... specified conditions of test Referenced Documents Summary of Test Method 2.1 ASTM Standards:2 D56 Test Method for Flash Point by Tag Closed Cup Tester D3941 Test Method for Flash Point by the Equilibrium ... E300 Practice for Sampling Industrial Chemicals E502 Test Method for Selection and Use of ASTM Standards for the Determination of Flash Point...
Ngày tải lên: 20/10/2014, 17:17
... D524 − 10 D4530 Test Method for Determination of Carbon Residue (Micro Method) E1 Specification for ASTM Liquid-in-Glass Thermometers E133 Specification for Distillation Equipment ... 11.1 Calculate the carbon residue of the sample or of the 10 % distillation residue as follows: Carbon residue ~ A 100! /W (1) where: A = mass of carbon residue, g, and W =...
Ngày tải lên: 20/10/2014, 17:17
ASTM D976 06 Standard Test Method for Calculated Cetane Index of Distillate Fuels
... limit for diesel fuels containing less than 500 ppm sulfur The equation for Calculated Cetane Index in Test Method D976 80 and in this version (D976 06) of the test method are the same Equation for ... may not be a valid substitute for ASTM cetane numbers as determined in a test engine FIG Nomograph for Calculated Cetane Index (ECS-1 Meter Basis Test...
Ngày tải lên: 20/10/2014, 17:17
ASTM D2887 Standard Test Method for Boiling Range Distribution of Petroleum Fractions by Gas Chromatography
... The range of results found in the round robin are listed in Table 14.2 Bias—The procedure in Test Method D2887 for determining the boiling range distribution of petroleum fractions by gas chromatography ... bias because the boiling range distribution can only be defined in terms of a test method 14.2.1 A rigorous, theoretical definition of the boilin...
Ngày tải lên: 20/10/2014, 17:18
ASTM D4945 Standard Test Method for HighStrain Dynamic Testing
... Force measurements also are made by force trans2 D 4945 FIG Typical Arrangement for High Strain Dynamic Testing of Piles FIG Schematic Diagram for Apparatus for Dynamic Monitoring of Piles recording, ... 106 psi) for steel The dynamic modulus of elasticity for concrete and wood piles may be estimated by measurement during the compression test in accordance with Test Met...
Ngày tải lên: 12/11/2015, 14:13
WET TESTING OF TEXTILE MATERIALS
... ISO-105-X12 the wet pickup of the rubbing cloth is 100% While in AATCC08 the wet Pickup of the rubbing cloth is 65%.We check rubbing by Dry and Wet methods In wet rubbing we wet the rubbing cloth ... resistance of color to fade or bleed of a dyed or printed textile materials to various types of influences e.g water, light, rubbing, washing, perspiration etc to which th...
Ngày tải lên: 26/07/2015, 22:37
Báo cáo hóa học: " Comparison of four different methods for reliability evaluation of ecotoxicity data: a case study of non-standard test data used in environmental risk assessments of pharmaceutical substances" pdf
... this article as: Ågerstrand et al.: Comparison of four different methods for reliability evaluation of ecotoxicity data: a case study of non-standard test data used in environmental risk assessments ... overall aim of this study was to investigate if the reliability of non-standard ecotoxicity data can be evaluated systematically i...
Ngày tải lên: 21/06/2014, 03:20
Tài liệu Standard Test Method forPour Point of Petroleum Products1 ppt
... limitations of the pour point test, various pumpability tests have been devised to assess the low-temperature flow characteristics of heavy residual fuel oils Test Method D 3245 is one such method ... “fluid at the temperature of the test if it will flow mm in in a 12.5 mm U-tube under a maximum pressure of 152 mm of mercury X1.4 Summary of Test Method X1.4.1 A sample...
Ngày tải lên: 19/02/2014, 20:20
Standard Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens)
... a water -cement ratio of 0.485 for all portland cements and 0.460 for all air-entraining portland cements The amount of mixing water for other than portland and air-entraining portland cements ... temperature before use 10 Procedure 10.1 Composition of Mortars: 10.1.1 The proportions of materials for the standard mortar shall be one part of cement to 2.75 parts of gr...
Ngày tải lên: 26/03/2014, 21:55
Báo cáo hóa học: "Case-Control study of Firefighters with documented positive tuberculin skin test results using Quantiferon-TB testing in comparison with Firefighters with negative tuberculin skin test results" potx
... specific testing protocol, by health personnel trained in proper Mantoux intradermal injection techniques, and with objective reading of the skin test results by a trained observer All positive ... tuberculin as the TB antigen As this occurred in the middle of our data collection, we elected to continue to use the initial QFT kits Tuberculin Skin Testing (TBST) us...
Ngày tải lên: 20/06/2014, 00:20
Happy About Global Software Test Automation Book Excerpt A Discussion of Software Testing for Executives phần 1 potx
... (http://www.happyabout.info/globalswtestautomation.php) Happy About Global Software Test Automation can be purchased as an eBook for $11 .95 or tradebook for $19 .95 at: http://www.happyabout.info/globalswtestautomation.php or at other online and ... Michael Hackett and Brent K Whitlock • Getting the book and other books from Happy About Getting Happy About Global So...
Ngày tải lên: 12/08/2014, 19:20
Happy About Global Software Test Automation Book Excerpt A Discussion of Software Testing for Executives phần 2 ppt
... Global Software Test Automation Nguyen is also a director of two non-profit organizations, the Association for Software Testing, an organization dedicated to improving the practice of software testing ... corporation headquartered in Foster City, California Happy About Global Software Test Automation 13 About TestArchitect™ TestArchitect provides a power...
Ngày tải lên: 12/08/2014, 19:20
ASTM D5453 Standard Test Method for Determination of Total Sulfur in Light Hydrocarbons, Spark Ignition Engine Fuel, Diesel Engine Fuel, and Engine Oil by Ultraviolet Fluorescence
... any item mentioned in this standard Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are ... 15.2 Bias—The bias of this test method was determined in a 1992 research report (RR:D02-1307)4 by analysis of standard reference materials (SRMs) containing known le...
Ngày tải lên: 20/10/2014, 17:16
ASTM D86 Standard Test Method for Distillation of Petroleum Products at Atmospheric Pressure
... D5949 Test Method for Pour Point of Petroleum Products (Automatic Pressure Pulsing Method) D5950 Test Method for Pour Point of Petroleum Products (Automatic Tilt Method) D5985 Test Method for Pour ... and use of borosilicate and quartz distillation flasks 14 Keywords 14.1 batch distillation; distillates; distillation; laboratory distillation; petroleum...
Ngày tải lên: 20/10/2014, 17:17