Electrical Hyundai I10 Getz(TB) New Model Technical Training full TB electrical
New Model Service Training VEHICLE : TB(Gets) 2002 Technical Service Training Center Electrical General - - Newly Adapted Item in the Body Electrical other parts when compare with New ACCENT ETACS section - Power window timer - Crash door unlock control from A/BAG - Battery Saver Control(Tail Lamp Auto Cut Control) - One button in-key type transmitter - Using B/Alarm horn instead of siren & receive antenna built in ETACSCM - Key Code Saving Use by Hi-scan Body Electrical section - In-Panel Junction Box - Head Lamp Circuit Relay-less type - Front Wiper Motor Control Relay-less type - One Cooling Fan Motor type - Body-less Multi function switch Body Electrical System section - Trip Computer Chonan TSTC ETACS Functions - - Usually, functions that is controlled in ETACSCM are as flow items However It explains about new function that explain here Defogger Timer Control Ignition Key Reminder Control Key Operated Warning Control WWW.OTO-HUI.COM Seat Belt Warning Timer Control Central Door Lock/Unlock Control Power Window Timer Control Crash Door Unlock Control Battery Saver Control(Tail Lamp Auto Cut Control) Room Lamp Decay Out Control & Keyless Unlock Timer Keyless Entry Control Anti-theft Control Chonan TSTC ETACS FUNCTION COMPARISON Kind different function compare Chonan TSTC - - Power Window Timer Control Power Window Timer Control Time Chart IGN S/W ON OFF Driver’s or Assist OPEN DR S/W CLOSE T1 T1 Power Window Off ON POWER WINDOW MOT OFF * T1 : 30 ± sec Remained time Description Power window output is “ON”, when IG switch is turned “ON” Power window output should be OFF after maintaining ON for 30 seconds, when IG switch is turned OFF If the driver door or front passenger door is opened within 30 seconds, the power window output must be off Chonan TSTC - - Crash Door Unlock Control - - Crash Door Unlock Control Time Chart Air Bag Deploy Condition Deployment Normal Air Bag Module High Crash Signal Low Door Unlock Output signal Unlock Door Lock Actuator Unlock Lock T1 T2 Door unlock signal output from A/BAG control module Lock T3 T1 : 200mSEC T2 : 40mSEC T3 : sec Description If the airbag signal is inputted to the ETACS when the door is locked, the unlock signal is executed immediately for safety At this time, all door should be unlocked for operating above “unlock execution” WWW.OTO-HUI.COM Chonan TSTC Battery Saver Control - - Battery Saver Control Time Chart(Tail Lamp Auto Cut) Lamp Auto Off IG KEY Switch Inserted Removed TAIL LAMP SWITCH ON Driver’s Door Switch OPEN TAIL LAMP (REALY) Lamp Auto Off OFF CLOSE ON OFF Description In case of the tail lamp switch is turned ON after IG SW ON or the driver door is opened after IG SW OFF, the tail lamp is extinguished automatically In addition, the IG SW is turned OFF after driver door is opened with IG SW is ON condition, the tail lamp will be extinguished automatically too After automatic extinguish, if the tail lamp switch is turned ON again, then, the tail lamp will be ON (illuminating) and the auto cut function will be released Chonan TSTC Room Decay Out Control - - Room Lamp Delay Out after receive “Keyless Unlock” signal FRT LH or RH Door S/W IG S/W TX Button ON OFF ON OFF UNLOCK LOCK 75% ON T2 Room Lamp OFF T1 * T1 : 5.5 ± 0.5 sec * T2 : 30 ± esc Description Room lamp must be light ON when the door is opened (door switch is ON) The brightness of room lamp should be reduced to 75% immediately, and be dimmed off gradually till the room lamp is OFF within - 6seconds after the door is closed (door switch is OFF) In case of the door open (door switch is ON) time is less than 0.1 second, then this function should not be operated This system takes 32 steps to dim the room lamp While the delay and brightness dimming room lamp are operating, output of them must be OFF immediately after IG switch is ON Chonan TSTC Room Decay Out Control - - Room Lamp control after receive “Keyless Unlock or Lock” signal UNLOCK Transmitter LOCK FRT LH or RH Door S/W Room Lamp Opened Closed ON OFF T2 T1 * T1 : 30 ± esc * T2 : 5.5 ± 0.5 sec Description The room lamp prolongs light “ON” about 30 sec If the Transmitter unlock signal receive with door is closed During room lamp operating by unlock signal of the Transmitter, lamp light goes OFF immediately if receive ignition switch ON or lock signal of the Transmitter The room lamp keeps lighting “ON” in light “ON” when opening the door, the room lamp is back to the delay function Chonan TSTC Burglar Alarm Horn - 10 - Using Burglar Alarm Horn instead of Siren Keyless Receive Antenna Built in the ETACS CM Transmitter One Button type in Key Door's Lock and unlock by ONE BUTTON that is combined with Ignition key Transmitter Lock Unlock Unlock Lock Lock Unlock Unlock Lock ONE BUTTON Type IN KEY ETACS CM B/ALARM HORN Chonan TSTC ... when the door is locked, the unlock signal is executed immediately for safety At this time, all door should be unlocked for operating above “unlock execution” WWW.OTO-HUI.COM Chonan TSTC Battery