Shop Manual & ETM BCM KIA Cerato 2010 - Electro chromic Inside Rear View Mirror
... view mirror( A) pulling it upside carefully.Make sure the mounting bracket and mirror not to be damaged.Installation1. Install the inside rear view mirror. 2. Connect the inside rear view mirror ... 2010 > G 1.6 DOHC > Body Electrical System DescriptionThe ECM (Electro Chromic inside rear view Mirror) is for dimming the reflecting light ... and rearward l...
Ngày tải lên: 22/10/2012, 15:55
... group - "Front door")2. Remove the front speaker (A) after removing 4 rivets. Rear Speaker1. Remove the rear door trim.(Refer to the BD group - " ;Rear door")2. Remove the rear ... the connector. 2010 > G 1.6 DOHC > Body Electrical System ComponentsLanguage 2010 > G 1.6 DOHC > Body Electrical System Circuit Diagram 2010 > G 1.6 DOHC >...
Ngày tải lên: 22/10/2012, 15:55
... (V) 2010 > G 1.6 DOHC > Body Electrical System Component LocationLanguageLanguage 1. Auto light sensor2. Head lamps3. Lighting switch (Auto)4. Tail lamps5. Body control module (BCM) 2010 ... (Auto)4. Tail lamps5. Body control module (BCM) 2010 > G 1.6 DOHC > Body Electrical System Circuit DiagramLanguage 2010 > G 1.6 DOHC > Body Electrical System InspectionOperate t...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - BCM (Body Control Module)
... OPEN/ON 2.5V Below 6V OverFrequencyCAN H OPEN/ON - -CAN L OPEN/ON - -CommunicationCrash Input OPEN/ON - -CODE SAVE OPEN/ON - -K LINE OPEN/ON - - ... switch -2 3 Start Stop Button 24 Head Lamp High switch25 -2 6 GNDTerminal Voltage FntoFnto PnNmPnNm SaettVlaeLvlotg eeLow Level High LevelAnalog InputB+ 8V ~ 16V - -AutoLightSig 0V ~ 5V - -IntT ... B+Atm solen...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Button Engine Start System
... related to:• "Start Stop Button (SSB) monitoring", • "Immobilizer communication" (with Engine Management System unit for immobilizer release),• "ESCL control", • "Authentication ... ComponentLanguage 2010 > G 1.6 DOHC > Body Electrical System Removal1. Disconnect the negative (-) battery terminal.2. Remove the crash pad lower panel (A). (Refer to...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Fuses And Relays
... relay, Rear heater relay, Trunk lid relay (Built-in-Junction box)2. Door unlock relay, Door lock relay, Front deicer relay, Hazard relay (Built-in-ICM relay Box) 2010 > G 1.6 DOHC > Body ... in the I/P-G and the No.2 or 4 terminal in the I/P-F when power and ground are connected to the No.3 terminal in the I/P-G and the No.16 terminal in the I/P-B. 2010 > G 1.6 DOHC > Body...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - General Information
... 2010 > G 1.6 DOHC > Body Electrical System General Troubleshooting InformationBefore Troubleshooting1. ... battery checker (MCR-570 KIT), check the battery for damage, state of charge, and clean and tight connections.(Refer to the Engine Electrical System - Battery)• Do not quick-charge a battery unless ... reconnected, the customer's radio stations become initialized. So, yo...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Head lamp leveling Device
... 2010 > G 1.6 DOHC > Body Electrical System Circuit Diagram 2010 > G 1.6 DOHC > Body Electrical System Removal1. Disconnect the negative (-) battery terminal.2. ... accordance with the head lamp aiming instructions. 2010 > G 1.6 DOHC > Body Electrical System Inspection1. Disconnect the negative (-) battery terminal.2. Remove the lower side crash pad ... (A) from the...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Horn
... 2010 > G 1.6 DOHC > Body Electrical System Component Location1. Horn switch 4. Horn relayLanguage 2. Relay box (Engine room compartment)3. Horn (Low pitch - Single)5. Clock spring 2010 ... Horn (Low pitch - Single)5. Clock spring 2010 > G 1.6 DOHC > Body Electrical System Removal1. Remove the front bumper. (Refer to the Body group - front bumper).2. Remove the bo...
Ngày tải lên: 22/10/2012, 15:55
Shop Manual & ETM BCM KIA Cerato 2010 - Ignition Switch Assembly
... 2010 > G 1.6 DOHC > Body Electrical System Inspection1. Disconnect the ignition switch connector (B) ... If continuity is not specified, replace the switch.Language Removal1. Disconnect the negative (-) battery terminal.2. Remove the steering column upper and lower shrouds (A).3. Remove the key
Ngày tải lên: 22/10/2012, 15:55