... Terms Page REF•13 Index Page REF•17 0•4 Introduction Introduction to the FordMondeo Introduced in March 1993, the FordMondeo models are available in four-door Saloon, five-door Hatchback and ... 1993-model FordMondeo 2.0 Si Hatchback Additional work was carried out and photographed on a 1993-model 2.0 Si Saloon and a 1993-model 2.0 Ghia Estate (with automatic transmission) FordMondeo 1.8 ... transmission Gear oil to Ford specification ESD-M2C-186-A Automatic transmission Transmission fluid to Ford specification ESP-M2C-166-H Power steering Transmission fluid to Ford specification ESP-M2C-166-H...
... REMOVE OXYGEN SENSOR (BANK SENSOR 2) FROM FRONT TWC S01823 12 (a) (b) (c) 13 SEPARATE EXHAUST MANIFORD AND FRON TWC Remove the bolts and lower manifold heat insulator Remove the bolts and TWC heat ... bolts and intake manifold stay 21 A/T only: DISCONENCT A/T THROTTLE CONTROL CABEL FROM INTAKE MANIFORD Disconnect the control cable from the clamp on the rear side of the intake manifold 22 DISCONNECT...
... ENGINE REPAIR MANUAL (RM929E) REMOVAL AND INSTALLATION OF ENGINE INTAKE PARTS If any metal tip is mixed in the inlet pass, that may give a bad effect to the engine and turbo charger When removing...
... the specified tools Always be careful to work safely, avoid forceful or uninstructed operations Exercise maximum care to avoid damage to mating or sliding surfaces Cover openings of engine system ... “B” of fuel tube matches notch “B” of the clip q Make sure that fuel tube flange is securely fixed in flange fixing groove on clip Make sure that installation is complete by checking that fuel...
... develops, the valve piston opens and the overflow quantity is automatically adjusted to maintain a fixed fuel pressure in the rail and enable simplified vehicle running Because this is an abnormal...
... clearance between the gear and camshaft (d) Tighten the flange bolt with the camshaft timing gear fixed in place Torque: 54 N*m (551 kgf*cm, 40 ft.*lbf) 2AZ-FE ENGINE MECHANICAL – CAMSHAFT EM–43 (e)...