installation requirements for safesuite
A research proposal submitted in partial fulfillment of the requirements for the degree of Master of Business Administration
Ngày tải lên :
13/04/2013, 10:30
... business formula used in this industry There are criteria used to define a supermarket: the minimum size requirements, the characteristics and extent of self-service, and the stock requirements ... consumers look to for purchasing advice? Does this differ by good or service category? How can the retailer appeal to opinion leaders? Social performance - Are customers high or low performers? How ... two week (table 4.1) Here respondents not counted for shopping for everyday fresh food Once per two week was the most frequent trip which counted for more than one-quarter of the sample The shopping...
51
1K
3
BUILDING CODE REQUIREMENTS FOR STRUCTURAL CONCRETE (ACI 318-99) AND COMMENTARY
Ngày tải lên :
03/08/2013, 11:24
... profile Deformed reinforcement — Deformed reinforcing bars, bar mats, deformed wire, welded plain wire fabric, and welded deformed wire fabric conforming to 3.5.3 Deformed reinforcement — Deformed ... only for spiral reinforcement (either as lateral reinforcement for compression members, for torsion members, or for confining reinforcement for splices) 3.5.4.2 — Plain wire for spiral reinforcement ... mats for concrete reinforcement shall conform to “Specification for Fabricated Deformed Steel Bar Mats for Concrete Reinforcement” (ASTM A 184) Reinforcing bars used in bar mats shall conform...
1.3K
1.8K
16
Requirements for the Generic Bus Driver Model
Ngày tải lên :
07/10/2013, 00:20
... installed on the platform Problems with this method are: • Detection methods used by drivers might conflict with hardware already installed on the platform For example, if a platform has a drill ... load a driver for a function not currently attached to the bus Figure Generic bus driver model when two functions are contained in one device Bus Driver and Device Requirements for a Generic ... meet the requirements of discoverability and multiplexability • Discoverable - If special information is required in descriptors to group interfaces into functions, this is a problem for a generic...
6
326
0
Requirements for entry
Ngày tải lên :
01/11/2013, 09:20
... staff, or care for an elderly or disabled relative, you should come away with a clear and realistic perspective of what illness can mean for patient and for doctor For more information on volunteering ... perseverance are part of the same package They feed on dual enthusiasm for science and for the healing art of medicine 29 Requirements for entry They are inspired by curiosity and enriched by sparks ... medicine patients For a female accident and emergency consultant, to also be the medical officer for a well-known football club (not that she is a great player) is good for her and for her hospital...
22
270
0
Tài liệu Cabling Standard - TIA 607 - Commercial Building Grounding and Bonding Requirements for Telecommu doc
Ngày tải lên :
10/12/2013, 02:15
... 606 for additional labeling requirements Bonding Conductors for Telecommunications Quang Dung Technology Distribution Company Page of ANSI/TIA/EIA 607 Commercial Building Grounding and Bonding Requirements ... Bonding Requirements for Telecommunications Table of Contents OVERVIEW COMPONENTS OF THE TELECOMMUNICATIONS GROUNDING AND BONDING INFRASTRUCTURE Identification Elements Bonding Conductors for Telecommunications ... Bonding Requirements for Telecommunications The Telecommunications Main Grounding Busbar (TMGB) The TMBG serves as: • • the dedicated extension of the building grounding electrode system for the...
7
593
2
Tài liệu Innovative Installation Techniques for Fiber Drop Terminals docx
Ngày tải lên :
10/12/2013, 18:15
... bracket for connecting drop cables By eliminating the need for separate waffle brackets or swing arms, installers save $17 to $25 per installation The single latch removal feature and simple snap installation ... is not available Innovative installation techniques for fiber drop terminals The snap-in/snap-out feature of the universal bracket makes the MST readily available for drop cable connections or ... bracket adapts for all mounting situations, MST installations are accomplished in less time and with reduced complexity It also eliminates the logistics of ensuring brackets are available for each...
4
308
0
Tài liệu Oracle Real Application Clusters: Quick Installation Guide for Oracle Database Standard Edition ppt
Ngày tải lên :
21/12/2013, 04:17
... Administrator Check Software Requirements Check Web Browser Requirements Check Hardware Requirements Oracle Application Server Check Disk Space Requirements Check Network Requirements Configure Disk ... write to them For performance and availability reasons, you should use at least two shared disks for your database files Oracle Application Server Table lists the disk space requirements for Oracle ... databases and monitor database performance Oracle Database Platform Guide for Windows: Contains information specific to managing a database on a Windows platform Oracle Database Administrator's...
50
526
0
iec 60269-2 low-voltage fuses - supplementary requirements for fuses for use by authorized person
Ngày tải lên :
25/12/2013, 10:53
... LOW-VOLTAGE FUSES Part 2: Supplementary requirements for fuses for use by authorized persons (fuses mainly for industrial application) FOREWORD 1) The formal decisions or agreements of the I ... Supplementary Requirements for Fuses for Use by Unskilled Persons (in preparation) 1.1 Scope These supplementary requirements apply to fuses for use by authorized persons Fuses for use by authorized ... Part 1: Second part: - Part 2: General Requirements (Publication 269-1) Supplementary Requirements for Fuses for Use by Authorized Persons (Fuses Mainly for Industrial Application) (Publication...
