| Tài liệu tham khảo |
Loại |
Chi tiết |
| [1] Nguy ễ n V ă n Du. Bài Giảng Bảo Dưỡng Sửa Chữa Đường Ôtô. Đạ i H ọ c Giao Thông Vận tải, 2006 |
Sách, tạp chí |
| Tiêu đề: |
Gi"ả"ng B"ả"o D"ưỡ"ng S"ử"a Ch"ữ"a "Đườ"ng Ôtô |
|
| [2] Bekir Aktas et al., “Effect of aggreate surface properties on chip seal retention performace” Contruction and Buiding Materials. 44, March. 2013 |
Sách, tạp chí |
| Tiêu đề: |
et al"., “"Effect of aggreate surface properties on chip seal retention performace |
|
| [3] Bekir Aktas et al., “Developing a macrotexture prediction model for chip seal” Contruction and Buiding Materials. 41, Dec. 2012 |
Sách, tạp chí |
| Tiêu đề: |
et al"., “"Developing a macrotexture prediction model for chip seal |
|
| [4] Trần Đình Bửu, Dương Ngọc Hải, “Giáo Trình Xây Dựng Mặt Đường Ôtô tập II”, Nhà Xuất Bản Giáo Dục Việt Nam, 2009 |
Sách, tạp chí |
| Tiêu đề: |
Giáo Trình Xây D"ự"ng M"ặ"t "Đườ"ng Ôtô t"ậ"p II” |
| Nhà XB: |
Nhà Xuất Bản Giáo Dục Việt Nam |
|
| [5] Gransberg, D., and D.B. James. “NCHRP Synthesis of Highway Practice 342: Chip Seal Best Practices.” Transportation Research Board, Washington, D.C, 2005 |
Sách, tạp chí |
| Tiêu đề: |
NCHRP Synthesis of Highway Practice 342: Chip Seal Best Practices |
|
| [6] TCVN 8863: 2011 “Mặt Đường Láng Nhựa Nóng- Thi Công Và Nghiệm Thu”, 2011 |
Sách, tạp chí |
| Tiêu đề: |
TCVN 8863: 2011 “M"ặ"t "Đườ"ng Láng Nh"ự"a Nóng- Thi Công Và Nghi"ệ"m Thu” |
|
| [7]Janisch, D.W. and F.S. Gaillard, “Minnesota Seal Coat Handbook”, , Minnesota Department of Transportation, Office of Minnesota Road Research, Maplewood, 2006 |
Sách, tạp chí |
| Tiêu đề: |
Minnesota Seal Coat Handbook” |
|
| [8] “Seal Coat and Surface Treatment Manual”, Texas Departmentof Transportation, Austin, 2010 |
Sách, tạp chí |
| Tiêu đề: |
Seal Coat and Surface Treatment Manual” |
|
| [9] Dean M. Testa and Mustaque Hossain, “Kansas Department of Transportation 2014 Chip Seal Manual” . Kansas State University Transportation Center, 2014 |
Sách, tạp chí |
| Tiêu đề: |
Kansas Department of Transportation 2014 Chip Seal Manual” |
|
| [10] McLeod, “A General Method of Design for Seal Coatsand Surface Treatments” Proceedings of the Associationof Asphalt Paving Technologists, Vol.38, St. Paul, Minn,1969 |
Sách, tạp chí |
| Tiêu đề: |
A General Method of Design for Seal Coatsand Surface Treatments |
|
| [11]Ju San Lee, “Performance Based Evaluation of Asphalt Surface Treatments Using Third Scale Model Mobile Loading Simulator” North Carolina State University, 2007 |
Sách, tạp chí |
| Tiêu đề: |
Performance Based Evaluation of Asphalt Surface Treatments Using Third Scale Model Mobile Loading Simulator” |
|
| [12] TCVN 7054:2005: Bitum- “Phương pháp xác định độ dính bám với đá” 2005 |
Sách, tạp chí |
| Tiêu đề: |
Ph"ươ"ng pháp xác "đị"nh "độ" dính bám v"ớ"i "đ"á |
|
| [13] Dau č ík Pavol, Hadvinová Marcela, and Viš ň ovský Jozef, “Methods for determination of affinity between aggregate and bitumen,” International Petroleum Conference, 45, June, 2011 |
Sách, tạp chí |
| Tiêu đề: |
Methods for determination of affinity between aggregate and bitumen |
|
| [14] ASTM D3625 – 96, “Standard Practice for Effect of Water on Bituminous-Coated Aggregate Using Boiling Water”, 2005 |
Sách, tạp chí |
| Tiêu đề: |
Standard Practice for Effect of Water on Bituminous-Coated Aggregate Using Boiling Water |
|
| [15] EN 12697-11 “Bituminous mixtures - Test methods for hot mix asphalt - Part 11: Determination of the affinity between aggregate and bitumen”, 2005 |
Sách, tạp chí |
| Tiêu đề: |
Bituminous mixtures - Test methods for hot mix asphalt - Part 11: Determination of the affinity between aggregate and bitumen |
|
| [16] AASHTO T 283,“Standard Method of Test for Resistance of Compacted Hot Mix Asphalt (HMA) to Moisture-Induced Damage”, 2007 |
Sách, tạp chí |
| Tiêu đề: |
“Standard Method of Test for Resistance of Compacted Hot Mix Asphalt (HMA) to Moisture-Induced Damage” |
|
| [17] EN 12272-3, “Determination of binder aggreate adhesivity by the Vialit plate shock test method”, Jan, 2003 |
Sách, tạp chí |
| Tiêu đề: |
Determination of binder aggreate adhesivity by the Vialit plate shock test method” |
|
| [18] ASTM D700-11, “Standard test method for Sweep test of bitumious emulsion surface treatment sample”, 2011 |
Sách, tạp chí |
| Tiêu đề: |
“Standard test method for Sweep test of bitumious emulsion surface treatment sample” |
|
| [19] Nazimuddin M. Wasiuddin et al., “ Use of Sweep test for emulsion and hot asphalt chip seals: Laboratory and field evalution”, 91 Annual Meeting of the Transportation Research Board, Jan 2012 |
Sách, tạp chí |
| Tiêu đề: |
et al., “ Use of Sweep test for emulsion and hot asphalt chip seals: Laboratory and field evalution” |
|
| [20] Yun Yan Yi et al,. “Investigation on Adhesive Behavior between Binder and Aggregate by Vialit Test under Low Temperature”, Advanced MaterialsResearch, August, 2013 |
Sách, tạp chí |
| Tiêu đề: |
et al,. “Investigation on Adhesive Behavior between Binder and Aggregate by Vialit Test under Low Temperature” |
|