18 Component Library ArtCAM 18 Component Library Introduction In ArtCAM JewelSmith a range of standard Shanks and Settings models are quickly accessible via the Libraries Settings Example • Select Create New Project The Assembly Components page appears, displaying several options including the Libraries section, which contains a Shank Library and a Component Library A shank will be made first, using the shank library • Select Open mesh library • Select a shank form the libary Note the ring inner diameter of 16.79 JewelSmith 18.1 18 Component Library ArtCAM Now open the settings library The files are stored in a folder within JewelSmith but you can set up your own, if desired • From the marquise section, select M4CC8x4mm • Select the box Import The setting is imported as a component with the base of the setting at Z0 Other settings can be made until the page is closed The setting needs to be moved into position • From the bottom of the settings page, select Back • Select the Project tab • Select the component M4CC8x4mm • Select Nudge Nudge the setting until it appears to be in the correct place • Close Project 18.2 JewelSmith