Hướng dẫn đấu nối và lập trình màn hình HMI Delta với PLC Cimon. Series HMI Connection Manual Cimon PLC (This PLC is applicable to BP, XP series of PLC) HMI Factory Setting Baud rate 38400 8 None 1 Controller Station Number 1 Control Area Status Area D00000D00010 Connection a RS 232 (DOP AAEAS, DOP B Series) Definition of PLC ReadWrite Address a Registers Format Type Word No (n) ReadWrite Range Data Length Note Input X Xn X000 – X511 Word Output Y Yn Y000 – Y511 Word General Purpose Relay M Mn M000 – M999 Word General Purpose Relay L Ln L000 – L999 Wor.
Series HMI Connection Manual Hướng dẫn kết nối PLC với HMI Delta DOP Cimon PLC (This PLC is applicable to BP, XP series of PLC) HMI Factory Setting: Baud rate: 38400 None Controller Station Number: Control Area / Status Area: D00000/D00010 Connection a RS-232 (DOP-A/AE/AS, DOP-B Series) DOP series Controller pin D-sub male (RS-232) RXD (2) (7) TXD TXD (3) (4) RXD GND (5) (2) GND (3) RTS (6) CTS Definition of PLC Read/Write Address a Registers Type Format Word No (n) Read/Write Range Data Length Note Input X Xn X000 – X511 Word Output Y Yn Y000 – Y511 Word General Purpose Relay M Mn M000 – M999 Word General Purpose Relay L Ln L000 – L999 Word Latch Relay K Kn K000 – K999 Word Flags F Fn F000 – F127 Word Timer (Set) TS TSn TS0000 – TS4095 Word Timer (Current) TC TCn TC0000 – TC4095 Word Counter (Set) CS CSn CS0000 – CS4095 Word Counter (Current) CC CCn CC0000 – CC4095 Word V1.00 Revision March, 2010 www.plc.today 15 Series HMI Connection Manual Type Format Word No (n) General Purpose Word Data Dn Read/Write Range Data Length Note D00000 – D31999 Word S0 – S99 Byte D Step Controller S Sn b Contacts Format Type Word No (n) Bit No (b) Read/Write Range Input X Xnb X0000 – X511F Output Y Ynb Y0000 – Y511F General Purpose Relay M Mnb M0000 – M999F General Purpose Relay L Lnb L0000 – L999F Latch Relay K Knb K0000 – K999F Flags F Fnb F0000 – F127F Timer Status T Tb T0000 – T4095 Counter Status C Cb C0000 – C4095 Note NOTE 1) The unit of PLC internal memory is byte and Device S is read in the unit of byte It is recommended NOT TO USE two consecutive devices S as the read address to prevent occurrence of interference For example, when choosing two numeric input device, please use S24 and S26, not use S24 and S25 16 V1.00 Revision March, 2010 ...Series HMI Connection Manual Type Format Word No (n) General Purpose Word Data Dn Read/Write Range Data... F127F Timer Status T Tb T0000 – T4095 Counter Status C Cb C0000 – C4095 Note NOTE 1) The unit of PLC internal memory is byte and Device S is read in the unit of byte It is recommended NOT TO USE