Tài liệu Shop Manual & ETM BCM KIA Cerato 2010
2010 > G 1.6 DOHC > Body Electrical System Circuit Diagram 2010 > G 1.6 DOHC > Body Electrical System Removal1. Disconnect the negative (-) battery terminal.2. Remove the head lamp assembly (Refer to the head lamp).3. Remove the head lamp leveling actuator (A) by turning the adjusting gear in the hole(B) using the LanguageLanguage adjusting wheel or screw driver.Installation1. Install the head lamp leveling actuator by turning the adjusting gear.2. Install the head lamp assembly.3. Adjust the head lamp in accordance with the head lamp aiming instructions. 2010 > G 1.6 DOHC > Body Electrical System Inspection1. Disconnect the negative (-) battery terminal.2. Remove the lower side crash pad switch (A) from the side crash pad cover by using the trim removal tool.(Refer to the Body group - "Crash pad")[LHD]Language [RHD]3. Remove the head lamp leveling switch connector from the lower crash pad switch.[LHD][RHD] 4. Connect the battery voltage between terminals 5 and 4.5. Measure the voltage between terminals 4 and 1 at each position.Position No. Rotation0 0°1 20°2 40°3 60°6. If the voltage is not as specified, replace the head lamp leveling switch. . the head lamp leveling actuator by turning the adjusting gear.2. Install the head lamp assembly.3. Adjust the head lamp in accordance with the head lamp. Disconnect the negative (-) battery terminal.2. Remove the head lamp assembly (Refer to the head lamp) .3. Remove the head lamp leveling actuator (A) by