method statement of tiling work

... Schedule of tiling work on Ground Floor Toilets as below: Work Wall tiling Floor tiling Start 01/3/2016 07/3/2016 Duration days days Finish 06/3/2016 11/3/2016 Construction Schedule of tiling work ... INTRODUCTION 1.1 PURPOSE This method statement describes the methodology for tiling of wall and floor at SMC project Tiling work will be carried out after all constructions of relevant structures such ... SCOPE OF WORKS: All tiling work of Factory No.1 designated for the Toilets (8 rooms) on Ground floor and st floor The tiling in Office area will be carried out by other Sub-Contractors This work...

Ngày tải lên: 20/10/2016, 15:17

... Earth work c Formwork d Reinforcement Steel Rebar work e Concrete work Finishing works included: a Brick work b Plaster work c Painting work d Tiling work (Wall & Floor) BUILDING DESCRIPTION: Location: ... Supervisor / Worker Pile cap treatment Injury of people/worker + Workers must alert when they start breaking work + Workers wear protective equipment during breaking works Forman / Supervisor / Worker ... Formwork calculation: Formwork of footings are made of plywood 18mm thk and steel boxes 11.5 Installation of Form work • • • • •... pump water out of pit + Check finishing level of ...

Ngày tải lên: 20/10/2016, 14:48

... Earth work c Formwork d Reinforcement Steel Rebar work e Concrete work Finishing works included: a Brick work b Plaster work c Painting work d Tiling work (Wall & Floor) BUILDING DESCRIPTION: Location: ... the works of soil stabilization and lean concrete on the ground The constructions of those work items were carried out by previous stage; therefore they will no longer discuss in this method statement ... describes the procedures and method for carrying out the construction works for Slab on Grade of building factory No.1 This method statement will be applied after completion of the RC structures such...

Ngày tải lên: 20/10/2016, 15:05

... All workers who work at high level must be test for health  The used cranes must have some certificates to work  209 Standard will be applied for inspection works  The inspection works of repairing ... process of construction are forbidden Absolute Prohibition workers not drink beer while working Buy insurance for employees To appoint officers in charge of labor safety supervision of occupational ... Making the roof panel with full length of one side roof - By this way, VINACONEX EC commits the best solution for water roofing - Cleaning up the roof and finish work for steel structure part - Wall...

Ngày tải lên: 28/05/2018, 01:15

... CONTENTS Introduction Definition and Abbreviation Scope of Work Resources (Materials, Equipments & Human Resources) Sequence of Work Working Method Quilty Control Plan Safety Control Plan Emergency ... BUILD OF MAIN TENDER (PHASE 1A) FOR PROPOSED CONDOMINIUM DEVELOPMENT AT DISTRICT 7, HO CHI MINH, VIETNAM FOR M/S RIVIERA POINT LIMITED LIABILITY COMPANY Scope of work The main scope of work is ... relavant local authorities of Ho Chi Minh City, Socialist Republic of Vietnam We will develop the construction method with the focus to avoid any harm to the health and safety of owner’s personnel,...

Ngày tải lên: 25/10/2018, 08:26

... Electrical works associated with installation of Cable Ladders, Cable Tray & cable Trunking Để miêu tả việc liên quan đến việc lắp đặt thang đỡ cáp, khay cáp & máng cáp 2.0 SCOPE OF WORKS: PHẠM ... OF WORKS: PHẠM VI CÔNG VIỆC This method statement covers works relating to areas having cables supported on cable ladders, cable trays & cable trunkings only Works are carried out basing on construction ... installation works Page of 15 - CONTRACTOR: GDC HANOI - PROJECT NAME: PHASE 3A LOWRISE-MINI CLUBHOUSE • After confirming the layout of the cable ladder, tray & trunking routing, also the location of DBs...

Ngày tải lên: 21/03/2021, 15:09

... Survey work for coordinates and checking elevation of all pier will be done carefully before we can start erection work - The Method Statement, quality control plan, safety plan for erection of Super-T ... Letter of requesting and accepting erection works - Minutes of Inspection for partial works such as casting concrete Super-T girder, curing works - Other relevant documentation 4.2 Acceptance of ... 100% of touching surface, cleaning after finishing roughening work - Installing of bottom bearing part to its exactly position - Checking elevation with attention of the Engineer - Assembling of...

