Electric Circuits, 9th Edition P49 docx

... opera- tional transform pairs are summarized in Table 12.2. (See page 437.) In linear lumped-parameter circuits, F(s) is a rational function of s. (See page 444.) If F(s) is a proper rational function,

Ngày tải lên: 06/07/2014, 16:20

... identical electrical components. For example, resistors produced from the same manufacturing process can vary in value by as much as 20%. Therefore, in creating an electrical ... instrumentation systems are good examples because in the transmission of information, or data, via electric signals, the power available at the transmitter or detector is limited. Thus, transm...

Ngày tải lên: 06/07/2014, 16:20

... with electric fields. The source of the electric field is separation of charge, or voltage. If the voltage is varying with time, the electric field is varying with time. A time-varying electric ... capacitor is an electrical component that consists of two conductors separated by an insulator or dielectric material. The capacitor is the only device other than a battery that can...

Ngày tải lên: 06/07/2014, 16:20

... portions of the system. In power circuits, transformers are used to estab- lish ac voltage levels that facilitate the transmission, distribution, and con- sumption of electrical power. A knowledge ... finding the Thevenin equivalent voltage and impedance are identical to those used for resistive circuits, except that the frequency-domain equivalent circuit involves the manipulation of c...

Ngày tải lên: 06/07/2014, 16:20

... or decrease voltages from a source to a load. Thus, ideal transformers are used widely in the electric utility industry, where it is desirable to decrease, or step down, the voltage level at

Ngày tải lên: 06/07/2014, 16:20

... low-voltage appliances (such as televisions) and higher voltage appliances (such as electric ranges). Appliances such as electric lamps, irons, and toasters all carry rms ratings on their nameplates. ... volt-amps. The apparent power, or volt-amp, requirement of a device designed to convert electric energy to a nonelectric form is more important than the average power requirement. Al...

Ngày tải lên: 06/07/2014, 16:20

... acting alone. The Use of Superposition Because we are analyzing linear lumped-parameter circuits, we can use superposition to divide the response into components that can be identi- fied

Ngày tải lên: 06/07/2014, 16:20

Ngày tải lên: 06/07/2014, 16:20

... circuit whose transfer function has a Butterworth polynomial in its denominator by cascading op amp circuits, each of which provides one of the needed factors. A block diagram of such a cascade

Ngày tải lên: 06/07/2014, 16:20

... resistor-capacitor (RC) circuits, 220-224,231-236,246, 472-473 resistor-inductor (RL) circuits, 214-220,231-236,246 resistor-inductor-capacitor (RLC) circuits, 266-279 series RLC circuits, 285-289 ... (RL) circuits, 212,214-220,224-228, 236-238,246 resistor-inductor-capacitor (RLC) circuits, 264-305, 473^175 second-order circuits, 264-305 sequential switching, 236-240,...

Ngày tải lên: 06/07/2014, 16:20