Microsoft Word C036292e doc ICS 77 140 65 Ref No ISO 3189 1 1985/Cor 1 2002(E) © ISO 2002 – All rights reserved Printed in Switzerland INTERNATIONAL STANDARD ISO 3189 1 1985 TECHNICAL CORRIGENDUM 1 Pu[.]
INTERNATIONAL STANDARD ISO 3189-1:1985 TECHNICAL CORRIGENDUM Published 2002-02-15 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION • МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ • ORGANISATION INTERNATIONALE DE NORMALISATION Sockets for wire ropes for general purposes — Part 1: General characteristics and conditions of acceptance TECHNICAL CORRIGENDUM Douilles pour câbles en acier d’usages courants — Partie 1: Caractéristiques générales et conditions de réception RECTIFICATIF TECHNIQUE Technical Corrigendum to International Standard ISO 3189-1:1985 was prepared by Technical Committee ISO/TC 105, Steel wire ropes ICS 77.140.65 © ISO 2002 – All rights reserved Printed in Switzerland Ref No ISO 3189-1:1985/Cor.1:2002(E) ISO 3189-1:1985/Cor.1:2002(E) Page Replace Table by the following: Table — Reference test force Nominal diameter of wire rope Type of rope construction × IWR 10 11 12 13 14 16 18 20 22 24 26 28 32 36 40 44 48 52 56 60 × 36 IWR Reference test force d mm × 19 IWR kN kN kN 16 21 25 31 37 43 50 65 82 16 20 25 30 36 43 49 65 82 — 20 25 30 36 43 49 65 82 101 122 145 170 198 258 327 403 488 581 682 790 907 Replace the note following Table by the following: NOTE — The reference test force is based on 40 % of the minimum breaking force of ropes of tensile grade 770 N/mm2 with wire rope cores (IWR), as given in ISO 2408, and rounded to the nearest kilonewton If sockets are to be used with ropes of higher tensile grade, then these reference test forces should be appropriately increased © ISO 2002 – All rights reserved