Ngày tải lên: 04/09/2021, 02:25

... HOTEL, SHOPPING MALLS AND OFFICES FOR RENT" Purpose of this method is to create soilcement piles with a diameter of 1000mm to surround the outside of defect positions of the diaphragm wall to ... Figure 1: Plan of Jet Grouting work 1.2 Mục tiêu công việc / Works Biện pháp bao gồm nội dung sau / This method includes following contents:  Trình tự thực Jet Grouting / Work sequence of Jet Grouting ... đào The Method Jet Grouting is selected to be the solution to reinforcement and waterproof treatment for defects of the diaphragm wall panel PN1-15 at the project of "COMPLEX BUILDING OF HOTEL,...

Ngày tải lên: 12/07/2022, 10:22

... 1980-2019DESCRIPTION OF WORKSScope of WorksThis is Method Statement for production of prestressed concrete I-girders (PC-I Girders) for superstructure Summary table of PC-I Girder: No Type of I girder ... equipment working at site prior to full operation Stability of working area and foundation of equipment shall be checked particularly at locations of outrigger and track pad of cranes. d) Prevention of ... both ends of girders in order to install jack for stressing. h) Installation of girder ‘s end Formwork  Formwork shall be in accordance with the requirements of technical specification of project...

Ngày tải lên: 16/09/2024, 10:22

... 1980-2019DESCRIPTION OF WORKSScope of WorksThis is Method Statement for production of Prestressed Concrete Deck (PSC Deck) for superstructure Summary table of PSC Deck : No Type of Beam Number Bridge ... joints in the formwork.Removal of Formwork and False-work General - Formwork shall be constructed such that the side forms of members can be removed without disturbing the soffit forms and, if ... be held for the purpose of general explanation on the whole contents of works as well as the method for the implementation of efficient work. b) Basic Instruction  All workers shall always wear...

Ngày tải lên: 16/09/2024, 10:24

... be held for the purpose of generalexplanation on the whole contents of works as well as the method for the implementation of efficientwork.b) Basic Instruction  All workers shall always wear ... equipment working at site prior to full operation Stability of working area andfoundation of equipment shall be checked particularly at locations of outrigger and track pad of cranes d) Prevention of ... Trang 17.2Removal of Wood deck slabs, Longitudinal Steel Beam 87.3Removal of Horizontal Beam, Truss Bailey 9 7.4Removal of Structure of Bridge Pier 9 7.5Removal of Structure of Abutment 9 7 TRAFFIC...

Ngày tải lên: 16/09/2024, 10:35

... CHE, SÀN TIẾP LIỆU Trang 3I SCOPE OF WORKS/ PHẠM VI CÔNG VIỆC.Scope of work: Steel structure for warehouse B,C. GB Steel present this method for the purpose of installation steel structure. quá ... THUẬN ĐẠO THUAN DAO LOGISTICS CENTER PROJECT BIỆN PHÁP THI CÔNG LẮP DỰNG KẾT CẤU THÉP METHOD STATEMENT OF STEEL STRUCTURAL INSTALLATION Trang 2MỤC LỤC1 Tiêu chuẩn, dữ liệu tính toán 2 Cấu tạo ... the implementation of this particular work processes. 1 Tính toán kiểm tra khả năng chịu lực hệ gông cẩu tháp: 1.1 Kiểm tra khả năng chịu lực H250: Page : 3/23 Mobilization of Manpower and Equipment...

Ngày tải lên: 01/11/2024, 20:37

... Construction Service Corporation c Formwork d Reinforcement Steel Rebar work e Concrete work Finishing works included: a Brick work b Plaster work c Painting work d Tiling work (Wall & Floor) BUILDING ... will no longer be discussed in this method statement Most of brickwork are for walls of Utilities Building and will be applied from the ground to 1st floor of building All walls will close the ... Construction Schedule of Brick work and Plaster work is attached in Appendix-1 SPECIFIC STANDARD Brick work and plastering works shall be carried out in accordance with the requirements of: - SMC MANUFACTURING...

