Shop Manual & ETM BCM KIA Cerato 2010 - General Information
Shop Manual & ETM BCM KIA Cerato 2010 - General Information
... 2010 > G 1.6 DOHC > Body Electrical System General Troubleshooting InformationBefore Troubleshooting1. Check applicable fuses ... battery checker (MCR-570 KIT), check the battery for damage, state of charge, and clean and tight connections.(Refer to the Engine Electrical System - Battery)• Do not quick-charge a battery unless ... reconnected, the customer's radio stations b...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Audio
... the connector. 2010 > G 1.6 DOHC > Body Electrical System ComponentsLanguage 2010 > G 1.6 DOHC > Body Electrical System Circuit Diagram 2010 > G 1.6 DOHC > Body Electrical ... antenna (Radio) 2010 > G 1.6 DOHC > Body Electrical System ComponentsLanguage 2010 > G 1.6 DOHC > Body Electrical System Removal1. Disconnect the negative (-) battery term...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Auto Lighting Control System
... (V) 2010 > G 1.6 DOHC > Body Electrical System Component LocationLanguageLanguage 1. Auto light sensor2. Head lamps3. Lighting switch (Auto)4. Tail lamps5. Body control module (BCM) 2010 ... (Auto)4. Tail lamps5. Body control module (BCM) 2010 > G 1.6 DOHC > Body Electrical System Circuit DiagramLanguage 2010 > G 1.6 DOHC > Body Electrical System InspectionOperate t...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - BCM (Body Control Module)
... OPEN/ON 2.5V Below 6V OverFrequencyCAN H OPEN/ON - -CAN L OPEN/ON - -CommunicationCrash Input OPEN/ON - -CODE SAVE OPEN/ON - -K LINE OPEN/ON - - ... switch -2 3 Start Stop Button 24 Head Lamp High switch25 -2 6 GNDTerminal Voltage FntoFnto PnNmPnNm SaettVlaeLvlotg eeLow Level High LevelAnalog InputB+ 8V ~ 16V - -AutoLightSig 0V ~ 5V - -IntT ... B+Atm solen...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Button Engine Start System
... ComponentLanguage 2010 > G 1.6 DOHC > Body Electrical System Removal1. Disconnect the negative (-) battery terminal.2. Remove the crash pad lower panel (A). (Refer to Body group - "Crash pad")3. ... cover.Language 2010 > G 1.6 DOHC > Body Electrical System ComponentLanguage 2010 > G 1.6 DOHC > Body Electrical System Language Removal1. Disconnect the...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Electro chromic Inside Rear View Mirror
... the auto-dimming function ON which is indicated by the green Status Indicator LED turning on.The mirror defaults to the "ON" position each time the vehicle is started. 2010 > G ... 2010 > G 1.6 DOHC > Body Electrical System DescriptionThe ECM (Electro Chromic inside rear view Mirror) ... 2010 > G 1.6 DOHC > Body Electrical System InspectionCheck it by the proce...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Fuses And Relays
... relay, Trunk lid relay (Built-in-Junction box)2. Door unlock relay, Door lock relay, Front deicer relay, Hazard relay (Built-in-ICM relay Box) 2010 > G 1.6 DOHC > Body Electrical System ... in the I/P-G and the No.2 or 4 terminal in the I/P-F when power and ground are connected to the No.3 terminal in the I/P-G and the No.16 terminal in the I/P-B. 2010 > G 1.6 DOHC > Body ......
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Head lamp leveling Device
... 2010 > G 1.6 DOHC > Body Electrical System Circuit Diagram 2010 > G 1.6 DOHC > Body Electrical System Removal1. Disconnect the negative (-) battery terminal.2. ... accordance with the head lamp aiming instructions. 2010 > G 1.6 DOHC > Body Electrical System Inspection1. Disconnect the negative (-) battery terminal.2. Remove the lower side crash pad ... (A) from the...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Horn
... 2010 > G 1.6 DOHC > Body Electrical System Component Location1. Horn switch 4. Horn relayLanguage 2. Relay box (Engine room compartment)3. Horn (Low pitch - Single)5. Clock spring 2010 ... Horn (Low pitch - Single)5. Clock spring 2010 > G 1.6 DOHC > Body Electrical System Removal1. Remove the front bumper. (Refer to the Body group - front bumper).2. Remove the bo...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Ignition Switch Assembly
... 2010 > G 1.6 DOHC > Body Electrical System Inspection1. Disconnect the ignition switch connector (B) ... If continuity is not specified, replace the switch.Language Removal1. Disconnect the negative (-) battery terminal.2. Remove the steering column upper and lower shrouds (A).3. Remove the key
Ngày tải lên: 22/10/2012, 15:55