2019-STI-USACE-Design-Build-Flyer_October-2019

Semper Tek’s Team has successfully delivered several Design-Build projects for USACE & other Federal Clients over the last years The Design-Build project scopes ranged in complexity and value for single project between $150K to $8M PROJECT RISK FACTORS DBB Longer Project Time-lines to accommodate sequential phases: Design, Bid, Construction Adds Risk to breakdown in communication Low-Cost Setbacks such as less experienced and low quality bidders can affect the project Eliminates cost verification during Design Phase PROGRAM The Semper Tek Team works together from start to finish, in open communication with the Owner, to deliver otherwise unachievable results The best logical solutions are conceived when all stakeholders are in collaboration, resulting in minimized cost, schedules streamlined and efficiencies realized with the quality results It’s the best return on investment! Design-Build TIME Reduce 15% or more off the project time-line by incorporating the construction team early on in the design process Less documentation is needed and the Construction Phase can begin much earlier COST Control Cost towards SOW & Cost Reduction can be achieved by the continuous analysis of cost options that parallels the Design Packages Cost can be controlled early enough in order to meet the project budget QUALITY Expect High Quality project that meet the program needs by benefiting the Construction Team with a much earlier start to planning logistics, product procurement and QA/QC coordination DESIGN BUILD ☑ $ High Quality TRADITIONAL DESIGN - BID - BUILD Quality Reduction due to Low Bid approach if selected contractor is not accustomed to perform project type DESIGN-BUILD DBB CBOC Rendering, Ft Knox, KY, USACE Louisville District www.SemperTekInc.com Phone: 859.252.8339 Design-Build Program Design-Build Relevant Experience Semper Tek’s Design-Build Program provides owners with a single point of contact responsible for both the design and construction phases of a project We have the responsibility and contractual risk for every aspect of a project build from: program verification, cost assessments, pre-construction activities including architecture, interiors, engineering, subcontracting, construction and post-construction D/B Renovation of Bldg 614 & Demolition of Bldg 745 Wright-Patterson AFB, Ohio USACE W912QR-09-D-0043, Task Order 0014 Completed in April 2014 for $2,193,789.59 D/B HVAC for Oncology and Hematology Departments Robley Rex VAMC, Louisville, Kentucky Department of Veterans Affairs VA249-14-C-0031 Completed in July 2015 for $1,185,026.36 Design Build Team D/B Electrical Repair for High Perf Computer at WPAFB Wright-Patterson AFB, Ohio USACE Louisville District, SDVOSB MATOC W912QR-13-D-0027 Completed in May 2016 for $611,426.69 Team Leader - Architecture Santiago Iturralde Bachelor of Architecture - SPSU (Now KSU) 20 years of experience in A/E Industry 15 years in Design-Build D-B Project Experience Range: 2M to 30M D/B VA Community Based Outpatient Clinic (CBOC) Fort Knox, KY USACE Louisville District W912QR18-C0025 Anticipated in Spring 2020 for $8,755,435.68 Civil - Structural Jason Brinkmoeller Civil Eng - Virginia Military Institute 12 years of C.M experience 10 years in Design-Build D-B Project Experience Range: 150K to 10M Electrical - Mechanical Bill Daugherty Electrical Eng - GA Institute of Technology 14 years of C.M experience years in Design-Build D-B Project Experience Range: 200K to 7M Mr Brinkmoeller holds a Certified Healthcare Constructor (CHC) Certification by the American Society of Healthcare Engineers (ASHE) Mr Brinkmoeller is one of only eight people in the state of Kentucky, and the only employee of a SDVOSB Firm to hold this prestigious certification Jason’s certification is valid until October 2020 This specialized knowledge will be applied to all Design-Build projects with Healthcare SOW Cost & Risk Management Scott Matheny C.M Degree - Eastern Kentucky University 25 years of C.M experience 15 years in Design-Build D-B Project Experience Range: 200K to 18M Constructability - Logistics Eric Boursaw B.S Construction Management - AAS 22 years of C.M experience 15 years in Design-Build D-B Project Experience Range: 4M to 54M A Service-Disabled Veteran Owned Small Business VA C BOC 3-D Modeling Coordination Semper Tek’s Team has the in-house capabilities to produce 3D BIM Models in order to illustrate the programing needs, coordinate the major systems & building components during the design phase