1 6 Pointed star box - base Begin with a square creased into quarters horizontally only crease between these lines 2 3 4 5 6 Crease so line A runs parallel to line B Inside reverse fold the double layer by lifting the top flap 7 8 9 10 11 Make the whole thing 3D 12 Make 5 more Valley fold the 2 inner layers A B © R.Glynn - July 1998 Fold the corner of the tab over the hidden flap to lock it in place 13 Slot 2 units together 15 16 Mountain fold flap behind Assemble remaining 4 units 6 Pointed star box - base Assembly © R.Glynn - July 1998 14 1 6 Pointed star box - lid 2 3 1/2 1/4 1/8 1/16 Make a small pinch 1/16 from the edge of the square Fold the top edge to the pinch mark only crease between these lines 4 5 6 7 10 8 A B 9 Unfold then valley fold left edge using the circled guide point 11 12 13 Valley fold back up to the circled guide point on layer below 14 15 Make unit 3D Crease so line A runs parallel to line B © R.Glynn - July 1998 16 6 Pointed star box - lid Assembly Insert tab into pocket (mate the two turned over top edges). Mountain fold behind to lock 17 Note how point tucks inside neighbouring module Assemble remaining 4 units © R.Glynn - July 1998 . together 15 16 Mountain fold flap behind Assemble remaining 4 units 6 Pointed star box - base Assembly © R.Glynn - July 1998 14 1 6 Pointed star box - lid 2 3 1/2 1/4 1/8 1/ 16 Make a small pinch 1/ 16 from. 1 6 Pointed star box - base Begin with a square creased into quarters horizontally only crease between these lines 2 3 4 5 6 Crease so line A runs parallel to. layer below 14 15 Make unit 3D Crease so line A runs parallel to line B © R.Glynn - July 1998 16 6 Pointed star box - lid Assembly Insert tab into pocket (mate the two turned over top edges). Mountain