Tài liệu Shop Manual & ETM BCM KIA Cerato 2010
2010 > G 1.6 DOHC > Body Electrical System Component Location1. Power door mirror 2. Power door mirror switchLanguage 2010 > G 1.6 DOHC > Body Electrical System ComponentsLanguage 2010 > G 1.6 DOHC > Body Electrical System Inspection1. Disconnect the negative (-) battery terminal.2. Remove the front door trim and power window switch module. (Refer to the Body group-front door)[LHD][RHD]3. Check for the continuity between terminals of power door mirror switch according to the table.Language 4. Check for continuity between the terminals in each switch position according to the table. 2010 > G 1.6 DOHC > Body Electrical System Inspection1. Disconnect the power door mirror connector (A) from the harness.Language 2. Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.1. Up / Down2. Left / Right4. Lamp +7. Heater +8. GNDMirror Heater . 2010 > G 1.6 DOHC > Body Electrical System Component Location1. Power door mirror 2. Power door mirror switchLanguage 2010 > G 1.6 DOHC >. ComponentsLanguage 2010 > G 1.6 DOHC > Body Electrical System Inspection1. Disconnect the negative (-) battery terminal.2. Remove the front door trim and power