filtering ip sessions with reflexive access lists

Tài liệu Reflexive Access Lists ppt

... SanJose1 to perform IP session filtering Configure a reflexive access list, as shown: SanJose1(config) #ip access- list extended FILTER-IN SanJose1(config-ext-nacl)#permit ip any any reflect GOODGUYS ... SanJose1(config) #ip access- list extended FILTER-OUT SanJose1(config-ext-nacl)#evaluate GOODGUYS SanJose1(config-ext-nacl)#exit SanJose1(config)#int e0 SanJose1(config-if) #ip access- group FILTER-IN ... SanJose1(config-if) #ip access- group FILTER-IN in SanJose1(config-if) #ip access- group FILTER-OUT out These commands create two named access lists, FILTER-IN and FILTER-OUT The FILTER-IN list monitors packet...

Tài liệu Reflexive Access Lists pptx

Danh mục: Quản trị mạng

Cisco Systems - Managing IP tracffic with access lists pptx

Danh mục: Quản trị mạng

... rights reserved ICND v2.0—6-9 How to Identify Access Lists • Standard IP lists (1-99) test conditions of all IP packets from source addresses • Extended IP lists (100-199) test conditions of source ... configure standard and extended IP access lists, and NAT/PAT, given a functioning router • Use show commands to identify anomalies in standard and extended IP access lists, given an operational router ... addresses, specific TCP /IP protocols, and destination ports • Standard IP lists (1300-1999) (expanded range) • Extended IP lists (2000-2699) (expanded range) • Other access list number ranges...

Tài liệu Chapter 10 Managing Traffic with Access Lists docx

Danh mục: Chứng chỉ quốc tế

... logging Control access list logging standard Standard Access List Router(config) #ip access- list standard ? Standard IP access- list number WORD Access- list name Router(config) #ip access- list ... Router(config)#int e1 Router(config-if) #ip access- group 110 out Named Access Lists 命名访问列表是创建标准和扩展访问列表的另外种方法.它允许你使用命名的方法来创建和应用标准或者扩展访问列表.使用 ip access- list 命令来创建,如下: Router(config) #ip access- list ? extended Extended ... 应用在接口上,之前说过了尽可能的把 IP 标准 ACL 放置在离目标地址近的地方,所以使用 ip access- group 命令把 ACL 10 放在 E1 接口,方向为出,即 out.如下: Router(config)#int e1 Router(config-if) #ip access- group 10 out Controlling VTY(Telnet) Access 使用 IP 标准 ACL...

Tài liệu IP Access Lists pdf

Danh mục: Quản trị mạng

... Router# show access- lists [ACL_#_or_name] Router# show ip access- list [ACL_#_or_name] Here is an example of the show access- lists command: Router# show access- lists Extended IP access list 100 ... two ACLs: an extended numbered IP ACL and an IPX SAP ACL If you want to view only ACLs for IP, use the following command: Router# show ip access- list Extended IP access list 100 permit tcp 172.16.0.0 ... 222934-9 / Chapter 13 IP Access Lists You can be more specific with your filtering in this example For example, if you want to restrict just telnet access, but allow other types of access from 192.168.5.1...

LAB5_Dynamic IP Access-Lists pot

Danh mục: Tài liệu khác

... người dùng access- list 100 deny ip any any log  thêm câu lệnh để kiếm soát xem có packets match với ACL Bước 4: Kiểm tra RouterA Trước telnet từ PCB Ra#show ip access- lists Extended IP access list ... sent with a source address of 150.1.5.5 U.U.U Router4 R4#show ip access- lists Extended IP access list INBOUND 10 permit ospf any any (1 match) 20 permit tcp any any eq telnet 30 Dynamic ACCESS ... Từ PCB thử telnet đến 152.1.1.1 Từ PCB telnet đến 195.1.1.4 Ra#show ip access- lists Extended IP access list 100 10 Dynamic tempaccess permit tcp host 150.1.1.2 host 152.1.1.1 eq telnet permit tcp...

Access Lists for Routed Traffic

Danh mục: Phần cứng

...

Access Lists Lab Scenario

Danh mục: Quản trị mạng

... Las_Vegas(config-int) #ip access- group 101 in All administrators are located in Tulsa on network 172.16.4.0/24 Configure a Standard IP access list to allow access to the terminal lines only to that network: access- list ... icmp any any access- list 102 deny icmp any any 10 access- list 102 permit ip any any Apply access list 102 as an outbound access control list to the Dallas router interface s0/0 with the following ... Solution Configure an extended IP access list on the Las Vegas router The list should contain the following entry to allow access to the Time and Attendance application: access- list 101 permit tcp...

Tài liệu Cisco Ios Access Lists pptx

Danh mục: Quản trị mạng

... types of access lists for different network protocols use different ranges of access list numbers (e.g., IP uses 1-99 for standard access lists and 100-199 for extended access lists; IPX uses ... the inbound access list 68 3.2.11 Session filtering using reflexive access lists 75 3.2.12 An expanded example of packet filtering 79 3.3 Alternatives to access lists ... 5.2 Packet -filtering access control lists 127 5.2.1 Checking for correctness 128 5.2.2 Debugging extended access lists 133 5.3 Route -filtering access control lists ...