Ngày tải lên: 20/10/2016, 14:37

... size STEP 2: Casing work: - - - HOLE OPENING – CASTING INSTALLATION Casings are pre-fabricated in the workshop Because of the casings, the actual size of the bored hole is often larger than its ... verticality fo the installed steel case Method Statement for Bore Pile works Project : PHU MY BRIDGE PHU CUONG Co., Ltd using the inclination of the top end of the casing The simplest way is using ... jointed together firmly by steel wire of ¢1mm÷¢2mm and welding Method Statement for Bore Pile works Project : PHU MY BRIDGE PHU CUONG Co., Ltd - - - - The insertion of rebar cages must be made rapidly...

Ngày tải lên: 08/09/2014, 09:44

... installing work METHOD STATEMENT FOR PRESSURE TEST Doc No.: MD1-0-T-054-05-00195 Rev A Page of 17 4.4 Piping Engineer The Piping Engineer shall perform installation of piping and field work for ... Organization For Pressure Test Attachment Page of 17 METHOD STATEMENT FOR PRESSURE TEST Doc No.: MD1-0-T-054-05-00195 Rev A Page of 17 Purpose The purpose of this procedure is to provide guidelines ... pneumatic) of above ground and underground piping to comply with project specification requirements Scope  This method statement describes the instructions for general requirements of pressure test of...

Ngày tải lên: 15/01/2016, 20:46

... Sulphuric Acid plant METHOD STATEMENT METHOD STATEMENT FOR STORAGE TANKS WITH ROOF Rev-0 Page 10 1500 MTPD Phosphoric Acid plant 4500 MTPD Sulphuric Acid plant METHOD STATEMENT METHOD STATEMENT FOR ... Tones METHOD STATEMENT FOR STORAGE TANKS WITH ROOF Rev-0 Page 1500 MTPD Phosphoric Acid plant 4500 MTPD Sulphuric Acid plant METHOD STATEMENT METHOD STATEMENT FOR STORAGE TANKS WITH ROOF Rev-0 ... Horizontal by RT through 10% of the total length of the welding and 100% RT of the T-Joints • Erection and fabrication of Roof METHOD STATEMENT FOR STORAGE TANKS WITH ROOF Rev-0 Page 1500 MTPD Phosphoric...

Ngày tải lên: 25/08/2016, 22:05

... representative of the materials used in the permanent works for AEP paint system (Interior and Exterior): • • • • bags of putty of 20kg /bag cans of sealer of litres /can cans of AEP paint of litres ... made of the works at the following times: Materials Delivery to Site Completion of surface preparation After application of prime or seal coats After application of undercoat After application of ... Corporation a b c d Brick work Plaster work Painting work Tiling work (Wall & Floor) 1.4 BUILDING DESCRIPTION: Location: Factory No.1 are located at the corner of Road No.D5 &N2-5 in Long Duc Industrial...

Ngày tải lên: 20/10/2016, 14:55

... Checklist - writing effective work method statements 20 Introduction Why we need work method statements? The purpose of a work method statement is: • to outline a safe method of work for a specific job ... application of the law to your situation © WorkCover NSW Contents Page Introduction Part A Suggested proforma Proforma for work method statements Part B Points to remember when writing work method statements ... assurance Remember that a work method statement is part of a site safety plan This plan should include: • Induction Training • Register of Hazardous Substances • Work Method Statement • OHS Procedures...

Ngày tải lên: 19/03/2014, 08:20

... Rate of a Reaction Rate Law Order of a Reaction Half-Life Examples Determination of the Order of a Reaction Working Method for the Determination of the Order of a Reaction by the Method of Initial ... approach of a ‘Working Method is one method of addressing this decline in marks and the difficulty that students face with physical chemistry Ironically, in many textbooks, working methods are ... Introduction States of Matter Acids and Bases The Gas Laws - Idea of Proportionality Kinetic Theory of Gases The General Gas Equation Importance of Units in Physical Chemistry A General Working Method to...

Ngày tải lên: 10/06/2014, 19:44

... comprehensive list of tools and techniques Instead of just listing them in any kind of order, the approach 23 Introduction to the concept and application of this book Concept of the book Problem ... of problem solving processes, but most of the approaches are very similar, regardless of the technical field of origination Typically problem solving approaches or models vary in the number of ... diagnosis activities’ point of departure Purpose (What does it do?) The problem definition consists of two parts: The preliminary definition of the problem – this is often part of the initial project...

Ngày tải lên: 08/10/2013, 18:11