Water technology

Water Technology Introduction • For the existence of all living things water is essential Without water we cannot survive Almost all human activities domestic, agricultural and industrial demand use of water • Water from any source has to be treated before its use The treatment to which it is subjected depends upon its use • For eg If it has to be used for drinking purposes, the treatment would include removal of objectionable colour, taste and pathogenic micro organisms, whereas the water for industrial use require the removal of dissolved salts if it is used for steam generation • In this section we will discuss about the analysis of water and treatment of water for its industrial and domestic use Analysis of Water • Analysis of water includes the determination of different constituents in water to ascertain the suitability of water for a specific use, and the treatment to which it should be subjected prior to its use • • • • • • • • • The following characteristics of water are usually determined during its analysis Hardness Alkalinity BOD,COD Dissolved Carbondioxide Free Chlorine Silica Chlorides Total dissolved solids Hard water and Soft water • • Water which forms lather with soap easily is called soft water Water which does not form lather with soap easily is called soft water Hardness of water • • • Hardness is the soap consuming capacity of water Hardness of water is due to the presence of Ca and Mg salts in it Other ions responsible for hardness 3+ 3+ 2+ are Al , Fe and Mn If Ca and Mg salts are present in water then they react with the soluble sodium soap to form insoluble salts calcium and magnesium • • • 2C17H35COONa + CaSO4 - (C17H35COO)2Ca + Na2SO4 Sodium stearate Insoluble salt 2C17H35COONa + MgCl2 - (C17H35COO)2Mg + 2NaCl Types of Hardness • • Temporary hardness Permanent hardness Temporary Hardness • Temporary Harness is caused by the presence of dissolved bicarbonates of calcium, magnesium and other heavy metals and the carbonate of iron Thus the salts responsible for temporary hardness are Ca(HCO3)2 and Mg(HCO3)2 This hardness is also known as alkaline hardness • • • • • Ca(HCO3)2 -CaCO3 + H2O + CO2 Mg(HCO3)2 -MgCO3 + H2O + CO2 Temporary hardness can also be removed by addition of calculated amount of lime [Ca(OH) ] Ca(HCO3)2+ Ca(OH)2 2CaCO3 + 2H2O Mg(HCO3)2+ Ca(OH)2  MgCO3 + CaCO3 + 2H2O Permanent Hardness • This type of hardness is due to the presence of sulphates and chlorides of calcium and magnesium • This is called permanent hardness because it cannot be removed simply by boiling • This type of hardness is also known as non-carbonate hardness • Special methods like lime soda process, zeolite method, ion-exchange method are used for the removal of permanent hardness Hardness in terms of CaCO3 equivalent • Comparison of the hardness of different samples of water would be easier if the hardness caused by different salts can be expressed in terms of single salt • That is why hardness is expressed in terms of calcium carbonate equivalent The reason for choosing CaCO3as the standard for calculating hardness of water is : • • 1) its MW is exactly 100, which makes mathematical calculation easier 2) it is the most insoluble salt and thus can be easily precipitated in water treatment process 100 gm of CaCO3 ΞΞΞ 111gm of CaCl2 ΞΞ 136 gm of CaSO4 Ξ 95 gm of MgCl2 How to calculate harness in terms of CaCO3 equivalent If w gm of CaCl2 is present in a water sample then the amount of CaCl 2present in terms of CaCO3 equivalent will be: gm mole of CaCl2 is equivalent to gm mole of CaCO3 i.e 111gm of CaCl2 Ξ 100 gm of CaCO3 Therefore, w gm of CaCl2 is equivalent to 50/55.5 x w gm of CaCO Thus equivalents of CaCO = Strength of hardness x Chemical Equivalent of CaCO producing substance Chemical Equivalent of the substance Units of Hardness • 1) parts per million (ppm): It is the parts of CaCO equivalent hardness per 10 parts of water • 2) Milligrams per litre (mg/l):It is the no of milligrams of CaCO equivalent hardness per litre of water • 3) Degree Clark (°Cl):It is the parts of CaCO equivalent hardness per 70,000 parts of water • 4) Degree French(°Fr): It is the parts of CaCO equivalent hardness per 10 parts of water • Relation between various units of hardness 1ppm = 1mg/l = 0.1°Fr = 0.07 °Cl [...]... parts of CaCO 3 equivalent hardness per 10 parts of water • 2) Milligrams per litre (mg/l):It is the no of milligrams of CaCO 3 equivalent hardness per litre of water • 3) Degree Clark (°Cl):It is the parts of CaCO 3 equivalent hardness per 70,000 parts of water • 5 4) Degree French(°Fr): It is the parts of CaCO 3 equivalent hardness per 10 parts of water • Relation between various units of hardness ... is called soft water Water which does not form lather with soap easily is called soft water Hardness of water • • • Hardness is the soap consuming capacity of water Hardness of water is due to... industrial and domestic use Analysis of Water • Analysis of water includes the determination of different constituents in water to ascertain the suitability of water for a specific use, and the treatment... of water are usually determined during its analysis Hardness Alkalinity BOD,COD Dissolved Carbondioxide Free Chlorine Silica Chlorides Total dissolved solids Hard water and Soft water • • Water