Tài liệu Shop Manual & ETM BCM KIA Cerato 2010
2010 > G 1.6 DOHC > Body Electrical System Component Location1. Body control module2. Windshield deicer switch3. Windshield deicer4. Deicer connectorLanguage 2010 > G 1.6 DOHC > Body Electrical System DescriptionWindshield deicer system prevent windshield wiper from freezing in the winter season. It consists of deicer in the lower part of windshield, switch and relay. Body control module receives an input signal from the deicer switch, then controls relay.Since the generator "L" is switched ON, if the deicer switch is ON, then deicer output is ON for 20 minutes. 2010 > G 1.6 DOHC > Body Electrical System Inspection1. Remove the cowl top cover.(Refer to the wiper)2. Disconnect the windshield deicer connector (A) from the wiper motor linkage.3. Check for continuity between the terminals of deicer lines.LanguageLanguage 4. Turn the ignition switch ON and the windshield deicer switch ON, then measure the voltage between the terminals of harness side deicer connector.O K : approx. Battery voltage (12V) 2010 > G 1.6 DOHC > Body Electrical System Language Inspection1. Disconnect the negative (-) battery terminal.2. Remove the crash pad lower panel (A).(Refer to the Body group - "Crash pad")[LHD][RHD]3. Disconnect deicer switch connectors.4. Using an ohmmeter, inspect the continuity between the terminals. . 2010 > G 1.6 DOHC > Body Electrical System Component Location1. Body control module2. Windshield deicer switch3. Windshield deicer4 . Deicer. relay.Since the generator "L" is switched ON, if the deicer switch is ON, then deicer output is ON for 20 minutes. 2010 > G 1.6 DOHC > Body Electrical