Microsoft Word C052665e doc ICS 23 100 20 Ref No ISO 6020 2 2006/Cor 1 2008(E) © ISO 2008 – All rights reserved Published in Switzerland INTERNATIONAL STANDARD ISO 6020 2 2006 TECHNICAL CORRIGENDUM 1[.]
INTERNATIONAL STANDARD ISO 6020-2:2006 TECHNICAL CORRIGENDUM Published 2008-10-15 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION • МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ • ORGANISATION INTERNATIONALE DE NORMALISATION Hydraulic fluid power — Mounting dimensions for single rod cylinders, 16 MPa (160 bar) series — Part 2: Compact series TECHNICAL CORRIGENDUM Transmissions hydrauliques — Dimensions d'interchangeabilité des vérins 16 MPa (160 bar) simple tige — Partie 2: Série compacte RECTIFICATIF TECHNIQUE Page iv, Foreword Replace the sixth paragraph with the following new paragraph: “This third edition of ISO 6020-2 cancels and replaces the second edition of ISO 6020-2 (ISO 6020-2:1991), ISO 8138 (ISO 8138:1998) and ISO 8131 (ISO 8131:1992), of which it constitutes a technical revision.” ICS 23.100.20 Ref No ISO 6020-2:2006/Cor.1:2008(E) © ISO 2008 – All rights reserved Published in Switzerland Copyright International Organization for Standardization Provided by IHS under license with ISO No reproduction or networking permitted without license from IHS Not for Resale `,,```,,,,````-`-`,,`,,`,`,,` - Technical Corrigendum to ISO 6020-2:2006 was prepared by Technical Committee ISO/TC 131, Fluid power systems, Subcommittee SC 3, Cylinders