... summarize the following results of physical interest on the velocity and temperature of the flow field and also on skin friction and the rate of heattransfer at the wall The effect of growing permeability ... scholars and presently guiding 15 Ph D scholars Now he is carrying on his Post Doc Research in MHD flow through Porous Media His major fields of study are MHD flow, Heatand Mass TransferFlow through ... velocity and temperature of the flow field are solved employing perturbation technique and the effects of the pertinent parameters on the velocity, temperature, skin friction and the rate of heat transfer...
... accuracy In a recent study, Cho et al [12] investigated the effect of a gap in the inclined rib on heattransferin a square duct and reported that a gap in the inclined rib accelerates the flowand ... augmented heattransferand friction in asymmetrically heated rectangular ducts with ribs on the heated wall in transverse, inclined, V-continuous and V- discrete pattern Int Journal of Heat Mass Transfer ... K.R Gandhi B.K and Saini J.S “Investigation of heattransferand friction using inclined discrete ribs on absorber plate of a solar air heater” 19th National & 8th ISHMT-ASME Heat & Mass Transfer...
... converted into an equivalent amount of heatand that heat could be converted into work EO 1.8 DEFINE the following: a Heat b Latent heat c Sensible heat d Units used to measure heat EO 1.9 DEFINE the ... TRANSFER, AND FLUID FLOW The information contained in this handbook is by no means all encompassing An attempt to present the entire subject of thermodynamics, heat transfer, and fluid flow would ... thermodynamic process is increasing the temperature of a fluid while maintaining a constant pressure Another example is increasing the pressure of a confined gas while maintaining a constant temperature...
... converted into an equivalent amount of heatand that heat could be converted into work EO 1.8 DEFINE the following: a Heat b Latent heat c Sensible heat d Units used to measure heat EO 1.9 DEFINE the ... of job and task analyses, and independent input from contractors and operations-oriented personnel were all considered and included to some degree in developing the text material and learning objectives ... TRANSFER, AND FLUID FLOW The information contained in this handbook is by no means all encompassing An attempt to present the entire subject of thermodynamics, heat transfer, and fluid flow would...
... regions of the boilingheattransfer curve: a Nucleate boiling b Partial film boiling c Film boiling d Departure from nucleate boiling (DNB) e Critical heat flux HT-02 Page viii Rev HeatTransfer OBJECTIVES ... removing decay heat from a reactor core Rev Page ix HT-02 HeatTransfer Intentionally Left Blank HT-02 Page x Rev HeatTransferHEATTRANSFER TERMINOLOGY HEATTRANSFER TERMINOLOGY To understand and ... typical combined heattransfer situation Figure Combined HeatTransfer Using the figure representing flowin a pipe, heattransfer by convection occurs between temperatures T1 and T2; heat transfer...
... the continuity equation is: minlets ˙ HT-03 moutlet ˙ moutlets ˙ Page 16 Rev Fluid Flow LAMINAR AND TURBULENT FLOW LAMINAR AND TURBULENT FLOW The characteristics of laminar and turbulent flow are ... mode of flow This is also an important consideration in certain applications that involve heattransfer to the fluid Laminar Flow Laminar flow is also referred to as streamline or viscous flow These ... TRANSFER, AND FLUID FLOW The information contained in this handbook is by no means all encompassing An attempt to present the entire subject of thermodynamics, heat transfer, and fluid flow would...
... andflowboiling Pool boiling is boiling on a heating surface submerged in a pool of initially quiescent liquid Flowboiling is boilingin a flowing stream of fluid, where the heating surface ... CHAPTER INTRODUCTION Boilingheattransfer is defined as a mode of heattransfer that occurs with a change in phase from liquid to vapor There are two basic types of boiling: pool boilingandflowboiling ... Pool Boiling Crisis in Ordinary Liquids 81 2.4.3.2 2.4.3 Boiling Crisis with Liquid Metals 97 Film Boilingin a Pool 102 2.4.4.1 Film Boilingin Ordinary Liquids 103 2.4.4.2 2.4.4 Film Boiling in...
... Drop andHeatTransferin a Single-Phase Flow 33 2.3 Pressure Drop andHeatTransferin a Single-Phase Flow Many correlations have been proposed in literature for the friction factor andheat transfer, ... applications in engineering and technology It contains six chapters related to the overall characteristics of the cooling systems: single-phase and gas–liquid flow, heattransferandboilingin channels ... laminar, transient and turbulent single-phase flows; (2) heattransfer of liquids and gas flows; and (3) two-phase flows in adiabatic and heated micro-channels As indicated by Kandlikar and Grande...
... Light-to -heat Absorption Mechanism in atomic Systems," International Journal of Heatand Mass Transfer, 41, pp 839-849 Häkkinen, H., and Landman, U., 1993, "Superheating, Melting, and Annealing of ... beam absorption Häkkinen and Landman [3] studied dynamics of superheating, melting, and annealing at the Cu surface induced by laser beam irradiation using the two-step heattransfer model developed ... CONCLUSION In this work, laser material interaction is studied using MD simulations Based on the results, the following conclusions are obtained First, during picosecond laser heating, the heat transfer...
