drying and homogenization of solid samples
Fabrication and characterisation of solid phase crystallised plasma deposited silicon thin films on glass for photovoltaic application
... composed of silicon and hydrogen, both of which are non-toxic and present in great abundance on earth SPC poly-Si is formed from amorphous silicon (a-Si) by a standard process of deposition of a-Si ... in the material quality of the poly-Si thin film Control of the inter- and intra-grain defects in the poly-Si thin film Optimisation of the doping profiles of the n+ and p+ poly-Si layers (thereby ... representation of the interdigitated metallisation scheme of poly-Si thin-film solar cells on glass (b) Schematic xii LIST OF FIGURES cross-section of an emitter finger, the sloped sidewalls, and parts of...
- 211
- 272
- 0
Design and development of major balance of plant components in solid oxide fuel cell system
... any SOFC system, the performance of the INER SOFC system is dependent not only on the design and operating conditions of the fuel cell stack, but also on the design and operating conditions of ... provided by the anode off-gas given an anode off-gas temperature of less than 650 oC, a cathode off-gas temperature of less than 390 oC, and a flame barrier temperature of less than 700 oC However, ... SOFC BOP system (S/C=1.7, O/C=0.3, fuel utilization = 64.2%, electrical conversion efficiency = 44%) Design of SOFC BOP components The BOP components of a SOFC system account for between 50% and...
- 12
- 585
- 0
Mechanical properties of solid polymers Constitutive modelling of long and short term behaviour pptx
... study of polymers III Technique of mechanical tests of vulcanizates of rubber and plastics Rubber Chem Tech., 13, 904–917 Haward, R.N (1942) Extension and rupture of cellulose acetate and celluloid ... in the range of temperatures and strain rates of interest A linear dependence of yield stress as a function of log strain rate can be observed over a large interval of strain rates and temperatures, ... sub-Tg secondary transitions) The strength and magnitude of these transitions depends on the degree of crystallinity and the size of the lamellae, and therefore is influenced by the thermal history...
- 155
- 570
- 0
Báo cáo khoa học: Effects of sphingomyelin, cholesterol and zinc ions on the binding, insertion and aggregation of the amyloid Ab1)40 peptide in solid-supported lipid bilayers ppt
... accomplished by evaluation of the optical parameters for the lipid layer before and after binding of peptide and subsequent aggregation, and of the layer composed of peptide (or a portion of the peptide) ... Devanathan et al of b-sheet, and even smaller amounts of a-helix [41] We therefore assume that the peptide layer on the DOPC and SM membrane surface consists of such a mixture of oligomers and secondary ... bilayers composed of DOPC, of SM and of SM ⁄ cholesterol are summarized in Tables 3–5 for the binding and aggregation processes The error limits shown in these tables correspond to the standard errors...
- 14
- 532
- 0
Preparation, characterization and application of heterogeneous solid base catalyst for biodiesel production from soybean oil
... C/min, and held for 10 250 C at 25 C/ min, and held The flow rate of hydrogen was 30 ml/min and the flow rate of air was about 400 ml/min Temperatures of the injector and detector were 280 and ... weight of the internal standard, AB ¼ peak area of FAME, ftricaprylin ¼ response factor, Atricaprylin ¼ peak area of the internal standard, and ms ¼ weight of the sample Determination of sulfur ... When increasing the amount of loading catalyst, the slurry (mixture of catalyst and reactants) was become too viscous giving rise to a problem of mixing and a demand of higher power consumption...
- 9
- 679
- 0
Research for Agricultural Sciences:" Effect of high temperature fluidized drying and tempering on head rice yield and mechanical strength of Vietnamese rice varieties " doc
... A10 DryingTemp DryingTime TemperingTime DryingTemp*DryingTime DryingTemp*TemperingTime DryingTime*TemperingTime DryingTempt*DryingTime*TemperingTime OM2717 DryingTemp DryingTime TemperingTime DryingTemp*DryingTime ... factorial design, consisting of two levels of drying temperature (80 and 900C), two levels of drying time (2.5 and 3.0 min) and four levels of tempering time (0, 30, 40, and 60 min), was chosen in ... DryingTemp*DryingTime DryingTempt*TemperingTime DryingTime*TemperingTime DryingTemp*DryingTime*TemepringTime BF Fissured kernels: Drying temperature and time effect: Drying temperature, drying time and...
