- THÔNG TIN MÃ LỖI - KIỂM TRA BẰNG MÁY CHẨN ĐOÁN - KIỂM TRA BẰNG SƠ ĐỒ MẠCH ĐIỆN - KIỂM TRA CẢM BIẾN
Page 11/4/2012 9:52:44 PMhttp://kia-hotline.com/Main/Viewer/content.asp?IsPrint=true&vehicletype=Passenger&mfrcode=KM&area=KME&langcode= . 2009 > G 1.1 SOHC > Steering > Electronic Power Steering > Language Terminal and Connector Inspection1. Many malfunctions in the electrical system are caused by poor harness and terminals.Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.2. Thoroughly check all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.3. Has a problem been found?▶Repair as necessary and then go to "Verification of Vehicle Repair" procedure.▶Go to "Signal Circuit Inspection" procedure.Signal Circuit Inspection1. Ignition "OFF"2. Disconnect torque sensor connector and EPS CM connector.3. Measure resistance between terminal "2"of torque sensor harness connector and terminal "5"of EPS CM harness connector. (Rm, Resistance value of main sensorharness).4. Measure resistance between terminal "4"of torque sensor harness connector and terminal "4"of EPS CM harness connector. (Rs, Resistance value of sub sensorharness).a. Specification : [ R m - R s ] < Approx. ± 0.8 Ω5. Is the resistance measured within specifications?▶Go to "Component Inspection" procedure.▶Thoroughly check connectors (which measuring value is high or low) for looseness, poor connection, bending, corrosion, contamination, deterioration,or damage.▶Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. . Page 11/4/2012 9:52:44 PMhttp:/ /kia- hotline.com/Main/Viewer/content.asp?IsPrint=true&vehicletype=Passenger&mfrcode=KM&area=KME&langcode=.... connector. (Rs, Resistance value of sub sensorharness).a. Specification : [ R m - R s ] < Approx. ± 0.8 Ω5. Is the resistance measured within specifications?▶Go