0

dinners create url using the authorize filter

Tracking of multiple objects using the PHD filter

Tracking of multiple objects using the PHD filter

Cao đẳng - Đại học

... After the updating step in the GMPHD …lter, if two or more components have the same label, then this label is given to the one with the largest weight and new labels are assigned to the other ... association Let be the space of all possibilities for the data association Each of is called a hypothesis association The multiple-object tracking algorithm try to …nd the best hypothesis The large number ... than the single-object case A more tractable alternative to estimate the state of multiple objects is based on the probability hypothesis density …lter [63] The PHD is the …rst moment of the multiple-object...
  • 156
  • 262
  • 0
Tài liệu Kalman Filtering and Neural Networks - Chapter 6: LEARNING NONLINEAR DYNAMICAL SYSTEMS USING THE EXPECTATION– MAXIMIZATION ALGORITHM doc

Tài liệu Kalman Filtering and Neural Networks - Chapter 6: LEARNING NONLINEAR DYNAMICAL SYSTEMS USING THE EXPECTATION– MAXIMIZATION ALGORITHM doc

Hóa học - Dầu khí

... the observations=inputs and the parameter values The M-step involves system identification using the state estimates from the smoother Therefore, at the heart of the EM learning procedure is the ... extended Kalman smoother over the entire sequence using the current parameter estimate Moreover, these expectations are used to re-estimate the parameters, the smoother is then re-run, the parameters ... to the centers of the four Gaussian densities, while the solid line shows the analytical RBF fit using the covariance information The dotted lines below show the support of the RBF kernels 192...
  • 46
  • 490
  • 0
Tài liệu Using the Data Form Wizard to Create a Windows Form phần 1 pdf

Tài liệu Using the Data Form Wizard to Create a Windows Form phần 1 pdf

Kỹ thuật lập trình

... on the right, enter the Name of the form as MyDataForm.cs, and click Open (see Figure 6.18) You'll then see the welcome page for the Data Form Wizard Figure 6.18: Adding a data form using the ... you want to use in your form The area on the bottom left of the dialog box shows the tables and views you can access using your form The area on the bottom right shows the tables and views you've ... between the rows in the Customers table with the rows in the Orders table: When you move to a new row in the Customers table, the rows from the Orders table will be displayed in your form Set the...
  • 5
  • 502
  • 0
Tài liệu Using the Data Form Wizard to Create a Windows Form phần 2 doc

Tài liệu Using the Data Form Wizard to Create a Windows Form phần 2 doc

Kỹ thuật lập trình

... part of the form shows the details for the row from the Customers table where the CustomerID is ALFKI; the bottom part of the form contains a DataGrid control that displays the rows from the Orders ... select the control in the form designer and expand the DataBindings properties in the Properties window You'll see these properties in the Data area of the Properties window Next, you'll see how the ... is displayed in the control through the Text property in the DataBindings group The Text property in the DataBindings group sets the text displayed in a control To examine or set the data binding...
  • 7
  • 444
  • 0
Tài liệu Filter and Sort Records Using the DataView Object pptx

Tài liệu Filter and Sort Records Using the DataView Object pptx

Cơ sở dữ liệu

... to the current column name chosen in cboSortColumns If the two are the same, then the column name is assigned to the Sort property with the DESC keyword added on If not, then the name of the ... assigning the DefaultView of the mdtCust DataTable object to the mdvCust data view Next, the RowFilter property of mdvCust is set to compare the CompanyName column with the Like expression using the ... Using the command buttons, a routine is called that creates a DataView object, sets the RowFilter property, and then assigns the data view to the DataSource property of...
  • 7
  • 350
  • 0
Using the Renesas Graphics API to Create a User Interface

Using the Renesas Graphics API to Create a User Interface

Điện - Điện tử

... 1.Where are the bitmaps and fonts source files being stored within the MCU? 2.How are they being located there? 3.What types of issues are you seeing with these methods of writing to the frame ... reserved Lab Questions: - How are we changing the color of the slider button?  Determines the visual behavior of an associated object  The usage of the scheme is dependent on object:  In case ... Review/Questions Lab Questions: How are we changing the color of the slider button? Do you need to use Screen Object in the callback? How are we handling the display corruption issues from Lab 1? 16...
  • 38
  • 420
  • 0
Using the Renesas Graphics API to Create a User Interface_Part2_LabProcedure