Tài liệu Lab 11.2.1 Configuring Standard Access Lists pdf

Danh mục: Quản trị mạng

... 10 Apply access list to the proper router interface a First remove the old access list application by typing no ip access- group in at the interface configuration mode b Apply the new access list ... new access list a Now create an access list that will prevent the even numbered hosts from pinging but permit the odd numbered one b What will that access list look like? Finish this command with ... and repeat until they are successful Step Prevent access to the Ethernet interface from the hosts a Create an access list that will prevent access to FastEthernet from the 192.168.14.0 network...

Tài liệu Lab 11.2.1a Configuring Standard Access Lists docx

Danh mục: Quản trị mạng

... Systems, Inc b What will that access list look like? Finish this command with an appropriate comparison IP address (aaa.aaa.aaa.aaa) and wildcard mask (www.www.www.www): ip access- list permit aaa.aaa.aaa.aaa ... 10 Apply access list to the proper router interface a First remove the old access list application by typing no ip access- group in at the interface configuration mode b Apply the new access list ... and repeat until they are successful Step Prevent access to the Ethernet interface from the hosts a Create an access list that will prevent access to FastEthernet from the 192.168.14.0 network...

Tài liệu Lab 11.2.2 Configuring Extended Access Lists pdf

Danh mục: Quản trị mạng

... GAD(config) #access- list 101 deny tcp 192.168.14.0 0.0.0.255 any eq 80 GAD(config) #access- list 101 permit ip any any c Why is the second statement needed? Step Apply the access ... server function is active Step Prevent access to HTTP (port 80) the Ethernet interface from the hosts a Create an access list that will prevent Web browsing access to FastEthernet from the 192.168.14.0 ... Step Configure the hosts on the Ethernet segment a Host IP address Subnet mask Default gateway 192.168.14.2 255.255.255.0 192.168.14.1 b Host IP address Subnet mask Default gateway 192.168.14.3 255.255.255.0...

Tài liệu Lab 11.2.2a Configuring Extended Access Lists pptx

Danh mục: Quản trị mạng

... GAD(config) #access- list 101 deny tcp 192.168.14.0 0.0.0.255 any eq 80 GAD(config) #access- list 101 permit ip any any c Why is the second statement needed? Step Apply the access ... server function is active Step Prevent access to HTTP (port 80) from the Ethernet interface hosts a Create an access list that will prevent Web browsing access to FastEthernet from the 192.168.14.0 ... according to the chart b Allow HTTP access by issuing the ip http server command in global configuration mode Step Configure the hosts on the Ethernet segment a Host IP address Subnet mask Default...

Tài liệu Lab 11.2.2b Simple Extended Access Lists pptx

Danh mục: Quản trị mạng

... BHM#show access- lists Extended IP access list 100 permit ip host 192.168.1.34 172.16.2.0 0.0.0.255 deny ip 192.168.1.32 0.0.0.15 172.16.2.0 0.0.0.255 permit ip any any BHM# h Now test the access ... deny ip 192.168.1.32 0.0.0.15 172.16.2.0 0.0.0.255 access- list 100 permit ip any any i Another valuable command is the show access- lists command The following is a sample output BHM#show access- lists ... per line End with CNTL/Z BHM(config) #access- list 100 deny ip 192.168.1.32 0.0.0.15 172.16.2.0 0.0.0.255 e This statement defines an extended access list called “100” It will deny ip access for...

Tài liệu Lab 11.2.3c Simple DMZ Extended Access Lists pdf

Danh mục: Quản trị mạng

... syntax of the access lists with the show -access- lists command The output should be similar to the following: GAD#show access- lists GAD#show access- lists Extended IP access list 101 permit ip 10.10.10.0 ... should be similar to the following: GAD#show access- lists Extended IP access list 101 permit ip 10.10.10.0 0.0.0.255 any deny ip any any Extended IP access list 102 permit tcp any any established ... permit icmp any any unreachable deny ip any any (4 matches) Extended IP access list 111 permit ip 10.1.1.0 0.0.0.255 any (59 matches) deny ip any any Extended IP access list 112 permit tcp any host...

Tài liệu Lab 11.2.3d Multiple Access Lists Functions (Challenge Lab) pdf

Danh mục: Quản trị mạng

... Verify the Access Lists a Now that the access lists have been applied, they need to be verified First, verify what lists have been defined From a CLI session on one of the routers with access lists, ... of the routers with access lists, display the access lists with the Boaz#show ip access- lists command Record the information about one of the access lists ... _ b Next, confirm which access list is applied to each interface This is done from the terminal session of one of the routers with access lists, with the Boaz#show ip interface command Look...

cisco nac appliance - enforcing host security with clean access

Danh mục: An ninh - Bảo mật

... Real IP Gateway Mode 43 In-Band Mode 43 The Certification Process in In-Band Mode 44 Certification Steps for Host with Clean Access Agent 44 Steps for Client to Acquire an IP Address 44 Clean Access ... an employee role with full network access If a guest user joins the network, that guest user is placed in the guest role with only limited guest access privileges such as web access only Devices ... unauthorized access and potential breach of sensitive data By identifying users and PCs as they access the network and assigning access roles, users can access only data allowed in their access role...