Tài liệu hướng dẫn sửa chữa Hệ thống khí thải trên xe Toyota camry hybrid xv50 2012 2017 exhaust system khí thải. Cung cấp các thông tin cần thiết cho Kỹ thuật viên tiến hành chẩn đoán, sửa chữa nhanh chóng, chính xác
EX–1 2AZ-FXE EXHAUST – EXHAUST PIPE EXHAUST PIPE 2AZ-FXE EXHAUST ENGINE COMPONENTS HEATED OXYGEN SENSOR 44 (449, 32) GASKET FRONT EXHAUST PIPE ASSEMBLY 62 (632, 46) 33 (337, 24) REAR EXHAUST PIPE NO SUPPORT BRACKET FRONT EXHAUST PIPE NO SUPPORT BRACKET GASKET EX 43 (438, 32) 33 (337, 24) EXHAUST PIPE SUPPORT NO 56 (571, 41) GASKET CENTER EXHAUST PIPE ASSEMBLY EXHAUST PIPE SUPPORT NO EXHAUST PIPE SUPPORT NO 56 (571, 41) EXHAUST PIPE SUPPORT NO TAIL PIPE ASSEMBLY Non-reusable part N*m (kgf*cm, ft.*lbf) : Specified torque A142736E01 EX–2 2AZ-FXE EXHAUST – EXHAUST PIPE REMOVAL REMOVE TAIL PIPE ASSEMBLY (a) Remove the nuts and tail pipe assembly EX A146108 (b) Remove the gasket from the center exhaust pipe REMOVE CENTER EXHAUST PIPE ASSEMBLY (a) Remove the bolts, nuts and center exhaust pipe assembly A146109 (b) Remove the gasket from the front exhaust pipe REMOVE HEATED OXYGEN SENSOR (See page EC26) 2AZ-FXE EXHAUST – EXHAUST PIPE EX–3 REMOVE FRONT EXHAUST PIPE ASSEMBLY (a) Remove the nuts, front exhaust pipe No support bracket and front exhaust pipe assembly EX A146117 (b) Remove the gasket from the front exhaust pipe assembly REMOVE REAR EXHAUST PIPE NO SUPPORT BRACKET (a) Remove the bolts and rear support bracket Bracket A132948E01 INSTALLATION Front Exhaust Pipe Assembly INSTALL REAR EXHAUST PIPE NO SUPPORT BRACKET (a) Install the rear support bracket with the bolts Torque: 33 N*m (337 kgf*cm, 24 ft.*lbf) NOTICE: Be sure to install the bracket in the correct direction INSTALL FRONT EXHAUST PIPE ASSEMBLY (a) Install a new gasket onto the front exhaust pipe assembly Bracket A060823E05 EX–4 2AZ-FXE EXHAUST – EXHAUST PIPE (b) Install the front exhaust pipe assembly with the nuts EX A146117 Torque: 62 N*m (632 kgf*cm, 46 ft.*lbf) (c) Install the front exhaust pipe No support bracket with the nuts Torque: 33 N*m (337 kgf*cm, 24 ft.*lbf) INSTALL HEATED OXYGEN SENSOR (See page EC26) INSTALL CENTER EXHAUST PIPE ASSEMBLY (a) Install a new gasket onto the front exhaust pipe (b) Install the center exhaust pipe assembly with the bolts and nuts A146109 Torque: 56 N*m (571 kgf*cm, 41 ft.*lbf) 2AZ-FXE EXHAUST – EXHAUST PIPE EX–5 INSTALL TAIL PIPE ASSEMBLY (a) Install a new gasket onto the center exhaust pipe assembly (b) Install the tail pipe assembly with the nuts EX A146108 Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf) INSPECT FOR EXHAUST GAS LEAK If gas is leaking, tighten the areas necessary to stop the leak Replace the damaged parts as necessary