simulation results using field ii

... Simulation results 6.1 Intensity considerations 6.2 Expected signal-to-noise ratio improvement 6.3 Imaging with linear FM signals- Simulation results using Field ... can be used for increasing the frame rate The work includes both simulated results using Field II, and experimental results based on measurements on phantoms as well as clinical images Initially ... Frank code 68 6.1 Simulation results on the expected SNR improvement from coded excitation for four different coded signals using Field II There is no ultrasonic attenuation...

Ngày tải lên: 24/08/2014, 17:52

... Software Project Cost Estimates Using COCOMO II Model Free source co Page of 12 In practice, COCOMO parameters can be greatly different from its typical values COCOMO II provides classification of ... CodeProject: Software Project Cost Estimates Using COCOMO II Model Free source co Page of 12 Now, I will demonstrate basic estimation steps in COCOMO II model To make actual estimates, I ll use ... http://www.codeproject.com/KB/architecture/cocomo2.aspx 11/14/2009 CodeProject: Software Project Cost Estimates Using COCOMO II Model Free source co Page of 12 COCOMO generally recommends using standard SLOC counting programs that can perform line...

Ngày tải lên: 13/05/2014, 21:47

... populations [9] The aims of this study are to: 1) compare QFT results to TBST results in a population where a high incidence of positive LTBI results are present; and 2) determine if MA is a confounder ... based on an equal distribution of observations Results did not differ from what has been recorded above Table 1: × Table Comparing TBST Results to QFT Results QFT+ (QFT-Cond+) TBST+ (Subjects) TBST- ... Arizona Department of Health that the TBST results were false positives6 The lower rate of positivity using QFT, even including conditionally positive results, indicates that there should be less...

Ngày tải lên: 20/06/2014, 00:20

... either i meets infinity in Σ, or ii meets μ, where μ / μ ∈ σ L , or iii contains a pair of points λ, u , λ, −u , u / o1, w 1.8 o |α| at α The following are global results for 1.7 on bifurcation ... following conditions: Let X m−2 i m−2 i i u 0, νu > and u / 0; ii u has only simple zeros in 0, , and has exactly k − such zeros; iii u has a zero strictly between each two consecutive zeros of ... − π, kπ , so k −→ ∞ ; 2.10 ii the characteristic value of L is exactly given by μk s2 , k 1, 2, , and the eigenfunction k cos sk t; φk corresponding to μk is φk t iii the algebraic multiplicity...

Ngày tải lên: 21/06/2014, 20:20

... red luminescent peaks at 592.0 and 613.0 nm, which is attributed to 5D0–7F0–1 transitions of Eu(III) ion, by excitation at 342.0 nm However, the emission strength of silver hollow sphere solution ... characterized by UV–Vis spectroscopy and fluorescence spectroscopy Synthesis of Rare-earth Complexes Results and Discussions Eu(TTA)3 Á 2H2O (HTTA: trifluorothenoyl-acetone) were synthesized according ... purification procedure was repeated for three times Morphology and size of the sample was obtained by using TEM, scanning electron microscopy (SEM), and scanning near-field optical microscopy (SNOM)...

Ngày tải lên: 21/06/2014, 22:20

... to Nios II Processor and Cyclone II FPGA 100 Means of Implementing Photo Frame Application Using uCLinux 101 Design of Application Software .102 Porting Application to Nios II processor ... © 2009 Bhavya Daya ii To: God for granting me patience My mom, dad and brother for their unwavering support iii ACKNOWLEDGEMENTS I would like to thank my supervisor, ... JTAG Programming of Cyclone II FPGA 78 Figure 19: Active Serial Programming of Cyclone II FPGA 79 Figure 20: Cyclone FPGAs 80 Figure 21: Nios II Processor Core ...

