Đăng nhập
Hoặc tiếp tục với email
Nhớ mật khẩu
Đang tải... (xem toàn văn)
Tài liệu hạn chế xem trước, để xem đầy đủ mời bạn chọn Tải xuống
THÔNG TIN TÀI LIỆU
Cấu trúc
Introduction
The Involute Curve
Datum Curves From Equation
Creating the Gear
Gear Parameters
Task 1: Create a datum curve driven by an equation.
Pick Insert, Model Datum, Curve, From Equation, Done
Task 2: Create a cylinder.
Pick View, Orientation, Standard Orientation
Task 3: Create three circles representing the major diameters.
Task 5: Create another datum point and a datum curve.
Pick Insert, Model Datum, Curve, Done
Task 6: Create a datum evaluate feature.
Task 7: Copy the involute curve.
Task 8: Add a relation and regenerate the part.
Task 9: Mirror the copied involute curve.
Task 10: Copy the curve again.
Task 11: Create an extruded cut.
Task 12: Pattern the cut.
Task 13: Finish the part.
Nội dung
HƯỚNG DẪN VẼ BÁNH RĂNG TRÊN PHẦN MỀM PRO ENGINEERING
Ngày đăng: 29/01/2021, 23:55
TỪ KHÓA LIÊN QUAN
TÀI LIỆU CÙNG NGƯỜI DÙNG
TÀI LIỆU LIÊN QUAN