Tài liệu hướng dẫn sửa chữa Hệ thống gương kính trên xe Hilux 2015 2018 manual mirror guong kinh . Cung cấp các thông tin cần thiết cho Kỹ thuật viên tiến hành chẩn đoán, sửa chữa nhanh chóng, chính xác, hiệu quả
14/3/17, 12)02 pm MIRROR (EXT) OUTER MIRROR SWITCH COMPONENTS ILLUSTRATION *A for LHD *1 FRONT ARMREST ASSEMBLY LH *3 POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL *2 - OUTER MIRROR SWITCH ASSEMBLY - ILLUSTRATION https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M32X.html Page of 14/3/17, 12)02 pm *A for RHD *1 FRONT ARMREST ASSEMBLY RH *3 POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL *2 - OUTER MIRROR SWITCH ASSEMBLY - https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M32X.html Page of 14/3/17, 12)02 pm MIRROR (EXT) OUTER MIRROR SWITCH INSPECTION PROCEDURE 1.INSPECT OUTER MIRROR SWITCH ASSEMBLY (for LHD, w/ Power Retract Mirror) a 84870A Check the mirror retract switch i Measure the resistance according to the value(s) in the table below Standard Resistance: Tester Connection Condition Specified Condition (MR) - (E2) (MF) - (+B2) Extended position Below Ω (MR) - (+B2) (MF) - (E2) Retracted position Below Ω *a Component without harness connected (Outer Mirror Switch Assembly) *b Mirror Retract Switch *c Mirror Select Switch and Mirror Surface Adjust Switch If the result is not as specified, replace the outer mirror switch assembly b Check the mirror select switch and mirror surface adjust switch i Turn the mirror select switch to the L position https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M32Z.html Page of 14/3/17, 12)02 pm ii Measure the resistance according to the value(s) in the table below Standard Resistance (for Left Side): Tester Specified Condition Connection Condition Up Below Ω Off 10 kΩ or higher (B) - 13 (M+) 15 (E) - 10 (VL) Down Below Ω Off 10 kΩ or higher (B) - (HL) 15 (E) - 13 (M+) Left Below Ω Off 10 kΩ or higher Right Below Ω Off 10 kΩ or higher (B) - 10 (VL) 15 (E) - 13 (M+) (B) - 13 (M+) 15 (E) - (HL) iii Turn the mirror select switch to the R position iv Measure the resistance according to the value(s) in the table below Standard Resistance (for Right Side): Tester Specified Condition Connection Condition Up Below Ω Off 10 kΩ or higher (B) - 13 (M+) 15 (E) - 12 (VR) Down Below Ω Off 10 kΩ or higher (B) - 11 (HR) 15 (E) - 13 (M+) Left Below Ω Off 10 kΩ or higher (B) - 13 (M+) 15 (E) - 11 (HR) Right Below Ω Off 10 kΩ or higher (B) - 12 (VR) 15 (E) - 13 (M+) If the result is not as specified, replace the outer mirror switch assembly 2.INSPECT OUTER MIRROR SWITCH ASSEMBLY (for LHD, w/o Power Retract Mirror) a 84870A Check the mirror select switch and mirror surface adjust switch i Turn the mirror select switch to the L position ii Measure the resistance according to the value(s) in the table below Standard Resistance (for Left Side): https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M32Z.html Page of 14/3/17, 12)02 pm Tester Connection Condition Specified Condition Up Below Ω Off 10 kΩ or higher (B) - 13 (M+) 15 (E) - 10 (VL) Down Below Ω Off 10 kΩ or higher (B) - (HL) 15 (E) - 13 (M+) Left Below Ω Off 10 kΩ or higher Right Below Ω Off 10 kΩ or higher (B) - 10 (VL) 15 (E) - 13 (M+) (B) - 13 (M+) 15 (E) - (HL) *a Component without harness connected (Outer Mirror Switch Assembly) *b Mirror Select Switch and Mirror Surface Adjust Switch iii Turn the mirror select switch to the R position iv Measure the resistance according to the value(s) in the table below Standard Resistance (for Right Side): Tester Specified Condition Connection Condition (B) - 12 (VR) Up Below Ω https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M32Z.html Page of 14/3/17, 12)02 pm 15 (E) - 13 (M+) Off 10 kΩ or higher (B) - 13 (M+) 15 (E) - 12 (VR) Down Below Ω Off 10 kΩ or higher (B) - 11 (HR) 15 (E) - 13 (M+) Left Below Ω Off 10 kΩ or higher (B) - 13 (M+) 15 (E) - 11 (HR) Right Below Ω Off 10 kΩ or higher If the result is not as specified, replace the outer mirror switch assembly 3.INSPECT OUTER MIRROR SWITCH ASSEMBLY (for RHD, w/ Power Retract Mirror) a 84870A Check