Ngày tải lên: 27/06/2014, 00:20

... assignments 11.4.2 Using Feedback Mechanisms 11.4.3 Moore Machines 11.4.4 Mealy Machines 431 433 436 440 441 xiii 11.5 Hierarchical Projects 11.5.1 Max+Plus II Primitives 11.5.2 Max+Plus II Macrofunctions ... DIGITAL SYSTEMS DESIGN AND PROTOTYPING Using Field Programmable Logic and Hardware Description Languages Second Edition Digital Systems Design and Prototyping: Using Field Programmable Logic and Hardware ... Hierarchical Project Using Altera-provided Functions 199 5.5 Creating and Using Custom Functions in AHDL 5.5.1 Creation of Custom Functions 5.5.2 In-line References to Custom Functions 5.5.3 Using Instances...

Ngày tải lên: 27/06/2014, 07:20

... the creation of SAPS III The SAPS III appears very promising, and is more recent and sophisticated than SAPS II Nevertheless, for historical comparisons the expanded SAPS II can easily be obtained ... 0.0844 × (expanded SAPS II) + 6.6158 × log(expanded SAPS II + 1) Table Uniformity of fit of the three SAPS II models in the validation sample Variable With the customized SAPS II model calibration ... (nearly 20 years for Acute Physiology and Chronic Health Evaluation [APACHE] II [16] and 10 for SAPS II [4] and APACHE III [17]) To improve the performance of available scoring systems, two methods...

Ngày tải lên: 12/08/2014, 23:20

... previously [30,31] The inclusion criterion was the simulation of manifestation profiles using pattern descriptions from the ZFSP dataset In both simulations, we Sá Ferreira Chinese Medicine 2011, ... are presented in the additional files and 3, respectively Results Study flowchart and simulation quality The flowchart describing the simulation study is presented in Figure One hundred of 7300 ... the exact number of simulations needed in stochastic simulation studies, it is considered that this number should increase with the amount of information of patterns to reduce simulation variability...

Ngày tải lên: 13/08/2014, 14:20

... illustrated in Figure Figure Field ammonia sensing device calibration using FS Applications and discussion The system software was developed in the Microsoft environment using Java comprising several ... monitoring system using field monitoring servers Proc AFITA2004 Hirafuji, M and S Ninomiya 2003 Agricultural IT strategy and R&D projects in Japan Proc SAITA2003 Pimpunchat N 2004 Field Server Project ... manual management systems, and by the development of software for manipulation and control Field Servers Field server (FS) is a famous WMSNs example (Hirafuji and Ninomiya, 2003; Fukatsu, et al.,...

Ngày tải lên: 14/04/2015, 13:20

... indentation using ABAQUS with the cohesive zone model Chapter discusses the simulation results and the main factors affecting the simulation and the simulated results are compared with experimental results ... and delamination processes This thesis also compared the FEM simulation results with the nanoindentation experimental results obtained using two wedge indenters having 90o and 120o inclusion angles ... δ tip ) ⎢ ⎥ ⎣ ⎦ (2.24) 18 Fig 2-4 A schematic of a Mode III crack containing a cohesive zone ahead of the crack tip [17] For the Mode III crack, the von Mises effective stress in the cohesive...

Ngày tải lên: 26/09/2015, 09:56

... iii TABLE OF CONTENT DECLARATION PAGE .II ACKNOWLEDGEMENTS III TABLE OF CONTENT IV SUMMARY VI LIST OF TABLES VIII ... model VIII Table 6: Results of the implant position for all spines XXIV Table 7: Data Preparation and compilation (Log Transformed Data) to SPSS format XXXVII viii List of Figures ... design & respectively XII Figure 73: Design of follower load guides that was fabricated on a lumbar spine model using Solidworks XIII Figure 74: Detailed drawings of follower...

Ngày tải lên: 02/10/2015, 17:14

... Growth 19 Chapter Cathode Growth Simulation 3.1 Simulation 25 3.1.2 Simulation parameters 26 3.2 Simulation results 33 3.2.1 Simulation of emitted rays 33 ii 3.2.2 Simulation of W ions 3.3 Summary ... Experimental Results 61 5.2 Anode Growth 68 5.3 Simulation Of Anode Growth 72 5.3.1 Simulation set up 73 5.3.2 Simulation results 74 5.4 TEM Imaging Of Anode Growth 77 5.5 Summary 80 iii Chapter ... deposition patterned using lift-off (b) (ii) Deposition of Parylene and Au patterned using lift-off (b)(iii) Etching of Parylene layer (b)(iv) Assembly of Au nanoparticles using dielectrophoresis...

