Tài liệu hướng dẫn sửa chữa Hệ thống gạt mưa rửa kính trên xe Hilux 2015 2018 manual wiper washer gat mua rua kinh . Cung cấp các thông tin cần thiết cho Kỹ thuật viên tiến hành chẩn đoán, sửa chữa nhanh chóng, chính xác, hiệu quả
14/3/17, 12)06 pm WIPER / WASHER FRONT WIPER MOTOR COMPONENTS ILLUSTRATION https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000MQ8M.html Page of 14/3/17, 12)06 pm *A w/o Seal *B w/ Seal *1 COWL TOP VENTILATOR LOUVER SUBASSEMBLY *2 FENDER APRON MUDGUARD SEAL SUBASSEMBLY LH FENDER APRON MUDGUARD SEAL SUBhttps://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000MQ8M.html Page of 14/3/17, 12)06 pm *3 ASSEMBLY RH *4 FRONT FENDER TO COWL SIDE SEAL LH *5 FRONT FENDER TO COWL SIDE SEAL RH *6 FRONT WIPER ARM AND BLADE ASSEMBLY LH *7 FRONT WIPER ARM AND BLADE ASSEMBLY RH *8 FRONT WIPER ARM HEAD CAP *9 HOOD TO COWL TOP SEAL *10 HOOD TO FRONT FENDER SEAL LH HOOD TO FRONT FENDER SEAL RH *12 WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY *11 N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 WINDSHIELD WIPER MOTOR ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified torque *2 WINDSHIELD WIPER LINK ASSEMBLY MP grease https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000MQ8M.html Page of 14/3/17, 12)06 pm WIPER / WASHER FRONT WIPER MOTOR INSPECTION CAUTION / NOTICE / HINT CAUTION: Make sure that fingers or articles of clothing not get caught in moving parts when performing this test PROCEDURE 1.INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for LHD) a 85110 Check the LO operation i Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly OK: *a Measurement Condition Specified Condition Battery positive (+) → Terminal (+1) Battery negative (-) → Terminal (E) Motor operates at low speed Component without harness connected (Windshield Wiper Motor Assembly) If the result is not as specified, replace the windshield wiper motor assembly b Check the HI operation i Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly OK: Measurement Specified Condition Condition Battery positive (+) → Terminal (+2) Battery negative (-) → Terminal (E) Motor operates at high speed If the result is not as specified, replace the windshield wiper motor assembly 2.INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for RHD) 85110 https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000MQ8L.html Page of 14/3/17, 12)06 pm a Check the LO operation i Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly OK: *a Measurement Condition Specified Condition Battery positive (+) → Terminal (+1) Battery negative (-) → Terminal (E) Motor operates at low speed Component without harness connected (Windshield Wiper Motor Assembly) If the result is not as specified, replace the windshield wiper motor assembly b Check the HI operation i Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly OK: Measurement Specified Condition Condition Battery positive (+) → Terminal (+2) Battery negative (-) → Terminal (E) Motor operates at high speed If the result is not as specified, replace the windshield wiper motor assembly https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000MQ8L.html Page of 14/3/17, 12)06 pm WIPER / WASHER FRONT WIPER MOTOR INSTALLATION CAUTION / NOTICE / HINT HINT: · · Use the same procedure for RHD and LHD vehicles The procedure listed below is for LHD vehicles PROCEDURE 85110 1.INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY a Using a T30 "TORX" socket wrench, install the windshield wiper motor assembly with the bolts Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) b Apply MP grease to the front wiper crank pivot of the windshield wiper motor assembly *a c Front Wiper Crank Pivot Connect the No windshield wiper link rod to the front wiper crank pivot of the windshield wiper motor assembly https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000MQ8N.html Page of 14/3/17, 12)06 pm Install in this Direction 2.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY NOTICE: Be careful not to damage the windshield when installing the windshield wiper motor and link assembly a Attach the motor grommet to temporarily install the windshield wiper motor and link assembly as shown in the illustration b Install the windshield wiper motor and link assembly with the bolts in the order indicated in the illustration Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) c Connect the connector *1 Motor Grommet Bolt Connector https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000MQ8N.html Page of 14/3/17, 12)06 pm Install in this Direction 53383 3.INSTALL HOOD TO COWL TOP SEAL a Attach the claw and clip to install the hood to cowl top seal 4.INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY a 55781E Push the cowl top ventilator louver sub-assembly as shown in the illustration to attach the guide Install in this Direction b Attach the claw and install the cowl top ventilator louver sub-assembly https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000MQ8N.html Page of 14/3/17, 12)06 pm Install in this Direction c Install the clips 53867H 5.INSTALL FRONT FENDER TO COWL SIDE SEAL LH a Attach the guide and claw and install the front fender to cowl side seal LH as shown in the illustration Install in this Direction (1) https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000MQ8N.html Page of 14/3/17, 12)06 pm Install in this Direction (2) 6.INSTALL FRONT FENDER TO COWL SIDE SEAL RH 53866J HINT: Use the same procedure for the LH side 7.INSTALL HOOD TO FRONT FENDER SEAL LH (w/ Seal) a 53389B Attach the claw and install the hood to front fender seal LH 8.INSTALL HOOD TO FRONT FENDER SEAL RH (w/ Seal) 53388D HINT: Use the same procedure described for the LH side 9.INSTALL FENDER APRON MUDGUARD SEAL SUB-ASSEMBLY LH a Attach the claw and clip and install the fender apron mudguard seal sub-assembly LH b Attach the clip and connect the hood to cowl top seal to the fender apron mudguard seal subassembly LH 10.INSTALL FENDER APRON MUDGUARD SEAL SUB-ASSEMBLY RH 53886G 53885G HINT: Use the same procedure described for the LH side https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000MQ8N.html Page of