30
315
3
iec 60269-4-1 low-voltage fuses - supplementary requirements for fuse-links for the protection of
Ngày tải lên :
25/12/2013, 10:54
... – Part 4-1: Supplementary requirements for fuse-links for the protection of semiconductor devices – Sections I to III: Examples of types of standardized fuse-links FOREWORD 1) The IEC (International ... 60269-4: Low-voltage fuses – Part 4: Supplementary requirements for fuse-links for the protection of semiconductor devices and shall comply with the requirements laid down in the relevant sections ... interested National Committees 3) The documents produced have the form of recommendations for international use and are published in the form of standards, technical specifications, technical reports...
42
420
2
iec 60269-4 low-voltage fuses - supplementary requirements for fuse-links for the protection of s
Ngày tải lên :
25/12/2013, 10:55
... (1994) for fusu for use 269-3 (1987) Part 3: Supplmmtay qui-& by unskilled penanr (fusu mainly for hourchdd and similar appiications) 269-3-1 (1994) Part 3-1: Supplementaty requirements for fuses for ... 8.5.5.2 For one of the tests of no and for test no 2a or 5, the recovery voltage shall be maintained at a value of - for a.c., 1O0 O % for fuse-links rated 690 V and higher, and % for other ... 2a and 2b Test arrangements for other kinds of fuse-links are given in IEC 60269-2-1: Supplementary requirements for fuses for use by authorised persons (fuses mainly for industrial application)...
87
404
1
iec 60364-7-707 electrical installations of buildings - requirements for special installations or
Ngày tải lên :
25/12/2013, 11:05
... l'information Electrical installations of buildings `,`,,``,``,,`,``,``,``,``-`-`,,`,,`,`,,` - Part 7: Requirements for special installations or locations Section 707 - Earthing requirements for ... ELECTRICAL INSTALLATIONS OF BUILDINGS Part : Requirements for special installations or locations Section 707 - Earthing `,`,,``,``,,`,``,``,``,``-`-`,,`,,`,`,,` - requirements for the installation ... 364-7-707 O I E C 1984 -7- ELECTRICAL INSTALLATIONS OF BUILDINGS Part : Requirements for special installations or locations Section 707 - Earthing requirements for the installation of data processing...
23
295
4
iec 60439-2 low-voltage switchgear and controlgear assemblies - particular requirements for busba
Ngày tải lên :
25/12/2013, 11:05
... intended for horizontal installation shall be made in accordance with the following test procedures: - for normal mechanical loads: see 8.2.10.1; - for heavy mechanical loads: see 8.2.10.2; - for ... are for information only Busbar trunking systems (busways) shall comply with all requirements of IEC 60439-1, if not otherwise indicated hereinafter and shall also comply with the particular requirements ... less than those specified for basic insulation Clearance values for reinforced insulation are dimensioned to the rated impulse voltage one step higher than those specified for basic insulation Parts...
74
822
14
iec 60439-3 low-voltage switchgear and controlgear assemblies - particular requirements for iow-v
Ngày tải lên :
25/12/2013, 11:06
... standard: IEC 60269-3:1987, Low-voltage fuses - Part 3: Supplementary requirements for fuses for use by unskilled persons (fuses mainly for household and similar applications) IEC 60529:1989, Degrees ... assemblies Part 3: Particular requirements for low-voltage switchgear and controlgear assemblies intended to be installed in places where unskilled persons have access for their use Distribution ... Particular requirements for low-voltage switchgear and controlgear assemblies intended to be installed in places where unskilled persons have access for their use Distribution boards - FOREWORD 1) The...
49
488
4
iec 60439-4 low-voltage switchgear and controlgear assemblies - particular requirements for assem
Ngày tải lên :
25/12/2013, 11:07
... dioxide test for 60076: Power transformers 60309: Plugs, socket-outlets and couplers for industrial purposes 60364-4-41 (1982): Electrical installations of buildings, Part 4: Protection for safety ... enclosures (IP Code) 60742 (1983): Isolating transformers and safety isolating transformers - Requirements 60755 (1983): General requirements for residual current operated protective devices COPYRIGHT ... not forming part of the ACS (see 2.4.2) 2.3.4 Busbar trunking system Not applicable 2.5.1 ASSEMBLYfor indoor installation Not applicable (see 2.1.1.3) 2.5.2 ASSEMBLY outdoor installation for...
56
514
5
iec 60439-5 low-voltage switchgear and controlgear assemblies - particular requirements for assem
Ngày tải lên :
25/12/2013, 11:08
... distribution cabinet for installation on a pole, on which a transformer is normally mounted, in an aerial network The cabinet entries for external conductors are suitable for cables or insulated ... distribution cabinet: A cable distribution cabinet for installation at ground level on a foundation The cabinet entries for external conductors are suitable for cables 2.1.10.2 pole-mounted cable distribution ... type-tested assemblies (TTA) for outdoor installation in places which are exposed to the public, but where only skilled persons have access for their use They are for use in public three-phase...
56
783
6
Tài liệu DIRECTORS’ VIEWS ON ACCOUNTING AND AUDITING REQUIREMENTS FOR SMES pptx
Ngày tải lên :
18/02/2014, 01:20
... Auditing Requirements for SMEs _ Accounting and auditing requirements for SMEs Introduction 2.1 The rationale for simplifying the financial reporting requirements ... auditing requirements for SMEs When the financial reporting options for SMEs were first introduced in the UK, the thresholds were set at a lower level than the EU maxima, and the turnover threshold for ... Accounting and auditing requirements for SMEs Introduction Statutory accounts Financial Reporting Standard for Smaller Entities International Financial Reporting Standard for SMEs Statutory audit...
69
793
0
Xem thêm