Microsoft Word c034046e doc ICS 53 020 20 Ref No ISO 12210 4 1998/Cor 1 2000(E) © ISO 2000 – All rights reserved Printed in Switzerland INTERNATIONAL STANDARD ISO 12210 4 1998 TECHNICAL CORRIGENDUM 1[.]
INTERNATIONAL STANDARD ISO 12210-4:1998 TECHNICAL CORRIGENDUM Published 2000-04-15 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION · МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ · ORGANISATION INTERNATIONALE DE NORMALISATION Cranes — Anchoring devices for in-service and out-of-service conditions — Part 4: Jib cranes TECHNICAL CORRIGENDUM Appareils de levage charge suspendue — Dispositifs d'ancrage en dehors des conditions de service — Partie 4: Grues flèche RECTIFICATIF TECHNIQUE Technical Corrigendum to International Standard ISO 12210-4:1998 was prepared by Technical Committee ISO/TC 96, Cranes, Subcommittee SC 8, Jib cranes Page Replace the existing Table with the following new Table 1, in which some of the requirements have been altered ICS 53.020.20 © ISO 2000 – All rights reserved Printed in Switzerland Ref No ISO 12210-4:1998/Cor.1:2000(E) ISO 12210-4:1998/Cor.1:2000(E) Table — Anchoring devices Anchoring device required a Jib crane type and motion Out-of-service condition In-service condition In-service conditions of high wind b Portal/ semi-portal Travelling Hoisting Slewing Luffing Traversing X — Xc X X X — O O O X — O O O Derrick Travelling Hoisting Slewing Luffing X — Xc — X — O — X — O — Pillar Jib Slewing Hoisting Traversing Xc — — — — — — — — a X indicates a mandatory requirement; O indicates an optional requirement; — indicates not required Anchoring device shall be actuated either automatically or by the crane driver when the wind velocity exceeds the in-service design value in accordance with ISO 8686-1 b c 'Weather vaning' allowed if agreed between purchaser and manufacturer © ISO 2000 – All rights reserved