- 18
- 363
- 0
Báo cáo hóa học: "Preparation and Characteraction of New Magnetic Co–Al HTLc/Fe3O4 Solid Base" pptx
... a and c have been calculated from the positions of the XRD peaks [12] The lattice parameters of the samples were presented in Table The c and a values were quite similar for all the samples, and ... brucite-like sheets and of water in the interlayer space [13, 14] Waterbending vibrations of the interlayer water were observed Fig SEM (a) and TEM (b) images of magnetic Co–Al HTLcs 123 for all samples ... absorption bands at 1,470 cm-1 can be indexed to the v3 mode of CO32- ions The intensity of this band became weaker when the Fe3O4 intercalate into the HTlcs The other bands at 1,040 and 864 cm-1were...
- 5
- 244
- 0
The Project Gutenberg EBook of Solid Geometry with Problems and Applications (Revised edition) potx
... the plane of l1 and l2 Proof : Let M be the plane of l1 and l2 , and let l3 be any line in M through P Draw a line meeting l1 , l2 , and l3 in the points B, C, and D respectively Let E and F be ... CD cut the planes M and N in AC and F G respectively; and let the plane of AB and AD cut N and P in EF and BD respectively Then prove (1) F G AC and EF BD, (2) AE AF CG AF = and = , EB FD GD FD ... side of a triangle and h the altitude on it and b another side and k the altitude on it, then ah = bk 62 The area of a trapezoid is equal to one half the product of its altitude and the sum of...
- 242
- 471
- 0
Báo cáo lâm nghiệp: "Simulation of wood deformation processes in drying and other types of environmental loading*" ppt
... means that D and &jadnr; reo are lated to D and &jadnr; of Eq [10] by the relations o and where N and B are shape functions and strain shape functions for the element type used, andt and f are surface ... simulation of deformations and stresses in wood dur- ing drying is given by where &jadnr; is the rate of nodal displacement vector and K, P and Po are stiffness matrix, load vector and pseudo-load ... Santaoja (1990), Thelandersson and Morén (1990) and Santaoja et al (1991).In Eq [8], |&jadnr;|denotes the absolute value of the rate of change of the moisture content and σ is the...
- 10
- 288
- 0
Báo cáo y học: "Broad-range PCR, cloning and sequencing of the full 16S rRNA gene for detection of bacterial DNA in synovial fluid samples of Tunisian" pps
... allowing the identification of the species level Sequence analysis of the PCR-positive samples revealed the presence of a wide spectrum of bacterial DNA in SF samples of all studied patients False ... ST samples of one ReA and one UA patient [15] DNA of Shigella species was also prevalent in SF samples as demonstrated previously in ST samples [15], but it was more frequently detected in SF samples ... inflamed joints of arthritis patients, and not known to trigger ReA There is also a differential bacterial colonisation and/ or infection of SF and ST samples because the analysis of SF can identify...
- 11
- 461
- 0
Báo cáo y học: " Allele-specific copy number analysis of tumor samples with aneuploidy and tumor heterogeneity" ppt
... It handles samples with aneuploidy, presence of normal cells and facilitates detection of tumor cell heterogeneity We describe allele-specific copy number profiling of lung cancer cell lines and ... data TAPS handles samples with aneuploidy and significant normal cell content, and facilitates detection of several kinds of tumor cell heterogeneity Raw array data is first normalized and segmented ... Materials and methods) as an independent measure of the average ploidy of the tumor cells Total copy numbers and LOH, and computed and independently measured average ploidy for all 12 samples are...
- 29
- 332
- 0
ENCYCLOPEDIA OF ENVIRONMENTAL SCIENCE AND ENGINEERING - MANAGEMENT OF SOLID WASTE pot
... prohibited Dry pits, abandoned quarries and certain types of canyons of depressions are often satisfactory landfill sites The size of landfills is often restricted by the amount of land available The ... wood Manufacture of household and office furniture, partitions, office and store fixtures, and mattresses Manufacture of household and office furniture, lockers, bedsprings, and frames Paper ... the Institute for Solid Waste of the American Public Works Association and the Office of Solid Waste Management of the Environmental Protection Agency.7 The standard usage of terms detailed by...
- 26
- 434
- 0
Báo cáo y học: "Two-dose-level confirmatory study of the pharmacokinetics and tolerability of everolimus in Chinese patients with advanced solid tumors" pps
... proliferation of a wide spectrum of human solid tumors in vitro and in vivo [12-14] Pharmacokinetic (PK) studies of everolimus in patients with advanced solid tumors have shown that absorption of everolimus ... included incidence, severity, and treatment relationship of adverse and serious adverse events and the regular monitoring of hematology, serum and urine chemistry, vital signs, and physical condition ... design of the study, carried out parts of the study, wrote the manuscript, and contributed equally to this study; LS and DY carried out parts of the study and contributed to critical review of the...
