— general design requirements for masonry pg c 7

... nonspeci c siRNA-induced effects are mediated by more recently characterized receptors located in distinct subcellular compartments The nucleic acidresponsive Toll-like receptors (TLRs) interact ... ligand for RIG-I Science 314, 994–9 97 Walton SP, Wu M, Gredell JA & Chan C (2010) Designing highly active siRNAs for therapeutic applications FEBS J 277 , 4806–4813 Diebold SS, Massacrier C, Akira ... the mechanism by which recognition of siRNA occurs is also unclear For example, some evidence suggests that siRNA-mediated activation of TLR3 occurs at the cell surface [5,6], yet it is not clear...

Ngày tải lên: 06/03/2014, 01:23

... C- 2 MANUAL OF CONCRETE PRACTICE CHAPTER — GENERAL DESIGN REQUIREMENTS FOR MASONRY, pg C- 7 1.1 — Scope C- 7 1.1.1 Minimum requirements C- 7 1.1.2 Governing ... C- 50 7. 7 — Reinforcement C- 50 TRANSLATION OF INCH-POUND UNITS TO SI UNITS, pg C- 51 C- 5 C- 6 MANUAL OF CONCRETE PRACTICE BUILDING CODE REQUIREMENTS FOR MASONRY STRUCTURES C- 7 ... grouted corrugated ducts, anchored in accordance with Section 4.9.1, does not need to be calculated C- 40 MANUAL OF CONCRETE PRACTICE CHAPTER EMPIRICAL DESIGN OF MASONRY 5.1 — General 5.1.1 Scope...

Ngày tải lên: 24/10/2014, 17:25

... CC-2 MANUAL OF CONCRETE PRACTICE INTRODUCTION, Pg CC-5 CHAPTER — GENERAL DESIGN REQUIREMENTS FOR MASONRY, pg CC-6 1.1 — Scope CC-6 1.1.3 Design procedures ... detailed research CC-6 MANUAL OF CONCRETE PRACTICE CHAPTER GENERAL DESIGN REQUIREMENTS FOR MASONRY 1.1 — Scope This Code covers the structural design and construction of masonry elements and ... and accessories CC-55 4.11 — Development of bonded tendons CC-55 References CC-55 CC-4 MANUAL OF CONCRETE PRACTICE CHAPTER — EMPIRICAL DESIGN...

Ngày tải lên: 24/10/2014, 17:25

... enumerated in this specification in accordance with the following methods: 11.1.1 Chemical Analysis— Test Methods C 25 11.1.2 Physical Tests—Test Methods C 110 12 Special Package Marking 12.1 When ... from the dry hydrate Chemical Composition 6.1 Hydrated lime for masonry purposes shall conform to the following requirements as to chemical composition: Hydrate Types: N Calcium and magnesium oxides ... 95 95 95 95 5 5 7 7 ··· ··· 8 10 Sampling and Inspection 10.1 The sampling, inspection, rejection, retesting, packing, and marking shall be conducted in accordance with Methods C 50 Residue, Popping,...

Ngày tải lên: 10/07/2014, 23:20

... as the basis for their accreditation Clause specifies the requirements for sound management Clause specifies the requirements for technical competence for the type of tests and/or calibrations ... systems — Requirements for measurement processes and measuring equipment [10] ISO/IEC 170 11, Conformity assessment — General requirements for accreditation bodies accrediting conformity assessment ... any work commences Each contract shall be acceptable both to the laboratory and the customer NOTE The request, tender and contract review should be conducted in a practical and efficient manner,...

Ngày tải lên: 07/06/2016, 22:03

... 1016/A 1016M – 04 A 77 1/A 77 1M Specification for Seamless Austenitic and Martensitic Stainless Steel Tubing for Liquid MetalCooled Reactor Core Components A 78 9/A 78 9M Specification for Seamless and ... Practice for Commercial Packaging E 92 Test Method for Vickers Hardness of Metallic Materials E 213 Practice for Ultrasonic Examination of Metal Pipe and Tubing E 273 Practice for Ultrasonic Examination ... be replaced with acceptable items prior to lot acceptance 33.1.5 Sampling for Chemical Analysis—One sample for chemical analysis shall be selected from each of two tubes chosen from each lot A...

