Yuanbao (Ver 1.2) Ronald Koh - 2000 c 2. 4. 3. 1. Turn paper over. Hold all layers firmly in position and fold corner A down as shown, about 1/5th of the distance between line BD and corner C. 5. Crease firmly through all layers and unfold. 6. 1/5 1/5 1/5 1/5 1/5 A B C D 8. Unfold to position at start of Step 4, . 9. . then turn paper over 10. Bring each of the four corners to a verticle position, along the crease lines made in Steps 6 & 7. Now push the each side to the middle to bring the circled point in the centre towards you. 11. 12. 13. Fold one layer all the way down, drawing the corners in at the same time to form a neat triangle on each side, . . like this. 14. 1/5 1/5 1/5 1/5 1/5 7 15. Open out the over- lapping layer on each side as you fold up. Fold the triangular piece into the pocket immediately behind, then repeat from Step 12 at the back. Open out to form a hollowed square at the bottom. 16 17. Push the upright flaps outwards. Finally, adjust the shape of the yuanbao until it looks like this.