1. Trang chủ
  2. » Kỹ Thuật - Công Nghệ

Shop Manual & ETM BCM KIA Cerato 2010 - Multifunction Switch

9 261 0
Tài liệu đã được kiểm tra trùng lặp

Đang tải... (xem toàn văn)

THÔNG TIN TÀI LIỆU

Thông tin cơ bản

Định dạng
Số trang 9
Dung lượng 256,31 KB

Nội dung

Tài liệu Shop Manual & ETM BCM KIA Cerato 2010

2010 > G 1.6 DOHC > Body Electrical System SpecificationsItems SpecificationsRated voltage DC 12VOperating temperature range -30°C ~ +80°C (-22 ~ +176°F)Rated loadDimmer & passing switchHigh : 0.2A (Relay load)Low : 0.2A (Relay load)Passing : 0.2A (Relay load)Lighting switch Lighting : 0.2A (Relay load)Turn signal & lane change switch 6.6 ± 0.5A (Lamp load)Front & rear fog lamp switch 0.2A (Relay load)Wiper & mist switchLow, High : 4.5A (Motor load)Intermittent : 0.22 ± 0.5A (Relay load)Lock : Max. 28A (Motor load)Washer switch 4A (Motor load)Variable intermittent volume switch Max. 25mA 2010 > G 1.6 DOHC > Body Electrical System Component (1)LanguageLanguage 1. Steering column shaft2. Lighting switch3. Wiper and washer switch4. Screw5. Clock springComponent (2) 2010 > G 1.6 DOHC > Body Electrical System InspectionLighting Switch Inspection1. With the multi function switch in each position, make sure that continuity exists between the terminals below.If continuity is not as specified, replace the multi-function switch[LHD][RHD]Lighting Switch (Auto Light)Language Lighting SwitchDimmer And Passing SwitchTurn Signal SwitchFront Fog LampRear Fog Lamp Wiper And Washer Switch Inspection1. With the multi function switch in each position, make sure that continuity exists between the terminals below.If continuity is not as specified, replace the multi-function switch.[LHD][RHD]Wiper Switch Washer SwitchRemoval1. Disconnect the negative (-) battery terminal.2. Remove the steering column upper(A) and lower(B) shrouds after removing 3 screws. 3. Disconnect the light switch connector (A) and the wiper switch connector (B).4. Remove the wiper switch (A) by pushing the lock pin (B). when removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.[LHD][RHD]5. Remove the clock spring(A).6. Loosen the screws from the multifunction switch assembly (A). . Lighting switch3 . Wiper and washer switch4 . Screw5. Clock springComponent (2) 2010 > G 1.6 DOHC > Body Electrical System InspectionLighting Switch. screws from the multifunction switch assembly (A). 7. Remove the multifunction switch assembly (A).Installation1. Install the multifunction switch. 2. Install

Ngày đăng: 22/10/2012, 15:55

TỪ KHÓA LIÊN QUAN

w