WET TESTING OF TEXTILE MATERIALS

... ISO-105-X12 the wet pickup of the rubbing cloth is 100% While in AATCC08 the wet Pickup of the rubbing cloth is 65%.We check rubbing by Dry and Wet methods In wet rubbing we wet the rubbing cloth ... resistance of color to fade or bleed of a dyed or printed textile materials to various types of influences e.g water, light, rubbing, washing, perspiration etc to which th...

Ngày tải lên: 26/07/2015, 22:37

... Application of Gibson and Coyle’s model for pile load tests in Bed (B1 /1/ CRP-0. 01 and B1/4/STN -15 ) Figure 6 .11 Application of Randolph and Deeks’ model for pile load tests in Bed (B1 /1/ CRP-0. 01 and B1/4/STN -15 ) ... of 0.01mm/s and the maintained pile load test (B2 /12 /CRP-0. 01 and B2 /13 /MLT) Figure 6 .10 9 Load-settlement curves for the maintained pile load tests (...

Ngày tải lên: 07/11/2012, 10:44

... 10.6 26 9.4 0 .28 3h -23 /8/04 22 B3 /22 /MLT MLT 28 0 4. 82 72. 61 9.5 27 0.5 0 .27 25 ,26 /8/04 23 B3 /23 /MLT MLT 28 0 4. 82 72. 61 9 .2 270.8 0 .27 27 / 12/ 8/04 Bed B4/1/CRP-0.01 CRP 28 0 0.01 3. 72- 3.6 56.04 13.3 26 6.7 ... 1.4 2. 5 2. 28 2. 28 10h -2/ 12/ 03 Date of test rate load pulse (kPa) mm/s (kN) (ms) 28 0 0.01 CRP 28 0 100 125 4.5 2. 2 2. 5 2. 53 2. 34 4...

Ngày tải lên: 07/11/2012, 10:44

... tank and a microfiltration membrane as separation apparatus The aeration tank was made from Plexiglas with a working volume of liters Air was supplied to the aeration tank through diffusers at a ... quality, and kinetic parameters were also investigated PERMEATE COMPRESSED AIR INFLUENT AIR SLUDGE WASTE Fig Schematic Diagram of the Coupling of Activated Sludge Proces...

Ngày tải lên: 05/09/2013, 09:08

... RESULTS AND DISCUSSION Dye decolorization Dye decolorizing efficiency by digested sludge The potential of digested sludge on MO and RB4 tested by variation of dye concentration was shown by the ... Journal of Water and Environment Technology, Vol 6, No.1, 2008 Dye decolorization Dye decolorizing efficiency by digested sludge To reveal the decolorizing...

Ngày tải lên: 05/09/2013, 09:38

... to machine hardened materials up to 65 HRC, also for high-speed cutting Cermet (solid titanium carbide) works well for continuous cutting of case-hardened materials Machining of Hard Materials ... and (b) complete machining of a gear in the hardened state Machining of Hard Materials 105 ing allowance of 20–30 μm remains for finishing grinding at the extremely high...

Ngày tải lên: 18/10/2013, 03:15

... Performance Testing of Permanent Links and Channels Testing of telecommunications Permanent Links and Channels to determine performance compliance to Class D ... configuration of the Permanent Link and Channel is shown below Measurement Permanent Link 90m max CP FD Measurement Channel 100m max Field Performance Testing V10 050111 Page of TO Passive Testing...

Ngày tải lên: 26/10/2013, 19:15

... Performance Testing of Permanent Links and Channels Testing of telecommunications Permanent Links and Channels to determine performance compliance to Class D (using Cat components) and Class ... to PL testing Channel testing still uses the Vendor’s patch cords, which are to be left in situ after testing The configuration of the Permanent Link and Chann...

Ngày tải lên: 27/10/2013, 17:15

... looks focused on the quasistatic rheology of a granular system, so why is all of this related to the description of its statics? As a matter of fact, the static properties of the studied sample are ... a series of captors), and are thus much noisier 250 Static properties of granular materials F r p h z Fig 14.13 Sketch of the experimental set-up of Reydellet e...

Ngày tải lên: 01/11/2013, 08:20

... in the literature when the areas of 222 The thermodynamics of granular materials the grains, rather than the quadrons, were taken as the fundamental particles of the system At present we know of ... 210 The thermodynamics of granular materials orifice into a cylinder and changes to a uniform source when the edges of the pile reaches the cylinder...

Ngày tải lên: 01/11/2013, 08:20

... Method C of TIA/EIA 52 6-1 4-A OF Testing ADC KRONE Requirements V7_1&3T Dr2Page of 12 1-Test Cord Method of Reference Setting = Cl 9.1.2 of ISO/ IEC 1476 3-3 Ed2 Similar to Method of IEC 6128 0-4 -1 Similar ... Planning in ISO/ IEC 1476 3-3 Annex E (Informative) of ISO/ IEC 1476 3-3 sets out the Stages available for OF testing For an ADC KRONE Warran...

Ngày tải lên: 10/12/2013, 02:15

... Performance Testing of Permanent Links and Channels There are distinct areas of cable testing; Certification, Qualification and Verification Certification is the most rigorous of all cable testing ... America) Field Performance Testing V15 060508 Page of 11 Passive Testing With Hand-Held Field Testers There are currently three levels of hand-held field tes...

Ngày tải lên: 12/12/2013, 12:15