Ngày tải lên: 08/09/2016, 00:30

... Standards: SNT-TC-1A Recommended Practice for Personnel Qualification and Certification in Nondestructive Testing12 Chemical Composition 5.1 Chemical Analysis—Samples for chemical analysis and ... Nondestructive Electric Test: 21.3.1 Each pipe shall be examined with a nondestructive test in accordance with Practices E 213, E 309, E 426, or E 570 Unless specifically called out by the purchaser, ... purchase order, packaging, marking, and loading for shipment shall be in accordance with the procedures of Practices A 70 0 27 Government Procurement 27. 1 When specified in the contract or order, the...

Ngày tải lên: 08/09/2016, 00:50

... thuận timescale 5 .C c yêu c u kĩ thuật Technical requirements 5.1.Yêu c u chung 5.1 General 5.1.1 C nhiều yếu tố định m c độ x c độ tin c y phép thử và/ho c hiệu chuẩn PTN th c C c yếu tố bao ... tiêu chuẩn nh-là sở cho vi c công nhận for their accreditation Clause specifies the Điều qui định yêu c u c n c cho vi c quản lý requirements for sound management Clause tốt Điều qui định yêu c u ... chuẩn chuẩn C c chuẩn phải procedure for the calibration of its reference hiệu chuẩn tổ ch c cung c p standards Reference standards shall be calibrated vi c liên kết chuẩn miêu tả by a body that can...

Ngày tải lên: 02/04/2017, 07:47

... Design Code (2-1)Perform Design : Design > RC Strong-Column Weak-Beam Design > Ductile Design/ Ductile Checking Design > Concrete Code Design > Beam Design / Column Design / Wall Design systems, with ... shear forces calculated at the positions (I,1/4,1/2,3/4 & J) of each member in accordance with the load combinations for concrete design Detailed calculation can be checked in the graphic report ... specified ductility classes (DCM and DCH for Eurocode8, CD “B” and CD “A” for NTC2008) 45 /64 Gen 2010 Enhancements in design part Gen 2010 (v1.1) Release Note Beam and Column Design forces for...

Ngày tải lên: 09/08/2017, 11:17

... purchase decisions Consumer characteristics include demographic and life-style factors Consumer needs relate to a firm’s store location, goods/service assortment, prices and so on Purchase decisions ... (N = 176 ) Characteristics % self-service 94.9 fixed prices 83.5 having electronic checkout 58.0 nice and convenience goods layouts 39.8 having cold storage 34.1 having air conditioner 27. 3 On question ... product display Forty percent of all respondents claimed that the goods are arranged nicely and allowed easy choice The physical facilities in stores such as check out, cold storage and air-conditioning...

Ngày tải lên: 13/04/2013, 10:30

... 7. 0—Notation 7. 1—Standard hooks 7. 2—Minimum bend diameters 7. 3—Bending 7. 4—Surface conditions of reinforcement 7. 5—Placing reinforcement 7. 6—Spacing limits for reinforcement 7. 7—Concrete protection for ... for reinforcement 7. 8—Special reinforcement details for columns 7. 9—Connections 7. 10—Lateral reinforcement for compression members 7. 11—Lateral reinforcement for flexural members 7. 12—Shrinkage ... Steel Bar for Prestressing Concrete A 76 7- 97 Standard Specification for Zinc-Coated (Galvanized) Steel Bars for Concrete Reinforcement A 77 5- 97 Standard Specification for Epoxy-Coated Reinforcing...

Ngày tải lên: 03/08/2013, 11:24

... selection of lubricator capacity: Littleton, CO USA Phone 303 -79 4-2611 www.norgren.com 15 Design Manual for Machine Lubrication How to Design for Micro-Fog Lubrication Reclassifier Table Reclassifier ... = inches face width, 13 inches pitch diameter Driven gear = inches face width, 36 inches pitch diameter P2 = 36 = 2 .77 13 P1 (2 .77 x 13) = 18 Recommended: 20 bearing-inch reclassifier Therefore ... www.norgren.com 13 Design Manual for Machine Lubrication If the chain is completely enclosed, only 1/2 of the bearing inch rating as calculated need be used For each sprocket beyond two, the total reclassifier...

Ngày tải lên: 09/08/2013, 15:00

... Walls / 6 .77 References / 6.86 Chapter Shear Walls 7. 1 7. 2 7. 3 7. 4 7. 5 7. 6 7. 7 7. 8 7. 9 7. 10 7. 11 7. 12 7. 13 7. 1 Introduction / 7. 1 Fundamental Concepts / 7. 2 Types of Shear Walls / 7. 6 Rigidity ... Reinforced Masonry Columns / 5 .7 5.4 MSJC Code Provisions for Reinforced Masonry Columns / 5.10 5.5 Analysis of Reinforced Masonry Columns / 5.16 5.6 Design Procedure for Reinforced Masonry Columns ... Building Officials and Code Administrators International Council of American Building Officials Concrete Masonry Association of California and Nevada Column Research Council Concrete Reinforcing Steel...

