Đang tải... (xem toàn văn)
Connector Housing (1): Creating the Main Pad and Other Features Extruding the Main Pad 1. profile.Connector Housing (1): Creating the Main Pad and Other Features Extruding the Main Pad 1. profile.Connector Housing (1): Creating the Main Pad and Other Features Extruding the Main Pad 1. profile.Connector Housing (1): Creating the Main Pad and Other Features Extruding the Main Pad 1. profile.
Connector Housing (1): Creating the Main Pad and Other Features Extruding the Main Pad profile Pad function , connector profile 70mm pad Designing the Catch yz plane offset 35mm plane offset plane Sketch constraints bottom line pad top coincidence constraint the vertical line pad back distance constraint dimension sketcher offset plane 8mm (16mm) catch pad Hint: Mirrored Extent option Detent Pocket main pad offset 20mm plane offset plane sketcher , Part by Sketch Plane profile , pocket constraint 3.Exit sketcher , pocket tool 9.5mm detent pocket Clip Design main pad sketcher clip Sketch line pad coincidence constraint top right point detent offset plane coincidence constraint constraint sketcher create 3mm long clip using the pad tool End of step Connector Housing (2): Dressing-up the Connector Drafting Surfaces Pad perimeter face (5 faces) 3deg draft connector neutral element lower upper face neutral element connector step face 3deg draft Filleting Edges upper and lower edge 1mm fillet corner edge fillet top 1mm, 2mm radius fillet Shelling the Part Pocket connector 1mm thickness shell clip remove Fillet part 1mm fillet element Hide Creating a Hole right edge 15mm, front edge 10mm 3.5mm diameter Hole Creating a Pattern hole rectangular pattern object first hole first hole 40mm Using the as the pattern direction front edge 10 Adaptivity Compass Compass 0% 218 0% Adaptivity Box AdaptivityBox Adapt 14.642 Adapt Adapt Adaptivity 219 220 OK Stress Von Mises 221 Adaptivity Box 222 < 2.> ANALYSIS ANALYSIS ANALYSIS 223 224 Analysis Workbench Part Design Generative Structural Analysis 225 Static Analysis ) Static Case 226 Clamp OK 227 Force Geometry Virtual Part Force Force 228 Supports OK Compute Compute 229 OK 230 Analysis 231 232