Using the Renesas Graphics API to Create a User Interface_Part2_LabProcedure

Điện - Điện tử

... see the “FileFind” framework call to locate the “Med_BG” bitmap file and pass it to the “R_expand_jpeg” API function to display the image at the 0,0 screen location You can also see the call the ... per time tick, the “heartbeat” array contains the simulated data for the graph The “EventValues” array in “genEvents” contains the values used to signal the screen objects that they should update ... hold the slider (note the graph waveform), hold and move the slider Press the “Run” button (note slider behavior) Press the “Mode” and “Power” Buttons and note the behavior Step 5.8 In the “MedStatus”...
  • 10
  • 408
  • 0
Expert Service Oriented Architecture in C Sharp  Using the Web Services Enhancements

Expert Service Oriented Architecture in C Sharp Using the Web Services Enhancements

Kỹ thuật lập trình

... part of the same domain where the service components reside The second category of front-end consumers is the external Web service clients and other services, shown at the top of the diagram These ... essential to understanding the material in the second half of the book The remaining chapters of the book cover all of the WS-Specifications that are implemented by WSE 2.0 Finally, the book closes with ... guarantees They are what they are, and you simply use them But what happens if the type definition gets out of sync with the component it is supposed to describe? This happens all the time in the COM+...
  • 336
  • 841
  • 2
USING THE ANALYTIC HIERARCHY PROCESS APPROACH FOR ASSESSMENT OF THE STRENGTH OF UNIVERSITY-INDUSTRY-GRI COOPERATION IN VIETNAM

USING THE ANALYTIC HIERARCHY PROCESS APPROACH FOR ASSESSMENT OF THE STRENGTH OF UNIVERSITY-INDUSTRY-GRI COOPERATION IN VIETNAM

Kinh tế - Thương mại

... to the others For example, the flow from University to Industry and vice versa Therefore, these flows become the main factor in the individual model and are considered as the third level The ... structural The former is the familiar contextual dependence of elements on other elements in performing their function, whereas the later is the dependence of the priority of elements on the priority ... from the top with the goal having the greatest influence of importance The AHP model formulation process starts both from bottom (the alternatives) and from the top (the objective, goal) or the...
  • 73
  • 495
  • 2
PREDICTION OF ATRAZINE FATE IN RIPARIAN BUFFER STRIPS SOILS USING THE ROOT ZONE WATER QUALITY MODEL

PREDICTION OF ATRAZINE FATE IN RIPARIAN BUFFER STRIPS SOILS USING THE ROOT ZONE WATER QUALITY MODEL

Môi trường

... that the organic matter for the rest of the soil profile (the third layer to the eighth layer) were half of the previous layer We did not have field measurements for the microbial pools; therefore ... load into the RBS and the runoff depth from the cornfield increased the atrazine mass loss in runoff leaving the RBS increased (Table 4) Atrazine mass in runoff leaving the RBS were in the range ... concentrations in the seepage under the RBS were many orders of magnitude below 1-µg L-1 This may be due to the fact that there was no residual atrazine in the RBS soil profile at the beginning of the simulation...
  • 14
  • 449
  • 0
Removal of arsenic from synthetic groundwater by adsorption using the combination of laterite and ironmodified activated carbon

Removal of arsenic from synthetic groundwater by adsorption using the combination of laterite and ironmodified activated carbon

Môi trường

... is also possible to realize that the longer the portion of AC-Fe, the higher the adsorbent cost Therefore, optimizing the AC-Fe portion in the column is one of the key factors for a feasible arsenic ... ratio, the value of V/WACFe (V, the volume of drinkable water produced from the start using adsorbents until breakthrough / WACFe, the weight of AC-Fe in the column) was calculated and found that the ... solute (arsenic anions) in the bed is decreased resulting to shorter contact between the feed and the adsorbent In addition, the higher the flow rate, the smaller the film resistance, implying...
  • 12
  • 529
  • 0
Using the Shell

Using the Shell

Kỹ thuật lập trình

... Check whether the file has the set-group-id bit set -h file Check whether the file is a symbolic link (same as –L) -k file Check whether the file has the sticky bit set -L file Check whether the file ... displays only the path to the man page (the second element on the line) Using backticks, you can execute one section of a command line first and feed the output of that command to the rest of the command ... bash` The first command line in the preceding example finds the full path of the ps command and finds the package that contains that ps command The second command line finds the full path to the...
  • 20
  • 541
  • 0
Using the vi Editor

