... decreased the absolute number of WT1/MHC tetramer+CD8+ cells and the decrease was maintained for two to three weeks. On the other hand, in MLPC cells without the addition of WT1 peptides, the ... anti-tumor immunotherapy as in this case. These data suggested the possible usefulness of treatment for suppressing the function of regulatory T cells in combination with anti-tumor immunotherapy in-cluding ... combination withthe same amount of imatinib, the tendency of increase of bcr-abl transcripts was abrogated and the patient showed a slight decrease of bcr-abl transcripts after the 4th administration...
... strive to learn from these theories and use them in a constructive way. Thus, the sum of the parts may be greater, and more practically helpful, than the whole.Each of the " ;four skills" ... on the development of the group's proficiency in reading skills. Treating theFour Language Skills Separately from One AnotherThere is a growing realisation among EFL teachers that the ... Reading Theory as a Microcosm of the Four Skills Ciarán P. McCarthyIntroductionIn the first section of this paper we shall look at how helpful it is to treat, at a theoretical level, the four...
... The device element cards in Spice then reference the modelname.Each device element card contains the device name, the nodes to which the device isconnected to, and the device model name. The ... element in the circuit is specified by an element line that contains the elementname, the circuit nodes to which the element is connected, and the values of the parameters that determine the electrical ... and where node 0 is the ground or reference node.A control line within the input deck is specified by a line containing a (.) in the firstcolumn, followed by the name of the control and its...
... in the design, accuracy in the representationof the design is crucial as the complexity of the development, as well as the diver-sity in the tools, becomes greater. The sequential nature of the ... by the OVI Verilog-A Technical Subcommittee.These design objectives of the Verilog-A language were considered in the context ofmeeting the goals of the use model of the language, including: The ... of the Verilog-A language as presented in the LRM and the work within the OVI Verilog-A Technical Subcommittee. The goal of this book is to provide the designer a brief introduction into the...
... satisfied:whereis the iteration of the solution for x. The reltol within the conver-gence criteria, is a global option of the simulation. The and are associ-ated withthe type, or nature of the unknown ... the module. Because of mathematical and other properties associated with analog opera-tors, there are special considerations in their usage. These and other issues associated with the use of analog ... creates the instance named mod. The mod instanceis passed the value fc as the value for the parameter carrier_freq to the instance. The instance is connected to signals cin, din and clk within the...
... complete the transition in the specified time.If the new final value level is below the value level at the point of the interruption (the current value), transition uses the old destination as the ... used to define the relationships between the input and output signalsof the module. Statements within the Verilog-A language allows these contributionstatements used in defining the analog behaviors ... Statements The contribution statements within the analog block of a module form the basis of the behavioral descriptions used to compute flow and potential values for the signalscomprising the analog...
... from the type of the value of the default value expression. If the type of the parameter is specified, and the value of the default expression conflicts with the declared type of the parameter, the ... association is the other way to assign values to parameters. The order inwhich parameters are passed in the declaration or instantiation statement (within the “#( )”), correspond to the order in the definition ... Y, the ports of module Y are associated with either the ports or the internal signals of module X. Associating connections between modulesrequires that both the type and the direction of the...
... crossings of the output of the module when they are within +/- 5% of the final state value. The times of the cross-ings are recorded, the settling time being the difference between the latest ... Regulator The result of the measurement is printed to the standard output using the $strobesystem task. The results of the measurement simulation are shown in Figure 5.14. The results for the simulation ... the Spice model. The other values for the structural RC network were selected byfirst setting resistor R1 to 4000 ohms, calculating the capacitance C1 at and thenadjusting the value until the...
... modulation technique inwhich the information carried within the signal is contained in the phase. The phaseof the signal can take on one of four values, such as shown in the constellation dia-gram ... friction, The back voltage generated by the motor istimes the angular frequency of the motor, , and the torque is times the currentthrough the motor, This is shown diagrammatically in Figure 5.30. The ... that the gears do not slip, then equating translational distance for the two gears in terms of their angular position yields: The relationship between the torque on the two shafts is related by the...
... pole where the firstnumber in the pair is the real part of the zero, and the second is the imaginary part. The transfer function is:where is the coefficient of the power of s in the numerator, ... contains the coefficients of the numerator.For the denominator, is the vector of N real pairs, one for each pole where the firstnumber in the pair is the real part of the zero, and the second is the ... represents a zero, the firstnumber in the pair is the real part of the zero, and the second is the imaginary part.Similarly, d is the vector of N real coefficients of the denominator. The transfer...
... The device element cards in Spice then reference the modelname.Each device element card contains the device name, the nodes to which the device isconnected to, and the device model name. The ... for Spice. The first card in the input deck must be atitle card, and the last card must be the .END control line. The order of the remainingelement and control lines is arbitrary. The input ... element in the circuit is specified by an element line that contains the elementname, the circuit nodes to which the element is connected, and the values of the parameters that determine the electrical...
... present for the last four residues at the C-terminus. The stereochemistry of the model hasbeen assessed using the program procheck [23]. Ninetyper cent of the residues fall in the most favouredregions ... 3A,B). The ligand binds in an extended conformation, with itsphosphate moiety located in the proximity of the zincion and withthe hydroxymethylene group pointingtoward Pro295. DHAP interacts with ... dotted lines, together withthe hydrogen bonds established byDHAP withthe metal-coordinating solvent molecule w1. The por-tion of the 2Fo)Fcelectron density map covering the DHAP mole-cule...
... annually, together withthe anesthesia workforce allocated for the provision of obstetric anesthesia services. The OAAI was calculated based on the premise that epidurals and cesareans are the predominant ... deliveries (Figure 3). There was no clear relationship between the anesthesia workforce allocation to the labor ward and the obstetric anesthesia workload as measured by the OAAI (Figure 4). ... that associated with regional anesthesia [7]. Therefore, the finding in our earlier study that there was an inverse relationship between the epidural rate for labor analgesia and the choice of...
... connected withthe cat-alytic function. One explanation lies in the fact that the loop protrudes from the surface of the moleculeand does not form any additional contacts with the molecule. The Glu-A ... formedbetween the enzyme and Tris are the same as observedpreviously [16].In the Glu-A complex there are two acarbose mole-cules: one in the active site and the other on the sur-face of the enzyme ... domain.Mutations at the remote ligand binding siteTo verify the hypothesis that the site on the Glu sur-face interacting with acarbose represents the starchbinding site, the point mutants R15A,...
... interpretations: (37) The man withthe telescope and the woman with the umbrella kicked the ball. (38) Slowly and stealthily, he crept towards his victim. III THE ALGORITHM The following algorithm, ... (12) and (13) on one hand, and (14) on the other: (12) Bob met Sue and Mar k in London. (13) I knew the man withthe telescope and the woman withthe umbrella. (14) Bob met Sue in Paris ... to do is to parse the right conjunct first, then copy the object over to the left conjunct so that a representation for the left clause can be constructed. Then we combine the two to get a...