1. Trang chủ
  2. » Kỹ Thuật - Công Nghệ

Using Embedded Tools for I2C, SPI, and USB Debugging for the Renesas RX63N RDK_LabProcedures

2 256 0

Đang tải... (xem toàn văn)

THÔNG TIN TÀI LIỆU

Thông tin cơ bản

Định dạng
Số trang 2
Dung lượng 94,97 KB

Nội dung

Project Build Directions Page 1 of 2 Using Embedded Tools for I2C, SPI, and USB Debugging and Development for Renesas MCUs Description: This lab asks participants to use Total Phase d

Trang 1

Project Build Directions

Page 1 of 2

Using Embedded Tools for I2C, SPI, and USB

Debugging and Development for Renesas MCUs

Description: This lab asks participants to use Total Phase development tools to debug

I2C, SPI, and USB applications on the Renesas YRDKRX63N Demonstration Board

This handout provides instructions on how rebuild a project after changes have been

made to the code.

Skill Level

Basic Knowledge of C, I2C, SPI, and USB protocols Time to Complete Lab

120 Minutes

Lab Materials

Beagle USB 480 Protocol Analyzer Beagle I2C/SPI Protocol Analyzer Aardvark I2C/SPI Host Adapter Renesas YRDKRX63N Demonstration Board

5 USB Cables

2 Mini-B USB Cable High Speed Hub MicroSD Card Data Center Software for Beagle analyzers Flash Center Software for Aardvark adapter e2studio

Lab Objectives

1 Isolate individual problems within a system

2 Learn to debug USB using the Beagle USB

480 Protocol Analyzer

3 Program an EEPROM using the Aardvark

I2C/SPI Host Adapter

4 Debug I2C using the Beagle I2C/SPI

Protocol Analyzer

Trang 2

Project Build Directions

Page 2 of 2

Project Build Directions

Procedural Steps

Step 1 Save (Ctrl+S)

Step 2 Click Build All (Ctrl+B)

Step 3 Click Debug (F11) to download the module

Step 4 Make sure the Renesas Debug “Perspective” (tab) is active, if it wasn’t selected

automatically You can switch between the C/C++ and debug perspectives when you are

debugging to more easily search code etc

Step 5 Hit Go (F8) If you hit a breakpoint that was left in a previous debug session, just hit Go

again (To halt execution press the Pause symbol, NOT the red square which exits debug!)

After corrections are made to the source code, you will need to save, rebuild,

and load the project before moving to the next steps in the presentation Follow the

steps below after you have made corrections to the source code

Ngày đăng: 22/06/2015, 14:17

TỪ KHÓA LIÊN QUAN

TÀI LIỆU CÙNG NGƯỜI DÙNG

TÀI LIỆU LIÊN QUAN

w