1. Trang chủ
  2. » Kỹ Thuật - Công Nghệ

Dang ky chia dieu khien tu xa cho land prado

5 25 0

Đang tải... (xem toàn văn)

THÔNG TIN TÀI LIỆU

Thông tin cơ bản

Định dạng
Số trang 5
Dung lượng 66,38 KB

Nội dung

73−28 THEFT DETERRENT & DOOR LOCK − TRANSMITTER SUB−ASSY MODULE SET DOOR CONTROL 730EY−01 REGISTRATION REGISTER RECOGNITION CODE HINT: S If replacing the door control transmitter or the door control receiver, register the recognition code S The add mode is used to register new recognition codes while still retaining codes already registered This mode is used when a new transmitter is added If the number of registered codes exceeds 4, the previously registered codes will be erased in order, starting from the first registered code S The rewrite mode is used to erase all the previously registered recognition codes in order to register all new recognition codes This mode is used when the transmitter or the door control receiver is exchanged for a new one S The confirmation mode is used to confirm how many recognition codes have already been registered before an additional registration of the recognition codes S The prohibition mode is used to erase all the registered codes and disables the wireless door lock function This mode is used when the transmitter is lost S All the following registration procedures must be performed in order continuously LAND CRUISER PRADO REPAIR MANUAL (RM990E) THEFT DETERRENT & DOOR LOCK − TRANSMITTER SUB−ASSY MODULE SET DOOR CONTROL Flow Chart of Recognition Code Registration START The vehicle should be in the following conditions F No key in ignition key cylinder F Driver side door is opened (Other doors are closed) F Driver side door is unlocked Insert key into ignition key cylinder, then pull it out Within sec Insert key into ignition key cylinder, then pull it out Close and open driver side door twice Within 40 sec Insert key into ignition key cylinder, then pull it out Close and open driver side door twice Insert key into ignition key cylinder and close all doors Within 40 sec Within 40 sec Continued on next page LAND CRUISER PRADO REPAIR MANUAL (RM990E) 73−29 73−30 THEFT DETERRENT & DOOR LOCK − TRANSMITTER SUB−ASSY MODULE SET DOOR CONTROL Continued from previous page Mode Selection: Turn ignition switch from LOCK to ON and back to LOCK at approximately second intervals according to the number of times shown below Number of ON−LOCK operation of ignition switch: Add Mode T1: Approx sec ON−LOCK operation: time T1 ON LOCK Rewrite Mode ON−LOCK operation: times T1 T1 ON LOCK Confirmation Mode Within 40 sec ON−LOCK operation: times T1 T1 ON LOCK Prohibition Mode ON−LOCK operation: times T1 T1 ON LOCK If the number of the ON−LOCK operations of the ignition switch is 0, or or more, there will be no response (power door lock and unlock operation) to show which mode has been selected Remove key from ignition key cylinder Within sec Continued on next page LAND CRUISER PRADO REPAIR MANUAL (RM990E) THEFT DETERRENT & DOOR LOCK − TRANSMITTER SUB−ASSY MODULE SET DOOR CONTROL 73−31 Continued from previous page Within sec Response to selected mode (Power door lock operation): Body ECU automatically performs power door LOCK−UNLOCK operation to show which mode has been selected Add Mode LOCK−UNLOCK operation: time T1: Approx sec T2: Approx sec T1 LOCK UNLOCK Rewrite Mode LOCK−UNLOCK operation: times T1 T1 LOCK UNLOCK Confirmation Mode LOCK−UNLOCK operation: The number of registered codes (1 − times) 1st time T2 2nd time T2 LOCK UNLOCK Prohibition Mode LOCK−UNLOCK operation: times T1 T1 LOCK UNLOCK HINT: F In the confirmation mode, when LOCK−UNLOCK operation is performed twice, the number of registered recognition codes is F In the confirmation mode, when codes are registered, LOCK−UNLOCK operation is automatically performed times Within 40 sec Add Mode or Rewrite Mode Continued on next page LAND CRUISER PRADO REPAIR MANUAL (RM990E) Confirmation Mode and Prohibition Mode Registration procedures are completed 73−32 THEFT DETERRENT & DOOR LOCK − TRANSMITTER SUB−ASSY MODULE SET DOOR CONTROL Continued from previous page Within 40 sec Press LOCK and UNLOCK switches on transmitter simultaneously Within sec 10 Press either switch Within sec Response to registration completion: Body ECU automatically performs power door LOCK−UNLOCK operation to show whether registration has been completed correctly or not LOCK−UNLOCK Occurs Once LOCK−UNLOCK Occurs Twice Registration of recognition code has been completed Registration of recognition code has failed T1 T1 LOCK LOCK UNLOCK UNLOCK T1 T1: Approx sec HINT: When LOCK−UNLOCK operation is performed twice, registration of recognition code has failed Perform registration procedures from beginning once again Within 40 sec Proceed with flow chart to finish registration If other transmitter is to be registered HINT: recognition codes can be registered at once Perform either of the following F Open any of doors F Insert key into ignition key cylinder Registration of recognition codes (add mode and rewrite mode) is completed LAND CRUISER PRADO REPAIR MANUAL (RM990E) ... next page LAND CRUISER PRADO REPAIR MANUAL (RM990E) 73−29 73−30 THEFT DETERRENT & DOOR LOCK − TRANSMITTER SUB−ASSY MODULE SET DOOR CONTROL Continued from previous page Mode Selection: Turn ignition... has been selected Remove key from ignition key cylinder Within sec Continued on next page LAND CRUISER PRADO REPAIR MANUAL (RM990E) THEFT DETERRENT & DOOR LOCK − TRANSMITTER SUB−ASSY MODULE SET... automatically performed times Within 40 sec Add Mode or Rewrite Mode Continued on next page LAND CRUISER PRADO REPAIR MANUAL (RM990E) Confirmation Mode and Prohibition Mode Registration procedures

Ngày đăng: 03/02/2020, 13:32

w