1. Trang chủ
  2. » Kỹ Thuật - Công Nghệ

CHAPTER 17: Thyristors (4-Layer Devices) doc

21 134 0

Đang tải... (xem toàn văn)

Tài liệu hạn chế xem trước, để xem đầy đủ mời bạn chọn Tải xuống

THÔNG TIN TÀI LIỆU

Thông tin cơ bản

Định dạng
Số trang 21
Dung lượng 402,28 KB

Nội dung

CHAPTER 17 Thyristors (4-Layer Devices) Objectives Describe and Analyze: • SCRs & Triacs • Shockley diodes & Diacs • Other 4-Layer Devices • UJTs • Troubleshooting Introduction • Thyristors: – Are 4-layer silicon semiconductors. – Use low input power to control large load currents. – Are very common in industrial power & motor control. – Are inherently nonlinear devices. – Have two states: ON and OFF. • Unijunction transistors (UJTs) are not thyristors, but are commonly used with SCRs. Unijunction Transistors (UJTs) UJTs • Before looking at SCRs, we will look at UJTs. A UJT is a “one trick pony”: its only common application is to provide trigger pulses to SCRs. • A simple relaxation oscillator can be made with a UJT, a capacitor, and a potentiometer. UJTs When emitter is forward biased, channel switches from high resistance to low resistance. Programmable UJT (PUT) A PUT is actually a thyristor that acts like a UJT. Its breakover point is set by a voltage divider. Silicon Controlled Rectifiers Two-transistor model of an SCR SCRs Once it is ON, it conducts until current is interrupted. SCRs Switches from OFF to ON instantly when triggered. SCRs Sizes range from I < 1A to I > 1000A. [...]...SCRs SCR Motor Control • A major application of SCRs is to control DC motors • SCRs, like all thyristors, need to be “commutated”, meaning interrupting the flow of current • An SCR motor control typically uses a full-wave rectifier without filtering the DC • When the pulsating DC goes to zero,... series-wound DC motors • Commutation is “provided free” by the AC current Light Dimmer using a TRIAC Trigger timing controlled by RC time constant Troubleshooting Rule 1: BE CAREFUL! • Industrially, thyristors are used in high-power circuits, often with high voltages SCRs and TRIACs commonly use a 110 Volt or 220 Volt AC main’s power without an isolation transformer • Check to see if the trigger circuit . CHAPTER 17 Thyristors (4-Layer Devices) Objectives Describe and Analyze: • SCRs & Triacs • Shockley diodes. Shockley diodes & Diacs • Other 4-Layer Devices • UJTs • Troubleshooting Introduction • Thyristors: – Are 4-layer silicon semiconductors. – Use low input power to control large load. inherently nonlinear devices. – Have two states: ON and OFF. • Unijunction transistors (UJTs) are not thyristors, but are commonly used with SCRs. Unijunction Transistors (UJTs) UJTs • Before

Ngày đăng: 08/08/2014, 16:22

TỪ KHÓA LIÊN QUAN