Microsoft Word CXT 012 S35 2072 2 Pressurized Ink Tank Sensor Y Remained ON Problem docx ISSUE NO CXT 012 Page of 1 3 Attached Issued By Overseas Technical Sec , Riso Kagaku Corp ComColor Technical Bu.
ComColor Technical Bulletin Page of ISSUE NO : CXT-012 MODEL: ComColor 91xx, 71xx & 31xx Data Category Field Modification Proceeding Grade Action ASAP Action as given Action if required Refer in need DATE 24 Feb., 2014 Trouble Shooting General Information Parts Compatibility Compatible Conditionally Compatible Not Compatible Old Obsolete Safety Advice Handling of Modified Parts Free of Charge Conditionally Chargeable Chargeable Our Ref SUBJECT: S35-2072-2 Pressurized Ink Tank Sensor Y Remained ON Problem [Brief] Ink circulation error (S35-2072-2: Pressurized Ink Tank Sensor Y remained ON) occurs if the Negative Pressure Air Tube is pressed by inadequate tube arrangement [Causes of the Problem] Due to inadequate tubing of tubes between Pressurized Ink Tank and Ink Bus, The Negative Pressure Air Tube may get caught in the gap between the ink tube (which is wrongly placed on the Wire saddle) and Ink Tower Frame when close the Ink Tower Unit As the result, Negative Pressure Air tube is pressed and S35-2072-2 error occurs Wrongly placed tube on the saddle have press the Negative Pressure Air Tube when close the Ink Tower Unit The tube is wrongly placed on the Wire saddle Attached: Issued By Overseas Technical Sec., Riso Kagaku Corp ComColor Technical Bulletin Page of ISSUE NO : CXT-012 [Temporary Countermeasure] Re-route the tubes between Pressurized Ink Tank Y and Ink Bus so that the ink tube is not placed on the Wire saddle The tube is wrongly placed on the Wire saddle NG [Permanent Countermeasure] Tie the tubes between Pressurized Ink Tank Y and Ink Bus together into bundles Wire saddle Tie tubes (except the Ink Tube between Negative Pressure Ink NG Tank Y and Ink Bus Y) Ink Tube Tie the wire tie within ±10mm against the wire saddle (between Negative Pressure Ink Tank Y and Ink Bus Y) NG Do not place a bonding point (ball) of the wire tie at the Tube Y direction so that they are not contacted Attached: Issued By Overseas Technical Sec., Riso Kagaku Corp ComColor Technical Bulletin Page of ISSUE NO : CXT-012 [Application serial Number] For Temporary measure CC9150 CC9110 CC7150 CC7110 CC3150 CC3110 33810234 33820024 33831097 33840057 34020080 34030191 閃彩印王 9150 閃彩印王 7150 33850101 33860037 [Application serial Number] For Permanent measure CC9150 CC9110 CC7150 CC7110 CC3150 CC3110 33810278 33820026 33831666 33840081 34020107 34030266 閃彩印王 9150 閃彩印王 7150 33850129 33860041 Attached: Issued By Overseas Technical Sec., Riso Kagaku Corp ... NO : CXT-0 12 [Temporary Countermeasure] Re-route the tubes between Pressurized Ink Tank Y and Ink Bus so that the ink tube is not placed on the Wire saddle The tube is wrongly placed on the Wire... the tubes between Pressurized Ink Tank Y and Ink Bus together into bundles Wire saddle Tie tubes (except the Ink Tube between Negative Pressure Ink NG Tank Y and Ink Bus Y) Ink Tube Tie the wire... Negative Pressure Ink Tank Y and Ink Bus Y) NG Do not place a bonding point (ball) of the wire tie at the Tube Y direction so that they are not contacted Attached: Issued By Overseas Technical