study of host pmp3p in agrobacterium mediated transformation of yeast

... function of magnetic field cycling 2.6 Brillouin Light Scattering The underlying principle of BLS is based on an inelastic scattering interaction between an incoming photon (a laser source) and a spin ... circular rings This understanding is useful in providing model structure to study DWs pinning and propagation, spin wave confinement and the effect of shape anisotropy on dynamic behavior of ring arrays ... investigation and comparison of rings’ behavior as a function of their dimension, geometry and inter-ring spacing is helpful in the development of DW logic and memory devices, also in designing...

Ngày tải lên: 09/09/2015, 11:20

... Effect of doping gas concentration on film conductivity and crystallinity 53 3.3 Integration of doped thin-film layers in device precursors 60 3.3.1 Investigation of doped film on intrinsic ... spectrum of the p-doped silicon film is observed to shift towards 520 cm-1 with increasing thickness, indicating increasing crystallinity 48 Figure 3.8 Impact of p-doped silicon thin-film ... crystalline counterpart, the conduction / valence band offsets of the doped and intrinsic silicon thin films with respect to the crystalline silicon substrate is of interest The valence band discontinuity...

Ngày tải lên: 09/09/2015, 11:15

... still permeates in the direction of fresh water into the salty water [6,49] The flow of the incoming water will increase the volume and thus pressure of the salty water, offering the opportunity ... Illustration of a continuous flat-sheet membrane casting process 71  Figure 3.6 Schematic diagram of hollow fiber spinning line 72  Figure 3.7 Schematic diagram of area nearby the spinneret and ... against the porous support layer (FO mode) 24  Figure 2.8 Illustration of the membrane fouling in FO process under different operating mode, (A) fouling in PRO mode, and (B) fouling in...

Ngày tải lên: 10/09/2015, 09:02

... adjusts the terminal voltage accordingly to reduce the ripple, improving the energy stability of the beam In the event of a tank spark, the corona/spark interlock will trigger a warning on the control ... respectively This facilitates the proper steering and focusing of the beam before it enters the switching magnet to be steered into one of the beamlines ... atoms are excited into oscillation by the RF field, quickly gaining enough kinetic energy to cause ionization and forming a plasma Positive ions from the plasma are pushed out of the source by...

Ngày tải lên: 14/09/2015, 08:44

... During the insertion of the sample into the main chamber, the sample holder containing the target is placed onto the transfer rod within the load lock with all valves except V2 closed The insertion ... distribution of backscattered ions at fixed intervals of length along the MCP-FPD The energy spectrum is subsequently obtained by processing the position spectrum, using a forward-binning process, ... chamber through the main viewport A UHV vacuum of < × 10−9 mbar is maintained by a Mitsubishi FT-800WH turbomolecular pump (TMP) in main chamber (TMP 1) and a Mitsubishi PT-50 TMP in the MCP-FPD chamber...

Ngày tải lên: 14/09/2015, 08:44

... the re-binning and the combining of the position spectrum windows Once the scattering angle, incident beam energy as well as an elemental surface edge position in one of the windows are defined, ... reverse-binning process required in the next section The Mathematica code FORBIN was written to duplicate the calibration, combining, rebinning and fragment scaling processes of two position windows into ... boundaries, in terms of position channels, of the energy channels in each window i They have the same starting and ending point as the half-integral boundaries of the real position channels in the...

Ngày tải lên: 14/09/2015, 08:44

... incident backscattered ion according to their position of incidence The non-linear energy-analyzing process of the spectrometer determines the position of incidence of each backscattered ion along ... profiling in certain situations, only HRBS allows for quantitative depth analysis of ultra-thin films in a non-destructive manner, providing accurate elemental and substrate lattice strain profiles ... University of Singapore (NUS) [20] was installed in 2004, receiving ion beams of high brightness and stability from a 3.5 MV Singletron Accelerator Elemental depth profiles of ultra-thin Lu2O3/Si...

Ngày tải lên: 14/09/2015, 08:44

... install the package “BaseWin” before installing any application Existing RM2000/GP20000 installation should be uninstalled and replaced by the Basic installation and the single installation of ... Reinforcement Concrete Design Number of iteration for “Ultimate Load Check” increased to 100 Printing of plot files improved for original scaling 3.96 Version 8.29.03 • • Result plot for spring ... superposition files Correction of join results in “DoList” for load cases Additional options in PLSYS for representing of stresses (FIBSUP) Minor improvements in lists and optimisation 3.58 Version...

Ngày tải lên: 06/09/2012, 15:18

... connection point in the “Connection Point window” Define the 2nd Connection Point Select “CP1” (located at the LH bearing posn ) for the connection point in the “Connection Point window” Constants ... Connection Points Cross-Section Reference Point Group Define the Connection Points Define the Connection between Top of Spring Support (Spring 1100) and Ground Select Reference Point Group and insert ... segment point for the spring connection “Station ‘0’ for example Select Connection Choose “Insert” in the new input window Spring-0 LH Window – Segment Point Part Check/modify the segment point and...

Ngày tải lên: 06/09/2012, 15:55

... Length in feet Moments in kipft Force in kips Length in inches Moments in kipins Stress in kN/m2 (kPa) Stress in MN/m2 (MPa) Stress in Kips/ft2 (ksf) Stress in Kips /in2 (ksi) Another reason for using ... take this into account when interpreting the results Typical consistent input/output units would be: Force in kN, Length in m Moments in kNm Force in MN Length in m Moments in MNm Force in kips ... 3-15 Definition of the Reinforcement (Reinforcement Points) 3-19 Definition of Stress Evaluation Points 3-23 Definition of a Temperature Distribution (Temperature points) ...

