1. Trang chủ
  2. » Văn Hóa - Nghệ Thuật

Nghệ thuật xếp hình Nhật Bản:pumpkin_2

3 126 0
Tài liệu đã được kiểm tra trùng lặp

Đang tải... (xem toàn văn)

THÔNG TIN TÀI LIỆU

Thông tin cơ bản

Định dạng
Số trang 3
Dung lượng 46,28 KB

Nội dung

Jan-O-Lantern by Kalei Anne Lundberg copyright 2000 This model is named for my sister-in-law, who is a firm believer that there can never be too many Halloween decorations. It is best made of duo-colored paper, but I have tested the design by using restickable glue stick to tack the outer edges of the eye color paper to orange tissue paper. There is some minor slippage in the swivel fold in step 8 along the eye side of the fold. A six inch piece of kami will make a model about 2.5 inches tall without the stem. The diagrams are offered for personal use. For any other use please contact me for permission at pumpkin@kalei.com. Pumpkin page 1 of 3 http://www.kalei.com 1. Eye Color Up. Crease the center line. 2. Valley fold to the center. These folds should be make to butt very tightly together. 3. Fold and unfold to set the crease for the stem section. 4. Valley fold to center. These folds could even overlap a little. Unfold left side. 5. Valley fold. 6 Enlarged views shown without the stem section of the model. Pumpkin page 2 of 3 http://www.kalei.com 7. Swivel fold to form nose and narrow eyes. 8. Valley fold. Repeat steps 5-8 on the right side flap. 9. Inside reverse fold to the crease line made in step 3. 10. Valley fold. The top edge should be parallel to the upper edge. 11. Squash fold. 12. Petal fold the bottom portion of the squash fold while opening the top portion to lay flat. 13. Completed fold. Repeat on the other side. 14. Valley fold flap through the jaw folds. 15. Tuck the top portion of the lower mouth flap behind the eye flaps. Fold tip under. 16. Mountain fold the tip along the crease made in step 3. Turn model over 17. Open up the stem section and squash fold. 18. Valley fold the tip down. Valley fold the sides to the center. 19. Squash fold the corners. Pumpkin page 3 of 3 http://www.kalei.com 22. Yet another rabbit ear. Accordion pleat the sides to the center and fold flat at a slight angle. 23. Tuck inside the pocket. Twist the stem to position and make it 3 dimensional. BOO! 20. Rabbit ear the sides. The center fold of the rabbit ear will lay even with where the jaw flap meets the eye flap on the front side. This fold need not be flattened as it will be rolled back outward in the next step. 21. Valley fold outward. Pinch along the edge using your thumbnail while rolling the paper outward. The center fold of the rabbit ear should pleat upwards. Turn model over. . of 3 http://www.kalei.com 22 . Yet another rabbit ear. Accordion pleat the sides to the center and fold flat at a slight angle. 23 . Tuck inside the pocket the eye side of the fold. A six inch piece of kami will make a model about 2. 5 inches tall without the stem. The diagrams are offered for personal use.

Ngày đăng: 22/10/2013, 14:15

TỪ KHÓA LIÊN QUAN