... Light-to -heat Absorption Mechanism in atomic Systems," International Journal of Heatand Mass Transfer, 41, pp 839-849 Häkkinen, H., and Landman, U., 1993, "Superheating, Melting, and Annealing of ... beam absorption Häkkinen and Landman [3] studied dynamics of superheating, melting, and annealing at the Cu surface induced by laser beam irradiation using the two-step heattransfer model developed ... CONCLUSION In this work, laser material interaction is studied using MD simulations Based on the results, the following conclusions are obtained First, during picosecond laser heating, the heat transfer...
... Light-to -heat Absorption Mechanism in atomic Systems," International Journal of Heatand Mass Transfer, 41, pp 839-849 Häkkinen, H., and Landman, U., 1993, "Superheating, Melting, and Annealing of ... beam absorption Häkkinen and Landman [3] studied dynamics of superheating, melting, and annealing at the Cu surface induced by laser beam irradiation using the two-step heattransfer model developed ... CONCLUSION In this work, laser material interaction is studied using MD simulations Based on the results, the following conclusions are obtained First, during picosecond laser heating, the heat transfer...
... variable heat flux P S Gupta and A S Gupta examined the heatand mass transfer for the boundary layer flow over a stretching sheet subject to suction and blowing Elbashbeshy and Bazid studied heatand ... conducting, and thermocapillarity on the flow andheattransferin a laminar liquid film on a horizontal stretching sheet Mukhopadhyay 14 presented solutions for unsteady boundary layer flow andheattransfer ... magnetohydrodynamic flow andheattransfer of a viscous, incompressible, and electrically conducting fluid past a semi -in nite stretching sheet was investigated The governing continuum equations that...
... family protein Thioredoxin family protein Thioredoxin family protein Thioredoxin family protein Thioredoxin family protein Thioredoxin H-type (TRX-H-3) (GIF1) Thioredoxin family protein No classification ... from combined effects of sucrose and atrazine This strongly suggested important interactions of sucrose and xenobiotic signalling or of sucrose and ROS signalling, thus resulting in induction ... shown to be involved in supplying reducing power to reductases detoxifying lipid hydroperoxides or repairing oxidized proteins [37] Thioredoxins could also act as regulators of scavenging mechanisms...
... coating shall be replaced frequently Considering the cost of installing and maintaining, the performance benefits of riblet coating are marginal Riblets have also been used in Olympics Games and ... spot remains constant, and the rounding off radius changes in the circumference coordinate), and found asymmetrical flow pattern and potential increase of heattransfer Following on, Isaev and co-workers ... allow higher inlet temperature in the turbine systems, resulting in augmentation in efficiency, thrust and durability In a heat exchanger, the heat is first convected from the fluid to the heat exchanger...
... area/volume goodness factor means smaller heattransfer surface area/volume under a given pumping power and fluid, resulting in a smaller and lighter heat exchanger matrix 53 2.3 2.3.1 Numerical ... are employed as reference to validate the numerical results, and are obtained using the Petukhov and Gielinski correlations (Incropera and DeWitt, 2002), respectively: Cf = [1.58 ln (Re 2H ) − 2.185]−2 ... alternating direction implicit (ADI) solver as the smoother Additionally, the computational domain is decomposed into several blocks and is parallelized by Message Passing Interface (MPI) Interface...
... on sinusoidal grooves in turbulent channel flow In this section, all the wall shapes tested in this study will be introduced, including sinusoidal, triangular and trapezoidal grooves 3.1.1 Sinusoidal ... = 0.5 < αc which results in drag reduction) Sm/Sm0 in the wide portion increases with increasing S, and conversely Sm/Sm0 decreases in the narrow portion with increasing S This is possibly due ... spanwise and vertical velocities w and v tend towards 10−9 value during the development of the flow, and finally the flow re-laminarizes) The Reynolds number is not important for laminar flow in corrugated...
... enhancing the heattransfer Thus, reducing the recirculation region can lead to increased heattransfer rate Recirculation region will reduce skin friction and increase the form drag However, the increment ... 17.5%, and is unlikely 155 to increase further It is interesting to note that while the heattransfer characteristic is enhanced for Cases 2C.3 and 2C.4, there is a corresponding slight decrease in ... intense than that in symmetric dimple, which may be the cause of the enhancement of heattransfer 4.4.2 Mean characteristics of drag andheattransfer Since Case has higher heattransfer characteristics...
... 10% and 20% are compared and shown 5.2.3.1 Mean flow field In this section, the mean flow field (streamlines) based on time averaged velocity field are investigated The streamlines in the vicinity ... 20%) coincide with the impingement between vortex and protrusion wall There is more intense mixing between the center region of channel and near-wall region, and stronger vortices which impinge ... streamlines follows the surface profile of the protrusion on the wind-ward side and over the top and then join the freestream In addition, the higher protrusion tends to trigger more intense mixing...
... three-dimensional incompressible flowandheattransferin plain fin -and- tube heat exchangers, the tube arrangement, tube row numbers and fin pitch were investigated in details They found that the average heat ... useful information about the flowandheattransfer characteristics in the plain fin -and- tube heat exchangers Tsai and Sheu (1998) also offered us some physical insights into the fluid structure in ... of fin pitch, tube pitch, fin height, tube thickness and tube ellipticity on heattransferand pressure drop in the plain fin -and- tube heat exchanger, they found that heattransfer can be increased...