Ngày tải lên: 06/09/2012, 15:55

... cursor location is indicated in the lower right-hand corner of the interface A frame line should appear in both views (plan and 3D) After clicking to define the end point of the frame object, ... the two joints marking the left ends of the two bottom chords The lower left-hand corner of the interface should indicate “2 Points selected” E Click on the Assign menu > Joint > Restraints command ... middle joint on the top chord object in Figure 33 to display the Joint Displacements results form shown in Figure 34 Figure 34 Joint Displacements obtained by rightclicking a joint shown in the...

Ngày tải lên: 06/09/2012, 15:56

Ngày tải lên: 17/09/2012, 09:13

... according to a double-blind protocol [3, 7] The purpose of the present study was to examine the effects of these regimens on recurrence of stroke So, the primary endpoint was occurrence of stroke ... randomized, double-blind, controlled trial of two different intensities of warfarin treatment on the prevention of recurrent thrombotic events in patients with APS The high-intensity warfarin treatment ... than moderate-intensity treatment in preventing recurrent thrombotic events The APASS study [3] was the first prospective study of the role of aPL in recurrent ischemic stroke, in collaboration...

Ngày tải lên: 26/10/2012, 09:48

... air gap with a minimum of cm The role of this layer is to prevent heat getting into the building in summer and take moisture out of the building In this ventilated gap the aluminum substructure ... one of the more affecting factors to increase the efficiency of the façade is the external air temperature The presence of ventilated façade in a building leads to a cooling effect in the skin of ... Miguel Mora Pérez M.Sc .in Industrial Engineering, Master in Energy Technology for Sustainable Development and Research Engineer in the Department of Hydraulic Engineering (Universidad Politécnica...

Ngày tải lên: 05/09/2013, 14:58

... ALSTRINC to account for the 1/3 allowable increase for the wind and seismic load 1.0D + 1.0L 1.0D + 1.0L + 1.0W 1.0D + 1.0L + 1.0E • PARAMETER $ ALSTRINC based on the % increase • ALSTRINC 33.333 ... 2-24 • A529 Gr 42 of ASD, not available in LRFD • A529 Gr 50 and 55 are new in LRFD • A441 not available in LRFD • A572 Gr 55 is new in LRFD • A618 Gr I, II, & III are new in LRFD • A913 Gr 50, ... Combinations • 1.0D + 1.0L • 0.75D + 0.75L + 0.75W • 0.75D + 0.75L + 0.75E D L W E = = = = dead load live load wind load earthquake load ASD Load Combinations Or you can use following load combinations...

Ngày tải lên: 12/12/2013, 20:15

... of the study Part I: Introduction Reasons for choosing the topic Aims of the study Scope of the study Methods of the study Design of the study Part II: Contents Chapter 1: Theoretical preliminaries ... (greeting of a speaker) Welcome to Vinh city 1.1.2 Indirect greeting expressions In English, there are a lot of indirect greeting expressions There are some ways of forming indirect greeting expressions ... expressions which include the verbs of greeting like greet, welcome are often used in writing, or informal situations For examples: I greet him by saying good morning (in writing) Greetings Ladies...

Ngày tải lên: 24/12/2013, 09:36

... Calculation of Nonlinear Forces 18-4 Transformation to Modal Coordinates 18-5 Solution of Nonlinear Modal Equations 18-7 Static Nonlinear Analysis of Frame Structure 18-9 Dynamic Nonlinear Analysis of ... B Internal Virtual Work f d Figure 3.1 Method of Virtual Forces The principle of virtual forces states (in my words) if a set of infinitesimal external forces, R , in equilibrium with a set of ... forces in the deformed structure In the case of finite element analysis of continuous solids, the virtual work principles are applied at the level of stresses and strains; therefore, integration...

Ngày tải lên: 12/01/2014, 21:45

... động đai hay đăng Đối với chi có tải trọng động nhỏ, tốc độ làm việc phân cấp cân cao (Vd: Turbines, turbochargers, dao phay gỗ,…) Phải sử dụng máy cân dẫn động đai Đối với chi tiết có tải trọng...

Ngày tải lên: 21/01/2014, 13:20

... characteristics of the Internet—number of nodes and links, and average degree of the Internet (a) and (b): The number of nodes/links is increasing quadratically (c): In most time-step based Internet ... average degree of the Internet has been changing frequently 67% of new nodes are introduced with single links and 31% of new nodes are introduced with two links Only 2% of new nodes are introduced ... characteristics of the Internet—average degree, creation of nodes and links, and death of nodes and links; (a): mn and me denotes the number of nodes and links added since November, 1997 In general, 1.36 links...

Ngày tải lên: 18/02/2014, 01:20

... starting from roots of successful context-free derivations In phase 2, it then eliminates invalid parse trees by using constraints in the given grammar We call the remaining edges that are used ... We are going to integrate the advantage of the CF approximation of HPSG into that of LTAG in order to establish another CFG filtering for LTAG We will also conduct experiments on trade-offs between ... Tsujii 2001 Efficient LTAG parsing using HPSG parsers In Proc of PACLING, pages 342–351 D H Younger 1967 Recognition and parsing of context-free languages in time n3 Information and Control, 2(10):189–208,...

Ngày tải lên: 08/03/2014, 04:22