Semester 3 Skills Based Final – Part 1 Router Configuration Student Training

Semester 3 Skills Based Final – Part 1 Router Configuration Student Training Name: ___________________Date: ______________ Exam Part 1 Overview: You are the network administrator for a local elementary school. Your task is to setup and configure the router for your particular location. You must configure the router from the command line of the console interface using only IOS help. The district office routers, labeled DO1 and DO2, are already configured and their setup is given below. The district has decided to create 1024 subnets from class B network 171.17.0.0 to allow room for expansion. The district has also chosen to use IGRP for their routing protocol and has been assigned autonomous system number 139 by the ICANN. You will be assigned a Station Number for your school. This number is the same number as the usable subnet you are assigned to. For example, if you are station number 10, you will be assigned the 10 th usable subnet range from your district’s network. This is illustrated in the diagram by the letters SN and a number. For security purposes, all of the student workstations will be given the upper half of the available addresses in the host range of your school’s LAN. All of your major networking equipment (Routers, switches, servers, printers etc.) and faculty stations will be given the lower half of the available address within that same range. You will need to create and apply an access list that filters and denies the student’s stations TELNET access to the closest serial interface on the district router. Notes: _________________________________________________________________________________ _________________________________________________________________________________ _________________________________________________________________________________ _________________________________________________________________________________ Semester 3 Skills Based Final – Part 1 Router Configuration – Cont. (Individual performance - 60 pts – 4 pts each) District Router DO1 District Router DO2 Interface Serial 0 IP addr: 171.17.255.65 Interface Serial 0 IP addr: 171.17.254.193 Interface Serial 1 IP addr: 171.17.255.1 Interface Serial 1 IP addr: 171.17.254.129 Interface Ethernet 0 IP addr: 171.17.255.129 Interface Ethernet 0 IP addr: 171.17.255.130 School Router Configuration: (Instructor or proctor must initial steps as completed) 1. Subnet Mask: ___________________________________ Initials: _______ Pts: _______ 2. Host Range: ____________________________________ Initials: _______ Pts: _______ 3. School WAN Interface Address: ____________________ Initials: _______ Pts: _______ 4. LAN Interface Address: (From assigned range above) Initials: _______ Pts: _______ 5. Appropriate Routing Protocol Initials: _______ Pts: _______ 6. Workstation Address: (From assigned range above) Initials: _______ Pts: _______ Connectivity: 7. Ping opposite district router’s ethernet interface. Initials: _______ Pts: _______ 8. Telnet to district router from workstation Initials: _______ Pts: _______ 9. Access district router using web browser. Initials: _______ Pts: _______ Adding Security: Create and apply an access list that denies the student’s workstations telnet access to the closest serial interface of the district router you are attached to. For the first section you will need a Faculty IP address and for the second you will need a Student IP address before attempting the tests. 10. Workstation Address: ____________________________ Initials: ________ Pts: ________ 11. Can access district router via a web browser. Initials: ________ Pts: ________ 12. Can access district router’s serial interface via telnet. Initials: ________ Pts: ________ You must reconfigure your workstation to have a Student IP address before completing the following steps. 13. Workstation Address: ____________________________ Initials: ________ Pts: ________ 14. Can access district router via web browser. Initials: ________ Pts: ________ 15. Cannot access district router’s serial interface via telnet. Initials: ________ Pts: ________ Points Scored: __________ Semester 3 Skills Based Final – Part 2 Troubleshooting (Individual performance - 20 pts) Objective: After your workstation and router have been successfully configured, you will be asked to leave and problems will be introduced into your PC and/or router to demonstrate troubleshooting skills. Problems encountered during troubleshooting and the steps taken to correct them must be documented. You will troubleshoot the workstation and router you configured during part 1 of the exam. Troubleshooting Activity Record – 10 Points each (use back if necessary) Symptom / Cause Tests / Results Detailed Solutions Points Semester 3 Skills Based Final – Part 3 Network Concepts (Individual performance - 20 pts – 10 pts each) Objective: Answer the 2 questions on semester 3 networking concepts as assigned by the instructor. Write the questions assigned in the space provided below. You may be asked to answer orally or write your answers on the back of this sheet. Answers should be as detailed as possible for maximum credit. Questions 1 (10 pts): _________________________________________________________________________________ _________________________________________________________________________________ Question 2: (10 pts) _________________________________________________________________________________ _________________________________________________________________________________ _________________________________________________________________________________ Points Scored: ____________ . IP addr: 17 1 .17 .255.65 Interface Serial 0 IP addr: 17 1 .17 .254 .1 93 Interface Serial 1 IP addr: 17 1 .17 .255 .1 Interface Serial 1 IP addr: 17 1 .17 .254 .12 9 Interface. _________________________________________________________________________________ Semester 3 Skills Based Final – Part 1 Router Configuration – Cont. (Individual performance - 60 pts – 4 pts each) District Router DO1 District Router