- 7
- 280
- 0
báo cáo khoa học: "A solid pseudopapillary tumor of the pancreas treated with laparoscopic distal pancreatectomy and splenectomy: a case report and review of the literature" ppt
... Marinis et al.: A solid pseudopapillary tumor of the pancreas treated with laparoscopic distal pancreatectomy and splenectomy: a case report and review of the literature Journal of Medical Case ... wall, consisting of dense fibrotic tissue with hyaline degeneration, calcifications, regions of ossific metaplasia, and microscopic foci of neoplasmatic tissue, compatible with cystic -solid pseudopapillary ... pancreatectomy, in terms of wound size, length of hospital stay, time of return to the usual social activities, complication rates, intraoperative blood loss, and the rate of spleen salvage More...
- 4
- 236
- 0
MODEL AND SOLUTION OF MUNICIPAL SOLID WASTE MANAGEMENT IN THE PERI-URBAN AREAS OF HA NOI INNER-CITY THROUGH 2030
... technology of solid waste management; the research subjects of the second and the third groups is mainly related to the planning of solid waste area or solid waste landfills There has been no overall and ... management of Hanoi through 2030 Object and scope of the research 3.1 Object of the research: Municipal solid waste; Industrial solid waste and trade villages belonging to other research 3.2 Scope of ... transportation and disposal services in peri-urban areas of Hanoi inner-city - Building a model and solution of MSW management of in the peri-urban areas of Hanoi inner-city relevant to the planning of solid...
- 27
- 480
- 0
Advantages and challenges of the spray drying technology for the production of pure drug particles and drug loaded polymeric carriers
... feed, (ii) drying of spray into drying gas, (iii) formation of dry particles and (iv) separation and collection of the dry SC product from the drying gas [2-4] Figure shows a scheme of the conventional ... The spray -drying technique PT Main advantages of the spray -drying process RI Main challenges of the spray -drying process Developments of the spray -drying technology SC 4.1 Introduction of the Nano ... Advantages and challenges of the spray -drying technology for the PT production of pure drug particles and drug-loaded polymeric carriers SC RI Alejandro Sosnik1* and Katia P Seremeta2,3,4 Laboratory of...
- 70
- 488
- 0
- environmental and health impact of solid waste management activities pdf
- identification quantification and comparison of heroin samples
- identification quantification and comparison of khat samples
- advantages and drawbacks of solid oxide fuel cells
- fixation dehydration and infiltration of bone samples
- reduction alkylation and digestion of protein samples
- breaking and mastication of solid foods
- collection storage and processing of saliva samples for downstream molecular applications
- collection handling and storage of biological samples
- retention and storage of blood samples
- sample preparation and analysis of solid bound pharmaceuticals
- challenges generation collection storage and transportation of solid waste in ghana
- 4mechanisms of interaction between xenobiotics and components of solid matrices
- collection and preparation of soil samples
- 3 equivalent depth of wave penetration and impedance of solid conductors
Tìm thêm: hệ việt nam nhật bản và sức hấp dẫn của tiếng nhật tại việt nam xác định các nguyên tắc biên soạn khảo sát các chuẩn giảng dạy tiếng nhật từ góc độ lí thuyết và thực tiễn khảo sát chương trình đào tạo gắn với các giáo trình cụ thể xác định thời lượng học về mặt lí thuyết và thực tế tiến hành xây dựng chương trình đào tạo dành cho đối tượng không chuyên ngữ tại việt nam điều tra đối với đối tượng giảng viên và đối tượng quản lí khảo sát thực tế giảng dạy tiếng nhật không chuyên ngữ tại việt nam khảo sát các chương trình đào tạo theo những bộ giáo trình tiêu biểu nội dung cụ thể cho từng kĩ năng ở từng cấp độ mở máy động cơ rôto dây quấn các đặc tính của động cơ điện không đồng bộ hệ số công suất cosp fi p2 đặc tuyến hiệu suất h fi p2 đặc tuyến tốc độ rôto n fi p2 đặc tuyến dòng điện stato i1 fi p2 sự cần thiết phải đầu tư xây dựng nhà máy thông tin liên lạc và các dịch vụ phần 3 giới thiệu nguyên liệu từ bảng 3 1 ta thấy ngoài hai thành phần chủ yếu và chiếm tỷ lệ cao nhất là tinh bột và cacbonhydrat trong hạt gạo tẻ còn chứa đường cellulose hemicellulose