Ngày tải lên: 08/11/2015, 16:38

... experimental results for determination of stator inductance variation The interpolation part is calculated, as shown in Example The function implementing the field weakening functionality, FieldWeakening, ... experimental results in Figure show high stability and proper trajectory of the speed control with field weakening  2008 Microchip Technology Inc DS01206A-page 11 AN1206 FIGURE 9: EXPERIMENTAL RESULTS ... REFERENCES This application note presents a solution for implementing field weakening in a sensorless field oriented control of an ACIM using Microchip’s dsPIC30F and dsPIC33F digital signal controllers...

Ngày tải lên: 11/01/2016, 17:01

... Circuit Modeling Using Electromagnetic Field Simulation Field- solver results Field- solver results Figure 2.13 Substituting field- solver results into the original solution scheme mixes field- theory ... Analysis Using Closed Box MoM 283 283 290 291 xii Microwave Circuit Modeling Using Electromagnetic Field Simulation 0.00013.2.2 Analysis Using Laterally Open MoM 0.00013.2.3 Analysis Using 3D ... Modeling Using Electromagnetic Field Simulation For a complete listing of the Artech House Microwave Library, turn to the back of this book Microwave Circuit Modeling Using Electromagnetic Field Simulation...

Ngày tải lên: 04/07/2014, 05:48

... obtained from the numerical simulation is analyzed from the theoretical perspective iv Contents Acknowledgements ii Abstract iii List of Tables vii List of Figures viii Introduction 1.1 The phase ... flat solid substrate derived from the Young’s relation by Borcia During the simulation, we find that this analytical iii iii Abstract Abstract relation between the static contact angle and the wettability ... center and water will be attracted to the walls at equilibrium state 37 viii viii LIST OF FIGURES 3.4 LIST OF FIGURES Evolution of the isosurface of ρ = 0.5 A stable droplet...

Ngày tải lên: 27/11/2015, 11:12

... with a lot of information not only in the project but also in the outside We were very happy III/ RESULTS Our questionnaire designed an interview of 25 questions and divided into 10 main topics: ... From accommodation facilities to extra comments • Discussion • Recommendations • Edit and print II/ INTERVIEW QUESTIONS According to the purpose of the report, we had to go out to carry out our ... talk with foreigners, obtaining information by designing, asking questions and analyzing their results in a short report? So that, it is very interesting with the student because it helps student...

Ngày tải lên: 25/04/2013, 15:42

... calculate req with the result from the simulations using the U-pipe model (Mu) Notice that when using constant heat flux at the pipe wall, the calculated req results in the same cross-section area ... temperature difference between the U-pipe wall and borehole wall for simulations Mu1-Mu6 (cTpw) and simulations Mu7-Mu12 (cq"pw) Notice that simulations Mu1 and Mu7 and so on simulate the same basic condition: ... are achieved Using constant temperature at the pipe wall results in peanut-shaped isotherms around the pipe legs, and this un-radial heat pattern is transferred far out in the bedrock Using a constant...

Ngày tải lên: 05/09/2013, 14:58

... Quartus II - Summary Design Entry using Verilog – An example module light(x1,x2,f); input x1,x2; output f; assign f = (x1&~x2)|(~x1&x2); endmodule Design Entry using Verilog – Quartus II Text ... Design Entry using Verilog – Quartus II Text Editor (6 of 6) We can change the options of Text Editor of Quartus II by the settings in Tools > Options > Text Editor Design Entry using Verilog ... right figure, then choose Verilog HDL File, and click OK Design Entry using Verilog – Quartus II Text Editor (2 of 6) Quartus II open the Text Window Editor The default name of design file is Verilog1.v...

Ngày tải lên: 06/11/2013, 03:15