Using the vi Editor

Kỹ thuật lập trình

... text at the end of the line Insert text before the cursor Insert text at the beginning of the line Open a new line below the cursor Open a new line above the cursor Positioning Commands The following ... To create a file using the vi editor: Type vi filenameto create the file Type i to insert text Press the Escape key to change to command mode Type :wq to write the file and exit vi Note – The ... end-of-line characters The set command is used from last-line mode to control these options These options can also be placed in a file the user creates in their home directory called exrc The set options...
  • 9
  • 387
  • 0
AJAX-Style Mapping Using the Virtual Earth SDK

AJAX-Style Mapping Using the Virtual Earth SDK

Kỹ thuật lập trình

... icons appear on the map These icons are called pushpins, and they simply enumerate the search results while showing their location on the map You’ll see how to implement them in the Using Pushpins” ... you can also set the zoom level of a map by using the SetZoomLevel accessor method of the VEMap control Using the following method call for the map, you will see the map of the world as shown ... top The PanXY JavaScript function you saw in the preceding code segment reads the X and Y coordinates from the text boxes on the page and pans the map accordingly using the Pan method of the...
  • 20
  • 416
  • 0
Using the ASP.NET AJAX Control Toolkit (Part 1)

Using the ASP.NET AJAX Control Toolkit (Part 1)

Kỹ thuật lập trình

... when you click on the arrows of the Calendar control Of course, you can further enhance the appearance of the control by using CSS and assigning it to the CssClass property of the Calendar control ... SuppressPostBack="true" /> The first panel (Panel2) is essentially the header where the image to expand/collapse the panel is located The majority of the actual content is in the second panel In this case, the content ... set the text for the ConfirmText property Lastly, create a Label control, and in the event handler for the button, set the label’s text to a message indicating the successful receipt of the Click...
  • 34
  • 503
  • 1
Using the ASP.NET AJAX Control Toolkit (Part 2)

Using the ASP.NET AJAX Control Toolkit (Part 2)

Kỹ thuật lập trình

... defined, the pop-up panel by default launches in the center of the screen Also the Panel3 control is used to define the header of the main panel as a section where the user can drag and drop the panel ... Although the CAPTCHA controls can offer somewhat better security, they also have the downside of causing extra inconvenience for the users Not only they require additional input from the user, but they ... control the appearance of the lower-right drag handle for the resize Furthermore, using the OnClientResize property, you can write a client-side JavaScript function to modify the behavior of the...
  • 40
  • 525
  • 1
StarGazer EMS Campus Management Using the ADC StarGazer EMS

StarGazer EMS Campus Management Using the ADC StarGazer EMS

Phần cứng

... Campus Management Using the ADC StarGazer EMS StarGazer for Campus 7.0 Supported Products Network Product Minimum Version CMU-710 4.4 CMU-810 5.0G The following table lists the Campus Line Cards ... c o m • + - - - 8 • - 0 - 6 - StarGazer EMS Campus Management Using the ADC StarGazer EMS StarGazer Ordering Information To obtain the necessary products for installing one StarGazer server, you ... License and one SGMEDIA8.3, which comprises the installation CDs and user documentation You can order SGMEDIA8.3 and the StarGazer NetworkProduct License(s) at the same time or at different times, but...
  • 4
  • 374
  • 0
Using the Office Save My Settings Wizard

Using the Office Save My Settings Wizard

Tin học văn phòng

... to restore the settings, copy the file to your hard drive, open the wizard, and choose Restore Previously Saved Settings to This Machine Browse to the file you created earlier and run the wizard ... that you install the same Outlook add-ins that you had on the computer that you saved the settings from If not, you'll receive errors mentioning missing files when you start Outlook The File and ... Wizard can move your Outlook files, including the *.PST and other files The Office Save My Settings Wizard saves only settings—you have to save the files yourself [ Team LiB ] ...
  • 2
  • 407
  • 0
Appendix E_ Using the CD-ROM

Appendix E_ Using the CD-ROM

Kỹ thuật lập trình

... IV of the book and include the full-blown application examples from Part V of the book In a few instances, numbered listings in the book may be too small to have their own listing files on the CD-ROM ... File menu (the Open Page in Navigator choice in the Macintosh version) and use the file dialog box to locate the file named lst19-01.htm inside the Chap19 directory To examine and modify the HTML ... with the help of the Adobe Acrobat Reader, included with the CD-ROM The file NS4_Obj.pdf contains this illustration in pdf format Start Acrobat Reader on your computer, and open the file from either...
  • 3
  • 357
  • 0

Xem thêm