204-02-1 Rear Suspension 204-02-1 SECTION 204-02 Rear Suspension VEHICLE APPLICATION: 2011.50 Ranger CONTENTS PAGE DESCRIPTION AND OPERATION Rear Suspension 204-02-2 REMOVAL AND INSTALLATION Spring (15 621 0) Rear Shock Absorber (15 791 0) 204-02-4 204-02-6 Rear Suspension 204-02-2 204-02-2 DESCRIPTION AND OPERATION Rear Suspension 4x2 Item Description Shock absorber Leaf Spring Shackle Assembly 2011.50 Ranger G1268941en Rear Suspension 204-02-3 204-02-3 DESCRIPTION AND OPERATION 4X2 Vehicles with increased ride height/4x4 Item Description Shock absorber Leaf Spring Shackle Assembly 2011.50 Ranger G1268941en 204-02-4 Rear Suspension 204-02-4 REMOVAL AND INSTALLATION Spring(15 621 0) 4x4 Removal Torque: 120 Nm CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense A new part with the same part number or an equivalent part must be installed, if installation is necessary Do not use a part of lesser quality or substitute design Torque values must be used as specified during reassembly to make sure of correct retention of these parts NOTE: Removal steps in this procedure may contain installation details Refer to: Lifting (100-02 Jacking and Lifting, Description and Operation) 4x2 Torque: 120 Nm All vehicles Torque: 162 Nm NOTE: Note the position of the bracket 2011.50 Ranger G1269451en 204-02-5 Rear Suspension 204-02-5 REMOVAL AND INSTALLATION Torque: 103 Nm Installation CAUTION: Install new spring locknuts and U-bolt nuts NOTE: Final tightening of the rear suspension components should be carried out when the vehicle weight is on the road wheels To install, reverse the removal procedure 2011.50 Ranger G1269451en 204-02-6 Rear Suspension 204-02-6 REMOVAL AND INSTALLATION Rear Shock Absorber(15 791 0) Removal CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense A new part with the same part number or an equivalent part must be installed, if installation is necessary Do not use a part of lesser quality or substitute design Torque values must be used as specified during reassembly to make sure of correct retention of these parts NOTE: Removal steps in this procedure may contain installation details Torque: • Torque: 47 Nm • Torque: 47 Nm Installation NOTE: Do not fully tighten the shock absorber lower mounting bolt The final tightening should be carried out when the vehicle weight is on the road wheels To install, reverse the removal procedure 2011.50 Ranger G1269452en