KIA HFGHGFH
Điện thân xe ô tô Kia
... when the door is locked, the unlock signal is executed immediately for safety At this time, all door should be unlocked for operating above “unlock execution” “Door unlock” is activated only one ... receives “Lock/Unlock” signal from the front LH or RLH door switch, door “Lock” or “Unlock” relay is executed 0.5second later ◆ In case of front LH or RH door switch is on less than 60ms, door act...
Ngày tải lên: 22/10/2012, 09:12
MÃ LỖI C1292 TRÊN XE Ô TÔ Kia Morning - P3
... replace steering column assembly and then go to "Verification of Vehicle Repair" procedure http:/ /kia- hotline.com/Main/Viewer/content.asp?IsPrint=true&vehicletype=Passenger&mfrcode=KM&area=KME&langcode=
Ngày tải lên: 22/10/2012, 11:15
MÃ LỖI C1292 TRÊN XE Ô TÔ Kia Morning - P4
... based on 2.5V and main sensor signal is the same as sub sensor signal [Main sensor - Sub sensor] < 0.75 mA http:/ /kia- hotline.com/Main/Viewer/content.asp?IsPrint=true&vehicletype=Passenger&mfrcode=KM&area=KME&langcode= ... to maximum 4V based on 2.5V and main sensor signal is the same as sub sensor signal [Main sensor - Sub sensor] < 0.75 mA Fig.2) When turning steering wheel to lef...
Ngày tải lên: 22/10/2012, 11:15
Shop Manual & ETM BCM KIA Cerato 2010 - Audio
... position [Audio System] Switch Connector terminal VOLUME DOWN 6-7 VOLUME UP 6-7 MUTE 6-7 MODE 6-7 SEEK DOWN 6-7 SEEK UP 6-7 [Audio system + Audio Cruise] Switch Connector terminal VOLUME DOWN 6-7 VOLUME ... terminal VOLUME DOWN 6-7 VOLUME UP MUTE 6-7 SEEK DOWN 6-7 SEEK UP Circuit Diagram 6-7 MODE 2010 > G 1.6 DOHC > Body Electrical System 6-7 6-7 Language 2010...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Auto Lighting Control System
... 1 Auto light sensor Head lamps Lighting switch (Auto) 2010 > G 1.6 DOHC > Body Electrical System Circuit Diagram Tail lamps Body control module (BCM) Language 2010 > G 1.6 DOHC ... negative (-) battery terminal Remove the photo & auto light sensor(A) from crash pad upper side by using screw (-) driver Remove the auto light connector Installation Reconnect the auto li...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - BCM (Body Control Module)
... Below 6V Over CAN H OPEN/ON - - CAN L OPEN/ON - - Crash Input Communication 2.5V Below Head Lamp Switch Frequency OPEN/ON OPEN/ON - - CODE SAVE OPEN/ON - - K LINE OPEN/ON - - ... Button 24 Head Lamp High switch 25 - 26 GND Terminal Voltage ATM Solenoid - FntoFnto PnNmPnNm Saett B+ VlaeLvlotg ee 8V ~ 16V - - 0V ~ 5V - - IntT 0V ~ 5V -...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Button Engine Start System
... based on communication with EMS ECU - Management of the Immobilizer function - Management of BES warning function Button Engine Start System The Button Start System allows the driver to operate ... Installation Install the start/ stop button Install the start/ stop button cover Language 2010 > G 1.6 DOHC > Body Electrical System Component Language 2010 > G 1....
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Electro chromic Inside Rear View Mirror
... sure the mounting bracket and mirror not to be damaged Installation Install the inside rear view mirror Connect the inside rear view mirror connector Install the mirror wire cover ... looking and rearward looking sensors, the ECM should not be darkened Removal Remove the mirror wire cover(A) and connector (B) Remove the ECM mirror screw (A) 3 Remove the inside rear...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Fuses And Relays
... No.3 terminal in the I/P-G and the No.2 or terminal in the I/P-F when power and ground are connected to the No.3 terminal in the I/P-G and the No.16 terminal in the I/P-B 2010 > G 1.6 DOHC > Body ... terminal in the I/P-H and the No.15(LH) or 4(RH) terminal in the I/P-G when power and ground are connected to the No.2 terminal in the I/P-H and the No.6 terminal in the I/P-D Trunk...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - General Information
... of the sunroof, the following - In case the sunroof is closed completely or tilted: Push the sunroof control lever upward until the sunroof tilts completely upward - In case the sunroof is open: ... probe with a tapered tip Refer to the user's guide in the wiring repair kit (Pub No : TRK 015.) Five-step Troubleshooting Verify the complaint Turn on all the components in the problem cir...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Head lamp leveling Device
... Installation Install the head lamp leveling actuator by turning the adjusting gear Install the head lamp assembly Adjust the head lamp in accordance with the head lamp aiming instructions 2010 > G 1.6 DOHC ... negative (-) battery terminal Remove the lower side crash pad switch (A) from the side crash pad cover by using the trim removal tool (Refer to the Body group -...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Horn
... disconnect the horn connectors, then remove the low pitch horn (A) Installation Install the horns after connecting the horn connectors Install the front bumper (Refer to the Body group - Front bumper) ... the horn by connecting battery voltage to the terminal and ground the terminal The horn should make a sound If the horn fails to make a sound, replace it Horn Relay Inspect...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Ignition Switch Assembly
... ACC Installation Install the key lock cylinder Install the key warning switch and key illumination lamp Install the ignition switch Install the steering column shrouds ... Removal Disconnect the negative (-) battery terminal Remove the steering column upper and lower shrouds (A) Remove the key warning switch and key illumination lamp (C) after disconnecting
Ngày tải lên: 22/10/2012, 15:55