Microsoft Word C054555e doc ICS 21 040 10 Ref No ISO 965 3 1998/Cor 1 2009(E) © ISO 2009 – All rights reserved Published in Switzerland INTERNATIONAL STANDARD ISO 965 3 1998 TECHNICAL CORRIGENDUM 1 Pu[.]
INTERNATIONAL STANDARD ISO 965-3:1998 TECHNICAL CORRIGENDUM Published 2009-07-15 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION • МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ • ORGANISATION INTERNATIONALE DE NORMALISATION ISO general purpose metric screw threads — Tolerances — Part 3: Deviations for constructional screw threads TECHNICAL CORRIGENDUM Filetages métriques ISO pour usages généraux — Tolérances — Partie 3: Écarts pour filetages de construction RECTIFICATIF TECHNIQUE Technical Corrigendum to ISO 965-3:1998 was prepared by Technical Committee ISO/TC 1, Screw threads Page ii, Foreword Replace the third paragraph with the following: ISO 965-3 was prepared by Technical Committee ISO/TC 1, Screw threads, Subcommittee 2, Tolerances Page 1, Scope In the first paragraph, second line, replace “according to” with “in accordance with” ICS 21.040.10 © ISO 2009 – All rights reserved Published in Switzerland Ref No ISO 965-3:1998/Cor.1:2009(E) ISO 965-3:1998/Cor.1:2009(E) Page 1, Normative references Delete the references to ISO 68-1, ISO 261 and ISO 965-1 Replace the reference to ISO 5408 with the following: ISO 5408, Screw threads — Vocabulary Page 10, Table In the 11th column, which gives the lower deviation, ei, for the pitch diameter of the external thread, replace “−307”, corresponding to tolerance class 8g and pitch of mm, with “−303” Page 16 Add the following bibliography at the end of the document, after Table 1: Bibliography [1] ISO 68-1, ISO general purpose screw threads — Basic profile — Part 1: Metric screw threads [2] ISO 261, ISO general purpose metric screw threads — General plan [3] ISO 965-1, ISO general-purpose metric screw threads — Tolerances — Part 1: Principles and basic data © ISO 2009 – All rights reserved