Ngày tải lên: 17/08/2013, 11:41

... rigorous format, but they are in keeping with the spirit of design patterns because they factor in industry-accepted practices for approaching recurring design problems 33 70 1xCH03.qxd 34 7/ 17/ 06 ... services architecture showing communication between the client and service Consider the example Web service, StockTrader, from Chapter that provides methods for retrieving stock quotes and placing ... be designed in conjunction with XSD schema files The best starting point is to 37 701xCH03.qxd 38 7/ 17/ 06 12:54 PM Page 38 CHAPTER ■ DESIGN PATTERNS FOR BUILDING MESSAGE-ORIENTED WEB SERVICES construct...

Ngày tải lên: 05/10/2013, 08:48

... business components can implement custom security checks through mechanisms such as code access security (CAS) and Active Directory checks, but these options are not comparable to the available mechanisms ... StockTraderConsole2 client = new StockTraderConsole2(); client.Run(); } 73 70 1xCH04.qxd 74 7/ 17/ 06 1:05 PM Page 74 CHAPTER ■ DESIGN PATTERNS FOR BUILDING SERVICE-ORIENTED WEB SERVICES public void ... handles processing for the client 77 70 1xCH04.qxd 78 7/ 17/ 06 1:05 PM Page 78 CHAPTER ■ DESIGN PATTERNS FOR BUILDING SERVICE-ORIENTED WEB SERVICES StockTraderServiceAgent: The service agent used...

Ngày tải lên: 05/10/2013, 08:48

... MSMQ for Reliable Messaging Consider the following application design for a StockTrader application for mutual fund trades, which cannot be executed until after the stock exchange closes for the ... [System.Xml.Serialization.XmlTypeAttribute(Namespace= "http://www.bluestonepartners.com/schemas/StockTrader/")] public class AcknowledgeMessage { public bool AcceptedToQueue; } The sample project does not include code for processing ... also contains dynamic reference information (such as AccountID) that is specific to the endpoint reference Listing 9-3 Endpoint Reference XML soap.tcp://stocktrader.com/StockTrader...

Ngày tải lên: 05/10/2013, 08:51

... Communications Devices, USB Device Class Definition for Audio Devices, and USB Specification.) Current USB bus driver code must contain blocks of special-case code for two classspecific exceptions to ... USB Communications class specification requires two interacting interfaces to perform the single function of "legacy modem." The USB bus driver must contain code that uses Communications class-specific ... driver for each function it discovers • Gives each function a unique structure or handle (provides an abstraction that allows the loaded driver to access its function) For a device, or function,...

Ngày tải lên: 07/10/2013, 00:20

... Fracture Control in Structures—Applications of Fracture Mechanics Prentice-Hall, Englewood Cliffs, N.J., 1 977 2.9 2.10 2.11 American Institute of Steel Construction, Specification for the Design, ... to a complete or partial collapse of the connection If performance is the controlling factor, the connection may lose its serviceability before its load capacity is reached because of excessive ... until 19 47 when the Research Council on Riveted and Bolted Structural Joints (RCRBSJ) was formed The purpose of the council, known now as the Research Council on Structural Connections (RCSC), was...

Ngày tải lên: 24/10/2013, 04:15

... Security Services specification is incredibly rich and comprehensive It defines a security reference model that provides an overall framework for CORBA security and encompasses all of the concepts ... modes or access control lists CORBA security does, however, extend the common security mechanisms to include the concept of delegation As described earlier, delegation is a security concept that ... directly subject to attack, and perform authentication and encryption services The CORBA V3 specification will include the addition of a firewall specification for transport-level, application-level,...

Ngày tải lên: 24/10/2013, 07:20

... Nottingham Medical School, referred to “balance of scienti c and clinical excellence, humanitarian and compassionate concern … balance of service and learning, balance of current competence and future ... qualifications Chemistry, Biology and one other Pre-Medical science subject recommended course available (cont.) Acceptable only when combined with other qualifications General Studies excluded Acceptable combined ... entry (cont.) Pre-Medical course available UKCAT compulsory UKCAT compulsory Pre-Medical course available UKCAT compulsory UKCAT compulsory Pre-Medical course available UKCAT compulsory Graduate...

Ngày tải lên: 01/11/2013, 09:20