Tài liệu Shop Manual & ETM BCM KIA Cerato 2010
2010 > G 1.6 DOHC > Body Electrical System Component LocationLanguage 1. Main relay2. Fuel pump relay3. A/C relay4. Condenser fan relay (High)5. Condenser fan relay (Low)6. Horn relay7. Wiper relay8. Head lamp relay (Low)9. Head lamp relay (High)10. Front fog lamp relay11. Blower relay12. Start relay13. Fuel filter heater relay14. PTC heater relay #315. PTC heater relay #216. PTC heater relay #117. Glow relay 1. Tail lamp relay, Power window relay, Rear heater relay, Trunk lid relay (Built-in-Junction box)2. Door unlock relay, Door lock relay, Front deicer relay, Hazard relay (Built-in-ICM relay Box) 2010 > G 1.6 DOHC > Body Electrical System Component LocationLanguage 2010 > G 1.6 DOHC > Body Electrical System Inspection1. Disconnect the negative (-) battery terminal.2. Pull out the relay from the engine compartment relay box.Power Relay (Type A)Check for continuity between the terminals.A : Fuel pump relayB : A/C relayC : Head lamp relay (Low)Language D : Horn relayE : Head lamp relay (High)F : Front fog lamp relayG : Fuel filter heater relay1. There should be continuity between the No.30 and No.87 terminals when power and ground are connected to the No.85 and No.86 terminals.2. There should be no continuity between the No.30 and No.87 terminals when power is disconnected.Power Relay (Type B)Check for continuity between the terminals.A : Wiper relay1. There should be continuity between the No.30 and No.87 terminals when power and ground are connected to the No.85 and No.86 terminals. 2. There should be continuity between the No.30 and No.87 terminals when power is disconnected.Power Relay (Type C)Check for continuity between the terminals.A : Condenser pan relay (High)B : Condenser pan relay (Low)C : Start relayD : Glow relayE : PTC heater relay #1F : PTC heater relay #2G : PTC heater relay #3H : Blower relay1. There should be continuity between the No.30 and No.87 terminals when power and ground are connected to the No.85 and No.86 terminals.2. There should be no continuity between the No.30 and No.87 terminals when power is disconnected. Power Relay (Type D)Check for continuity between the terminals.A : Main relay1. There should be continuity between the No.30 and No.87 terminals when power and ground are connected to the No.85 and No.86 terminals.2. There should be continuity between the No.30 and No.87 terminals when power is disconnected. . relay (Built-in-Junction box)2. Door unlock relay, Door lock relay, Front deicer relay, Hazard relay (Built-in-ICM relay Box) 2010 > G 1.6 DOHC > Body. I/P-H and the No.16 or 17 terminal in the I/P-F when power and ground are connected to the No.2 terminal in the I/P-H and the No.17 terminal in the I/P-B.2.