Lily-Fly page 1 of 3 http://www.kalei.com Lily-Fly by Kalei Anne Lundberg copyright 2000 This model appeared while I was playing with the lily base and because I wanted to send a butterfly to Sweden. The diagrams are offered for personal use any other use please contact me for permission at lilyfly@kalei.com. 1. Do the star precrease, color side up, and collapse the model into a colored preliminary fold. 2. Fold and unfold to the center line. Repeat on the other side. 3. Inside reverse fold along the precreased lines. Repeat on the other side. 4. Fold and unfold to the center line. Spread squash fold along the precrease. 5. Model after the spread squash is complete. Repeat on the other 3 sides. Note this is the lily base with the small points tucked to the inside. 6. Fold a single layer on the front and back left side to the right. Note: that the right side of the model will now enclose two full points 7. Valley fold the top point down. This fold will fall along the interior thickness. 10. Petal fold. 11. Tuck the small point to the inside. 12. Turn model over. 13. Valley fold the top layer to the left to complete the separation between the two bottom wings. 14. Fold model in half. 9. Inside reverse the two triangular folds between the top and bottom set of wings. Squash fold the bottom triangular fold. 8. Open up the four points. The model will lay flat. Note: The reverse side of the model should be oriented as in step 13. Lily-Fly page 2 of 3 http://www.kalei.com 15. Fold and unfold to align along the edge of the wings. 16. Outside reverse along the precrease line while sliding the point downward. This will cause a small crimp fold on either side of the model. Lily-Fly page 3 of 3 http://www.kalei.com 17. Note that the crimp curls up over the top wing and tucks into the body. 18. Fold and unfold. Light lines show the landmark. Repeat on back. 19. Reverse fold the tips to the inside. The bottom wings have an extra reverse fold for the tip. Repeat on back. 20. Reverse fold the small tip between the wings along line. Repeat on the back. Fold wings to the right repeat on the back. 21. Step reverse fold the tip three times. Note the second reverse will be even with the body side of the model. Open. 22. Shape the wings by sinking the tips through all layers. Some of these can be a bit tricky. 23. Ta Dah!!!! . body side of the model. Open. 22 . Shape the wings by sinking the tips through all layers. Some of these can be a bit tricky. 23 . Ta Dah!!!! . Repeat on back. 20 . Reverse fold the small tip between the wings along line. Repeat on the back. Fold wings to the right repeat on the back. 21 . Step reverse