Shop Manual & ETM BCM KIA Cerato 2010 - Indicators And Gauges
Shop Manual & ETM BCM KIA Cerato 2010 - Indicators And Gauges
... switch 2010 > G 1.6 DOHC > Body Electrical System ComponentsLanguage 2010 > G 1.6 DOHC > Body Electrical System Circuit DiagramLanguage 2010 > G 1.6 DOHC > Body ... Disconnect the negative (-) battery terminal.2. Remove the side air vent (B) using the SST (A) (0984 0-1 M100). (Refer to the Body group - Crash pad)Always use the SST(0984 0-1 M100) to pr...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Fuses And Relays
... in the I/P-G and the No.2 or 4 terminal in the I/P-F when power and ground are connected to the No.3 terminal in the I/P-G and the No.16 terminal in the I/P-B. 2010 > G 1.6 DOHC > Body ... blew first and completely eliminate the problem before installing a new fuse. 2010 > G 1.6 DOHC > Body Electrical System Component LocationLanguage 2010 > G 1.6 DOHC > Body...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Audio
... antenna (Radio) 2010 > G 1.6 DOHC > Body Electrical System ComponentsLanguage 2010 > G 1.6 DOHC > Body Electrical System Removal1. Disconnect the negative (-) battery terminal.2. ... > Body Electrical System ComponentsLanguage 2010 > G 1.6 DOHC > Body Electrical System Circuit Diagram 2010 > G 1.6 DOHC > Body Electrical System DescriptionLanguageLang...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Auto Lighting Control System
... (V) 2010 > G 1.6 DOHC > Body Electrical System Component LocationLanguageLanguage 1. Auto light sensor2. Head lamps3. Lighting switch (Auto)4. Tail lamps5. Body control module (BCM) 2010 ... (Auto)4. Tail lamps5. Body control module (BCM) 2010 > G 1.6 DOHC > Body Electrical System Circuit DiagramLanguage 2010 > G 1.6 DOHC > Body Electrical System InspectionOperate t...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - BCM (Body Control Module)
... OPEN/ON 2.5V Below 6V OverFrequencyCAN H OPEN/ON - -CAN L OPEN/ON - -CommunicationCrash Input OPEN/ON - -CODE SAVE OPEN/ON - -K LINE OPEN/ON - - ... switch -2 3 Start Stop Button 24 Head Lamp High switch25 -2 6 GNDTerminal Voltage FntoFnto PnNmPnNm SaettVlaeLvlotg eeLow Level High LevelAnalog InputB+ 8V ~ 16V - -AutoLightSig 0V ~ 5V - -IntT ... B+Atm solen...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Button Engine Start System
... related to:• "Start Stop Button (SSB) monitoring", • "Immobilizer communication" (with Engine Management System unit for immobilizer release),• "ESCL control", • "Authentication ... ComponentLanguage 2010 > G 1.6 DOHC > Body Electrical System Removal1. Disconnect the negative (-) battery terminal.2. Remove the crash pad lower panel (A). (Refer to...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Electro chromic Inside Rear View Mirror
... Status Indicator LED turning on.The mirror defaults to the "ON" position each time the vehicle is started. 2010 > G 1.6 DOHC > Body Electrical System InspectionCheck it by the ... 2010 > G 1.6 DOHC > Body Electrical System DescriptionThe ECM (Electro Chromic inside rear view Mirror) ... controlled by the Dimming ON/OFF Button :1. Pressing and holding the Feature C...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - General Information
... battery checker (MCR-570 KIT), check the battery for damage, state of charge, and clean and tight connections.(Refer to the Engine Electrical System - Battery)• Do not quick-charge a battery unless ... harness doesn't interfere with any moving parts.5. Keep wire harnesses away from exhaust pipes and other hot parts, from sharp edges of brackets and holes, and from exposed s...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Head lamp leveling Device
... 2010 > G 1.6 DOHC > Body Electrical System Circuit Diagram 2010 > G 1.6 DOHC > Body Electrical System Removal1. Disconnect the negative (-) battery terminal.2. ... accordance with the head lamp aiming instructions. 2010 > G 1.6 DOHC > Body Electrical System Inspection1. Disconnect the negative (-) battery terminal.2. Remove the lower side crash pad ... group -...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Horn
... 2010 > G 1.6 DOHC > Body Electrical System Component Location1. Horn switch 4. Horn relayLanguage 2. Relay box (Engine room compartment)3. Horn (Low pitch - Single)5. Clock spring 2010 ... Single)5. Clock spring 2010 > G 1.6 DOHC > Body Electrical System Removal1. Remove the front bumper. (Refer to the Body group - front bumper).2. Remove the bolts and disconnect t...
Ngày tải lên: 22/10/2012, 15:55