Routing Protocols and Concepts – Chapter 9 doc
Routing Protocols and Concepts – Chapter 9 doc
...
i
n
t
er
f
aces
command to view metrics
EIGRP Metrics
–Bandwidth – EIGRP uses
a static bandwidth to
calculate metric
Most serial interfaces use
–
Most
serial
interfaces
use
a default bandwidth ...
configure the
bandwidth later.
gg
Table
The show ip route
command is also used to
verify EIGRP
verify
EIGRP
–EIGRP routes are denoted
in a routing table by the letter...
Routing Protocols and Concepts: Chapter 5 doc
... only sends one route: the 192 .168.5.0
network.
RIP: received v1 update from 192 .168.4.1 on Serial0/0/1
192 .168.5.0 in 1 hops
19
Specifying Networks
The network command performs the following ... not set
C 192 .168.4.0/24 is directly connected, Serial0/0/1
C 192 .168.5.0/24 is directly connected, FastEthernet0/0
R 192 .168.1.0/24 [120/2] via 192 .168.4.2, 00:00:08, Serial0/0/1
R 192 ....
Routing Protocols and Concepts: Chapter 8 doc
... this parent route
9
Sample Routing Table Entries
The routing table hierarchy in Cisco IOS software was originally
implemented with the classful routing scheme.
Although the routing table incorporates ... destination IP address of a packet
and a route in the routing table, a minimum number of leftmost bits
must match between the IP address of the packet and the route in t...
Routing Protocols and Concepts: Chapter 3 docx
... Networks:
172.16.0.0
192 .168.10.0
Routing Information Sources:
Gateway Distance Last Update
(this router) 90 00:03: 29
192 .168.10.6 90 00:02: 09
Gateway Distance Last Update
172.16.3.2 90 00:02:12
Distance: internal 90 external ...
and details, please read
the chapter/ curriculum.
Book:
Routing Protocols
and Concepts
By Rick Graziani and
Allan Johnson
ISBN: 1...
Routing Protocols and Concepts – Chapter 4 docx
...
1
Distance Vector Routing
Protocols
Routing Protocols and Concepts – Chapter 4
© 2007 Cisco Systems, Inc. All rights reserved. Cisco Public
ITE PC v4.0
Chapter 1
1
Distance Vector Routing Protocols
... classless routing protocol
Enhanced Interior Gateway Routing Protocol
(EIGRP)
–A distance vector routing protocols that has some features of
link state r...
Routing Protocols and Concepts – Chapter 6 docx
...
CIDR
notation
( 199 3
,
RFC
15 19)
-Network Address Translation ( 199 4, RFC 1631)
Private Addressing ( 199 6 RFC 191 8)
-
Private
Addressing
( 199 6
,
RFC
191 8)
ITE PC v4.0
Chapter 1
5
© 2007 ... SE-ST1 LAN1 192 .168.4. 192 / 29
SE-ST1 LAN2 192 .168.4.200/ 29
SE-ST2 LAN1 192 .168.4.208/ 29
SE-ST2 LAN2 192 .168.4.216/ 29
Link
from
HQ
to
CENTRAL
1...
Tài liệu Routing Protocols and Concepts: Chapter 6 pot
... s0/0/0
VLSM
VLSM in Action
VLSM and IP Addresses
Chapter 6 VLSM and CIDR
Routing Protocols and Concepts
17
Classless Routing Protocol
Classless routing protocols include the subnet mask with ... bits.
15
CIDR and Route Summarization
The 192 .168.0.0/20, summarized or aggregated route includes all the
networks belonging to customers A, B, C, and D.
192 .16...
Tài liệu Routing Protocols and Concepts: Chapter 10 ppt
... routing issues within an area.
Multi-area OSPF and IS-IS are discussed further in CCNP.
Link-State Routing
Link-State Routing Protocols
Introduction to the SPF Algorithm
Link-State Routing ... link.
Implementing Link-State
Routing
Advantages of a Link-State Routing Protocol
Requirements of a Link-State Routing Protocol
Comparison of Link-State Routing Protoc...
Routing Protocols and Concepts: Chapter 11 ppt
... chapter/ curriculum.
Book:
Routing Protocols
and Concepts
By Rick Graziani and
Allan Johnson
ISBN: 1-58713-206-0
ISBN-13: 97 8-58713-
206-3
42
Verifying OSPF
Excellent command to begin troubleshooting. ... network Command
The network command (same function as when used with other IGP
routing protocols) :
Any interfaces on a router that match the network address...
Routing Protocols and Concepts: Chapter 2 pot
... 292 9
Configuring Serial Links in a Lab Environment
l Available clock rates, in bits per second, are 1200, 2400, 96 00,
192 00, 38400, 56000, 64000, 72000, 125000, ... Added to the Routing Table
l The debug ip routing displays routing table processes for any
route,
Ÿ directly connected network
Ÿ static route
Ÿ dynamic route.
l Disable debug ip routing by either:
Ÿ ... to display t...