the mirror retract switch i Measure the resistance according to the value(s) in the table below Standard Resistance: Tester Connection Condition *a Component without harness connected (Outer Mirror Switch Assembly) *b Mirror Retract Switch *c Mirror Select Switch and Mirror Surface Adjust Switch Specified Condition https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M32Z.html Page of 14/3/17, 12)02 pm (MR) - (E2) (MF) - (+B2) Extended position Below Ω (MR) - (+B2) (MF) - (E2) Retracted position Below Ω If the result is not as specified, replace the outer mirror switch assembly b Check the mirror select switch and mirror surface adjust switch i Turn the mirror select switch to the L position ii Measure the resistance according to the value(s) in the table below Standard Resistance (for Left Side): Tester Specified Condition Connection Condition 15 (B) - 12 (VL) (E) - (M+) 15 (B) - (M+) (E) - 12 (VL) 15 (B) - 13 (HL) (E) - (M+) 15 (B) - (M+) (E) - 13 (HL) Up Below Ω Off 10 kΩ or higher Down Below Ω Off 10 kΩ or higher Left Below Ω Off 10 kΩ or higher Right Below Ω Off 10 kΩ or higher iii Turn the mirror select switch to the R position iv Measure the resistance according to the value(s) in the table below Standard Resistance (for Right Side): Tester Specified Condition Connection Condition 15 (B) - 10 (VR) (E) - (M+) 15 (B) - (M+) (E) - 10 (VR) 15 (B) - 11 (HR) (E) - (M+) 15 (B) - (M+) (E) - 11 (HR) Up Below Ω Off 10 kΩ or higher Down Below Ω Off 10 kΩ or higher Left Below Ω Off 10 kΩ or higher Right Below Ω Off 10 kΩ or higher If the result is not as specified, replace the outer mirror switch assembly 4.INSPECT OUTER MIRROR SWITCH ASSEMBLY (for RHD, w/o Power Retract Mirror) 84870A https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M32Z.html Page of 14/3/17, 12)02 pm a Check the mirror select switch and mirror surface adjust switch i Turn the mirror select switch to the L position ii Measure the resistance according to the value(s) in the table below Standard Resistance (for Left Side): Tester Connection 15 (B) - 12 (VL) (E) - (M+) 15 (B) - (M+) (E) - 12 (VL) 15 (B) - 13 (HL) (E) - (M+) 15 (B) - (M+) (E) - 13 (HL) Condition Specified Condition Up Below Ω Off 10 kΩ or higher Down Below Ω Off 10 kΩ or higher Left Below Ω Off 10 kΩ or higher Right Below Ω Off 10 kΩ or higher *a Component without harness connected (Outer Mirror Switch Assembly) *b Mirror Select Switch and Mirror Surface Adjust Switch iii Turn the mirror select switch to the R position iv Measure the resistance according to the value(s) in the table below Standard Resistance (for Right Side): Tester Specified Condition Connection Condition https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M32Z.html Page of 14/3/17, 12)02 pm 15 (B) - 10 (VR) (E) - (M+) 15 (B) - (M+) (E) - 10 (VR) 15 (B) - 11 (HR) (E) - (M+) 15 (B) - (M+) (E) - 11 (HR) Up Below Ω Off 10 kΩ or higher Down Below Ω Off 10 kΩ or higher Left Below Ω Off 10 kΩ or higher Right Below Ω Off 10 kΩ or higher If the result is not as specified, replace the outer mirror switch assembly https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M32Z.html Page of 14/3/17, 12)02 pm MIRROR (EXT) OUTER MIRROR SWITCH INSTALLATION PROCEDURE 1.INSTALL OUTER MIRROR SWITCH ASSEMBLY a for LHD: i Attach the claw to install the outer mirror switch assembly b for RHD: i Attach the claw to install the outer mirror switch assembly 84870A 2.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL Click hereVehicle Exterior>DOOR / HATCH>FRONT DOOR>REASSEMBLY 3.INSTALL FRONT ARMREST ASSEMBLY LH (for LHD) 74220 Click hereVehicle Exterior>DOOR / HATCH>FRONT DOOR>REASSEMBLY 4.INSTALL FRONT ARMREST ASSEMBLY RH (for RHD) 74210 HINT: Use the same procedure described for the LH side of LHD vehicles Click here Click hereVehicle Exterior>DOOR / HATCH>FRONT DOOR>REASSEMBLY 5.INSPECT POWER MIRROR CONTROL SYSTEM Click hereVehicle Exterior>MIRROR (EXT)>POWER MIRROR CONTROL SYSTEM>OPERATION CHECK https://toyotamanuals.com.au/docs/hilux-service-repair-manual-jul-15-current/N00148/manual/repair/contents/RM100000000M330.html Page of